Which of the following are true about the modulus of a spring? Select all that apply. It represents the force required to produce unit extension. It represents the force required to produce unit extension per unit natural length. Its SI unit is N. Its SI unit is N/m. It is the elongation of a spring per newton.

Which of the following are true about the modulus of a spring? Select all that apply. It represents the force required to produce unit extension. It represents the force required to produce unit extension per unit natural length. Its SI unit is N. Its SI unit is N/m. It is the elongation of a spring per newton.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter5: Further Applications Of Newton's Laws: Friction, Drag, And Elasticity

Section: Chapter Questions

Problem 38PE: A disk between vertebrae in the spine is subjected to a shearing force of 600 N. Find its shear...

See similar textbooks

Similar questions

A company is testing a new material made of recycled plastic for use in construction. Figure P14.48 is a graph of the stress as a function of strain for this material. Find Youngs modulus for this material and compare your result with the data for conventional building materials listed in Table 14.1.
Discuss how you might measure the bulk modulus of a liquid.
Review. A wire of length L, Youngs modulus Y, and cross-sectional area A is stretched elastically by an amount L. By Hookes law, the restoring force is kL. (a) Show that k = YA/L. (b) Show that the work done in stretching the wire by an amount L is W=12YA(L)2/L.
Bone has a Youngs modulus of 18 109 Pa. Under compression, it can will island a stress or about 160 106 Pa before breaking. Assume that a femur (thigh bone) is 0.50 m long, and calculate the amount of compression this bone can withstand before breaking.
A 100-N weight is attached to a free end of a metallic wire that hangs from the ceiling. When a second 100-N weight is added to the wire, it stretches 3.0 mm. The diameter and the length of the wire are 1.0 mm and2.0 m, respectively. What is Young’s modulus of the metal used to manufacture the wire?
Calculate the pressure due to the ocean at the bottom of the Marianas Trench near the Philippines, given its depth is 11.0 km and assuming the density of sea water is constant all the way down. (b) Calculate the percent decrease in volume of sea water due to such a pressure, assuming its bulk modulus is the same as water and is constant. (c) What would be the percent increase in its density? Is the assumption of constant density valid? Will the actual pressure be greater or smaller than that calculated under this assumption?
A uniform rope of cross-sectional area 0.50cm2 breaks when the tensile stress in it reaches 6.00106N/m2 . (a) What is the maximum load that can be lifted slowly at a constant speed by the rope? (b)What is the maximum load that can be lifted by the rope with an acceleration of 4.00m/s2 ?
Bone has a Youngs modulus of 18 109 Pa. Under compression, it can will island a stress or about 160 106 Pa before breaking. Assume that a femur (thigh bone) is 0.50 m long, and calculate the amount of compression this bone can withstand before breaking.
A high-speed lifting mechanism supports an 800.-kg object with a steel cable that is 25.0 m long and 4.00 cm2 in cross-sectional area. (a) Determine the elongation of the cable. (b) By what additional amount does the cable increase in length if the object is accelerated upward at a rate of 3.0 m/s2? (c) What is the greatest mass that can be accelerated upward at 3.0 m/s2 if the stress in the fable is not to exceed the elastic limit of the cable, which is 2.2 108 Pa?