Example 18.9: A two hinged parabolic arch has a span 30 m and a rise of 7.5 m. The M.I. of arch section is proportional to sec 0, where 0 is the slope of the arch axis at any pont with the horizontal. Calculate the horizontal thrust caused in the arch due to rise of temperature 25°F. The value of E = 2 x 10 kN/m2 and hte co-efficient of expansion 10 m. 6 x 10-6 per degree F The M.I. at crown is 1.25 x

Example 18.9: A two hinged parabolic arch has a span 30 m and a rise of 7.5 m. The M.I. of arch section is proportional to sec 0, where 0 is the slope of the arch axis at any pont with the horizontal. Calculate the horizontal thrust caused in the arch due to rise of temperature 25°F. The value of E = 2 x 10 kN/m2 and hte co-efficient of expansion 10 m. 6 x 10-6 per degree F The M.I. at crown is 1.25 x

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The water in a 25-m-deep reservoir is kept inside by a 150-m-wide wall whose cross section is an equilateral triangle. Determine (a) the total force (hydrostatic + atmospheric) acting on the inner surface of the wall and its line of action and (b) the magnitude of the horizontal component of this force. Take Patm = 100 kPa.
A horizontal bend in a pipeline conveying 1m^3/s of water gradually reduces from 600mm to 300mm in diameter and deflects the flow through an angle of 60 degrees. At the larger end, the pressure is 170kN/m^2. Determine the magnitude of the force exerted on the bend.
An open horizontal tank 3 m high, 3.6 m wide and 5.1 m long is initially filled at 2 m of water. A. Determine the required acceleration in m/s2 so that no water will be spilled? B. Determine the required acceleration in m/s2 so that 1/3 of the initial volume of water will be spilled C. Determine the remaining volume in cu.m if it accelerated at 7 m/s^2D. Determine the minimum hydrostatic force in kN at the side of the tank if 2/3 of the initial volume will be spilled E. Determine the maximum hydrostatic force in kN at the side of the tank if it accelerates at 3 m/s^2
The pressure distribution over the base of a concrete (S =2.4) dam varies linearly, as shown in figure ,producing an uplift. Will the dam topple over (sum moments of all forces about the bottom, right-handcorner)? Use:(a) H =45 m(b) H = 60 m(c) H = 75 m
an oil tanker 3 m wide, 2 m deep and 10 m long contains oil of density 800 kg/m^3. if the tanker is closed and completely filled with the oil and accelerated horizontally at 3 m/s^2, determine the total liquid thrust (hydrostatic force) on the front end and rear end Find the Front and rear end The unit of the final answer is kN
A 3-cm-diameter horizontal pipe attached to a surface makes a 90° turn to a vertical upward direction before the water is discharged at a velocity of 6 m/s. The horizontal section is 5 m long and the vertical section is 4 m long. Neglecting the mass of the pipe and considering the weight of the water contained in the pipe, the bending moment acting on the base of the pipe on the wall is (a) 11.9 N·m (b) 46.7 N·m (c) 127 N·m (d) 104 N·m (e) 74.8 N·m
An open tank 3m by 3m in horizontal section weighs 4 kN and contains water to a depth of 1m. It is acted by an unbalanced force of 18 kN parallel to the pair of sides. a) Determine the acceleration of the tank. b) What must be the height of the tank so that no water will spill out? c) If the acceleration is increase by 4m/s2 , how much water will spill out?
A dam with specific weight of 24 kN/m3, has dimensions of 6m on top, 20m at the bottom and 27m high has water 22m deep acting on its vertical side. Compute the location of the vertical resultant force from the toe. CHOICES: a.) 8.01 b.) 18.10 c.) 1.80 d.) 10.81
Calculate the resultant of the hydrostatic forces on the gate in Figure 4a. What vertical force P is necessary to lift the gate at point A? Width of the gate is 1.60 m.
Determine the magnitude of the resultant hydrostatic force acting per foot of length on the seawall; ρw = 62.4 lb/ft3.
A vertical plate is an equilateral triangle whose edge is 3.5 m long. If one edge is level with the water surface, determine the total pressure force in kN acting on the plate. subject: Hy
A rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is accelerated horizontally at 2.5 m/s2 in the direction of its length. A. Determine the net force due to water acting on each end of tank. B. Determine the minumum pressure intensities at bottom C. Determine the slope of the free surface