When a microwave filter consisting of vertical parallel metal rods is in the absorbing position, oscillating currents are set up in the rods. At any one instant, the current in each rod has the same magnitude and direction. At that instant Select one: a. the rods will try to move apart horizontally. b. the rods will not be affected because the source of current is not a battery. c. the rods will try to shift vertically upwards. d. the rods will try to shift vertically downwards. e, the rods will try to move toward each other horizontally.

When a microwave filter consisting of vertical parallel metal rods is in the absorbing position, oscillating currents are set up in the rods. At any one instant, the current in each rod has the same magnitude and direction. At that instant Select one: a. the rods will try to move apart horizontally. b. the rods will not be affected because the source of current is not a battery. c. the rods will try to shift vertically upwards. d. the rods will try to shift vertically downwards. e, the rods will try to move toward each other horizontally.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.3OQ: A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure...

See similar textbooks

Similar questions

(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
Integrated Concepts A 200-turn flat coil of wire 30.0 cm in diameter acts as an antenna for FM radio at a frequency of 100 MHz. The magnetic field of the incoming electromagnetic wave is perpendicular to the coil and has a maximum strength of 1.001012T. (a) What power is incident on the coil? (b) What average emf is induced in the coil over one-fourth at a cycle? (c) If the radio receiver has an inductance at 2.50 (H, what capacitance must it have to resonate at 100 MHz?
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
A loop of wire is moving near a long, straight wire carrying a constant current I as shown in Figure CQ31.10. (a) Determine the direction of the induced current in the loop as it moves away from the wire. (b) What would be the direction of the induced current in the loop if it were moving toward the wire?
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
A conducting sheet lies in a plane perpendicular to a magnetic field B that is below the sheet. If B oscillates at a high frequency and the conductor is made of a material of low resistivity, the region above the sheet is effectively shielded from B . Explain why. Will the conductor shield this region from static magnetic fields?
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A particle of cosmic dust has a density =2.0g/cm3 , (a) Assuming the dust particles are spherical and light absorbing, and are at the same distance as Earth from the Sun, determine the particle size for which radiation pressure from sunlight is equal to the Sun's force of gravity on the dust particle, (b) Explain how the forces compare if the particle radius is smaller, (c) Explain what this implies about the sizes of dust particle likely to be present in the inner solar system compared with outside the Oort cloud.