Whenever closed conduits are used in a hydroelectric power plant, is/are used to limit the abnormal pressure in the conduit.

Q: What does it mean when a switch is "congested

A: Introduction - Congestion in a network is defined as a decrease in quality of service (QOS) that…

Q: In Lock-Out Tag-Out which energy sources must be removed from the system?

A: LOCKOUT/TAGOUT (LOTO); Lock out, tag out (LOTO) is a safety practise that ensures that dangerous…

Q: 12. What is the primary entity that needs to be consulted with in regards to the location of the…

A: According to the electric code, The meter and the service box should be placed outdoor which can be…

Q: essential electrical system in health care facilities

A: Circuit classified essential electrical system in health care facilities is shown in below

Q: A switch that i s located inside a bedroom for an outdoor light does not require AFCI protection…

A: As per the NEC code, "outlet" is defined as the device from where electrical supply is taken for…

Q: Write a verilog and testbench for up down counter

A: Write a verilog and testbench for up down counter' Here we use High for Up Counter and Low for Down…

Q: 1. F. -- plan of room or floor of building drawn to scale. - shows the meaning of every symbol…

A: As per the guidelines, we supposed to answer the first three-part of the question at a time so…

Q: Does the NEC make suggestions about how to wire a house that will be occupied by handicapped…

A: The NEC is the electrical code that is accepted by everyone belongs to the electrical industry. NEC…

Q: 8. What is the purpose of a lockout-tagout procedure? 9. List protective equipment.     10. When…

A: (8) Purpose of a Lockout - tagout procedure - This procedure is used to protect the employee from…

Q: What is the purpose of the NEC®?

A: NEC stands for National Electrical Code. It was developed in 1897.

Q: What is the purpose of circular boxes in the layout conduit

A: There are different types of accessories that are connected with PVC conduit. Those are coupler and…

Q: What authority enforces the compliance set by NEC

A: The National Electrical Code or the NEC provides a set of standards which must be followed during…

Q: 2. When working on a high - voltage system , it is best to keep anyone who is not part of the ser…

A:

Q: what wire size is needed on a one 20 amp, 120-volt bathroom circuit? what wire size is needed on a…

A: Proper wire size is an important fact to be considered in any of the electrical wiring installation.…

Q: A cable has a VSWR of 10. If the minimum voltage along the cable is 20 volts, what is the maximum…

A:

Q: Does compliance with the NEC always result in an electrical installation that is adequate, safe, and…

A: NEC stand for National electrical code which is basic standard code and it sets the standards for…

Q: With neat diagram explain the working of motor used in elevators.

A: The motor used for the elevator is a Cumulative compound DC motor, as during the starting high…

Q: write paragraph about how to concat and installation fluorescent lamp with Electric Choke and Tube…

A: We have given the following problem write paragraph about how to connect and installation…

Q: Explain the procedure to handle the "cast resign

A: In these units, coils are enveloped in resign by process of moulding. The transformer coils are…

Q: need the answer as soon as possible please Define TWO categories (with two sub-categories each)…

A:

Q: What is the largest voltage drop in the wires that is allowed by the code?

A: As per the NEC keeping in mind about the performance issue. The NEC recommends the largest voltage…

Q: 15. What does a grounding symbol on a construction drawing convey? A. A single ground rod B. A…

A: Choose the correct option What does a grounding symbol on a construction drawing convey?

Q: What is the NEC code for a receptacle by a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: What are the differences between a hard handover and a soft handover? Among the 2G, 2.5G, and 3G…

A: Handover is the process of switching from one cell to another cell.   When the connection breaks…

Q: For the following circuit, write a code on TinkerCAD to turn on the LED light when the push-button…

A: Given the circuit, as shown below: For the following circuit, we need to write a code on TinkerCAD…

Q: How can you calculate the maximum short-circuit current that can pass when the A-B ends of an outlet…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Consider the following sequential circuit. Determine its state table and state diagram. A Cp

A: Given the sequential circuit as shown below: We need to determine the state table and state…

Q: 16. What devices are used to protect a circuit from overloads?

A: 16)  to protect a circuit from overloads

Q: Describe a situation where you would need to use a combination single-pole/three-way switch.

A: In the installation of Dimmer switches we generally use the combination of single pole and three way…

Q: What is the NEC code for receptacle near a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: The Code places a maximum open-circuit voltage on lighting equipment in or on homes. This maximum…

A: The maximum open circuit voltage on lighting equipment in homes are 1000 V.

Q: 14. Severe burns, lung damage, eye damage, and hearing loss are all effects of what event? 8 am…

A: In this question we need to choose a correct option

Q: Which of the following is not a control system? Select the correct answer below: A. Home PC B.…

A: Control system- A control system is basically the interconnection or arrangement of various devices…

Q: 20.a. What's the maximum number of switches or circuit breakers the service-disconnecting means may…

A:

Q: What is the purpose of the NEC?

A:

Q: Appliances consuming high amount of power and powered by mechanical energy like Air con must be…

A: People are protected by ground fault circuit interrupters (GFCIs) in situations where they are prone…

Q: True or False: The term "lockout tagout" refers specifically to procedures used to ensure that…

A: In power Generating stations, the equipment should run continuously everyday with out any rest. So…

Q: Which method is BEST practice to prevent unknowing individuals from energizing an electrical circuit…

A: The electrical power is transferred from the generation side to the consumer end. The power which is…

Q: - List main features of Embedded System. Please explain the question step by step and please care to…

A:

Q: Select the most accurate system from the following, a. Air conditioner O b. Traffic light c. Room…

A: Digital systems are more accurate and precise than anolog system because they can be easily expanded…

Q: The NEC is the only code reference used for electrical installations of all types of occupancies…

A:

Q: When conduits pass through the wall from outside to inside, the conduit must be ________ to prevent…

A: The NEC is the standard electrical code that is developed by National Electrical Code Committee. The…

Flow Detection Sensor

A flow detection sensor which is also called a flow meter is an electronic device that measures the flow rate of liquids and gasses. Flow detection sensors can detect leaks, blockage, pipe bursts, and changes in liquid concentration which is occurred due to pollution.