When a only capacitor is connected to AC source of 200 rms voltage the current in the circuit is 3 ampere The average power dissipated in the circuit is O a. 600 ohm O b.66.67 ohm O .0.015 ohm O d. Zero

When a only capacitor is connected to AC source of 200 rms voltage the current in the circuit is 3 ampere The average power dissipated in the circuit is O a. 600 ohm O b.66.67 ohm O .0.015 ohm O d. Zero

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 33PQ

See similar textbooks

Similar questions

An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
A power plant generator produces 100 A at 15 kV (rms). A transformer is used to step up the transmission line voltage to 150 kV (rms). (a) What is rms current in the transmission line? (b) If the resistance per unit length of the line is 8.6108/m , what is the power loss per meter in the line? (c) What would the power loss per meter be If the line voltage were 15 kV (rms)?
Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from 220-V (rms) ac to 12-kV (rms) ac. What must the ratio be of turns in the secondary winding to the turns in the primary winding? (b) What is the maximum rms current the neon lamps can draw if the fuse in the primary winding goes off at 0.5 A? (C) How much power is used by the neon sign when it is drawing the maximum current allowed by the fuse in the primary winding?
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
An RLC series circuit consists of a 10 resistor, an 8.0F capacitor, and a 50-mH inductor. A 110-V (rms) source of variable frequency is connected across the combination. What is the power output of the source when its frequency is set to one-half the resonant frequency of the circuit?
The emf of an ac source is given by v(t)=v0sint. where V0=100V and at =200rad/s . Calculate the average power output of the source if it is connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
The following statements are related to an RLC circuit connected across an AC power source. Choose the words that make each statement true. (i) The voltage across the [(a) capacitor; (b) inductor] leads the current by 90. (ii) The voltage across the [(c) capacitor; (d) resistor] is in phase with the current. (iii) At resonance, the phase angle between the current and the voltage [(e) is 0; (f) depends on frequency f]. (iv) The maximum and rms voltages from the power source are related by [(g) Vmax = 2 Vrms,; (h) Vmax = Vrms/2].
The power rating of a resistor used in ac circuits refers to the maximum average power dissipated in the resistor. How does this compare with the maximum instantaneous power dissipated in the resistor?
A capacitor and a resistor are connected in series across an AC source as shown in Figure OQ33.3. After the switch is closed, which of the following statements is true? (a) The voltage across the capacitor lags the current by 90. (b) The voltage across (lie resistor is out of phase with the current. (c) The voltage across the capacitor leads the current by 90. (d) The current decreases as the frequency of the source is increased, but its peak voltage remains the same. (e) None of those statements is correct.
An AC source operating at 60. Hz with a maximum voltage of 170 V is connected in series with a resistor (R = 1.2 k) and a capacitor (C = 2.5 F). (a) What is the maximum value of the current in the circuit? (b) What are the maximum values of the potential difference across the resistor and the capacitor? (c) When the current is zero, what are the magnitudes of the potential difference across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant? (d) When the current is at a maximum, what are the magnitudes of the potential differences across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant?
An AC source operating at 60. Hz with a maximum voltage of 170 V is connected in series with a resistor (R = 1.2 k) and a capacitor (C = 2.5 F). (a) What is the maximum value of the current in the circuit? (b) What are the maximum values of the potential difference across the resistor and the capacitor? (c) When the current is zero, what are the magnitudes of the potential difference across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant? (d) When the current is at a maximum, what are the magnitudes of the potential differences across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant?