Answered: Which of the Following can be a source…

Science

Physics

Which of the Following can be a source of EMF? A. battery B. Wind generator C. Power Lines D. All of the above

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 18CQ: Which is more likely to interfere with compass readings. AC current in your refrigerator or DC...

See similar textbooks

Related questions

Q: In a vacuum, two particles have charges of q1 and q2, where q1 = +5.1 C. They are separated by a dis...

Q: 3. To help workers in your project site move dozens of equipment weighing 60 kgs to a height of 2.2m...

Q: 1) A car starting from rest is traveling with a contant acceleration of 30 mis Find s veladity ater ...

A: Given data: Initial velocity (Vi) = 0 m/s Acceleration (a) = 30 m/s2 Time (t) = 5 s Required: Final...

Q: A cannonball is shot with an initial speed of 30.0 m/s and 25.0º angle above horizontal from a heigh...

Q: Explain concisely why charged plastic comb can attract neutral pieces of paper, and the so called "f...

A: The comb is initially electrically neutral. As a result, the little fragments of paper are unaffecte...

Q: Two thin rods 10 cm long and the charge per unit length +20 C/m, are arranged as shown in the figure...

A: Given Length of rod, L = 10 cm Point p from one end of each rod, P = 2 cm Charge per unit length ...

Q: On a cool morning in Alaska, when the temperature is -10.0 °C, the car tire pressure is 32 psi. Unde...

A: Given T1= -10° C = 263 K P1 = 32 psi We have to find the pressure of tire when temprature heats up ...

Q: For questions 7 to 10, refer to the given problem below. Three 25-N forces act on a beam shown: 60° ...

Q: I have a question on how to calculate the kinetic energy of a mass without having a given velocity. ...

A: Kinetic energy can be calculated by applying energy conservation:- Ei= Ef => Ki + Ui = Kf + Uf Wh...

Q: gold wire carries 24.5 A of current with a drift velocity of 2.5 × 10-3 m/s. Assume there is one fre...

A: Given Current I = 24.5 A Drift velocity vd = 2.5 × 10-3 m/s Density =1.93 × 104 kg/m3 Mmolecular we...

Q: Consider the velocity vs. time graphs for two objects. (a) Does either object ever turn around? If ...

Q: diagram

Q: One gram of water (1 cm3) becomes 875 cm3 of steam when boiled at a constant pressure of 1 atm (1.01...

A: Given data: Mass, m=1 g Latent heat of vaporization, Lv=2.256×106 J/kg=2256 J/g Volume of steam, Vs...

Q: Quite often advertisements appear for telescopes that extol their magnifying power. a) Is this a goo...

Q: Sketch the FBD of a strong robot pushing a box along a horizontal floor if the box is not moving

A: Post the remaining questions separately!

Q: Given data: Mass of liquid%3800 kg Volume of liquid%3D1000 m3 Determine density

A: Given data : Mass of liquid=m Volume of liquid=V To find : Density

Q: Given data : Force applied=10 N Displacement=5 m Determine work done

A: Given data : Displacement=D Force=F To find : Work done

Q: A particle describes an UCM(uniform circular motion) with period 0.500 s and circle centered at the ...

Q: The a-t curve for a particle having rectilinear motion is shown in the figure. At t-e, the velocity ...

A: we can write a(t) =7 for 0≤t≤5a(t) =mt+n for 5≤t≤8a(t) =pt+q for 8≤t≤10 equating the values at t=5, ...

Q: Hydraulic engineers in the United States often use, as a unit of volume of water, the acre-foot, def...

Q: A rod of length L = 4.00 m with uniform charge of 5.80 nC/m is oriented along the y axis as shown in...

A: Consider the given data as below. Total charge, Q=5.80 nC=5.80×10-9 C Length of a rod, L=4 m Coulomb...

Q: Given data : Width=5 m Depth=12 m Determine moment of inertia about centroidal axis parallel to x ax...

A: Given data : Width=B Depth=h To find : Moment of inertia about centroidal axis parallel to X axis

Q: If the magnitude of the electric field in air exceeds roughly 3 x 10° N/C, the air breaks down and a...

Q: raiL A Determine the normal force exerted by the road on the car. A 1000-kg sports car (including th...

Q: Which of the following does not explain why the magnetic flux on a closed surface equal to zero? 2 M...

A: Magnetic flux is defined as the amount of magnetic field passing through a given area and it can be ...

Q: The voltages V1, V2, V3, and v4 are the node voltages corresponding to nodes 1, 2, 3, and 4 in the b...

Q: Earth's orbit is nearly circular. If, however, Earth's orbit were more elongated and elliptical, wha...

Q: The a-t curve for a particle having rectilinear motion is shown in the figure. At t=0, the velocity ...

A: a(t)= 7 for 0≤t<5a(t)= mt+n for 5≤t<8a(t)= pt+q for 8≤t<10 a(5)=7, a(8)=-6 →5m+n=7,8m+n=-6 ...

Q: On planet #4, you fire a projectile from the ground at an initial speed of 29.7 m/s at an angle of 5...

Q: Three charges line vertically respectively 31 C, -62 C, -38 C. 31 C and -62 C is separated by 20μm w...

Q: What is the force of gravity between two 1000 kg cars separated by a distance of 20 m on a highway? ...

Q: The filament of a tungsten light bulb has a resistance of 1 Ω at 20°C. If the length of the tungsten...

A: R=ρlA ...(1)R→resistance of the filamentρ→resistivity of the material of the filamentl→length ...

Q: Which component of the x-ray tubehead absorbs long waves created by the production of x-rays? Insula...

Q: The molar specific heat at constant volume of an ideal gas is equal to 3.5times the universal gas co...

Q: A package is dropped from a helicopter that is moving upward at 15 m/s. If it takes 8 seconds before...

A: Given Time take to reach ground,T = 8 second Acceleration due to gravity,g = 9.8m/s2 (downward) Up...

Q: The a-t curve for a particle having rectilinear motion is shown in the figure. At t=0, the velocity ...

A: We can write the form of acceleration as a(t)=7 for 0≤t≤5a(t)=mt+n for 5≤t≤8a(t)=pt+q for 8≤t≤...

Q: Over a certain region of space, the electric potential is V = 6x − 8x2y + 6yz2. (a) Find the expres...

Q: Charge q 1 and q 2 exert 20-N repulsive forces on each other. Calculate the repulsive force of one c...

Q: Imagine 4 objects made of the same material but with different masses. All systems have the same coe...

Q: Why is a modified vehicle with its body raised higher or less stable than a similar vehicle with its...

Q: A particle is thrown horizontally with an initial speed of magnitude 114 m/s from a point 1.16 m abo...

A: Initial horizontal velocity (u) = 114 msinitial height (ho) = 1.16 m horizontal distance (d) = 43.1 ...

Q: Compute the frequency (in MHz) of an EM wave with a wavelength of 2.4 in. (0.0610 m). ______________...

A: The answer is below

Q: Bill forgets to put his car in park, and it starts rolling forward. When it is moving at a speed of ...

Q: A sphere of radius 0.500 m at 18.0 °C is placed in the outside on a hot summer day at 40.0 °C. The e...

Q: Four resistors are connected in a circuit with a battery of unknown emf, as shown below. The battery...

A: Given value--- All values given in circuit. We have to find--- (c) Calculate the power dissipated...

Q: Bonita Cart hita is pulling a cart to the right. She does not realize that the cart is tied to a wal...

Q: 4. Three charges are placed on three corners of a square, as shown in the figure. Each side of the s...

Q: A marble is thrown upward with an initial speed of 15.6 m/s. Assume g=10.0 m/s2 and neglect air res...

A: Given Initial velocity u=15.6m/s Final velocity v=0.5×15.6=7.8 m/s Acceleration due to gravity g=10...

Q: Vector R is defined as the vector sum of vectors A and D (R = À + D) shown below. What are the vecto...

Q: A little turtle is placed at the origin of an xy-grid drawn on a large sheet of paper. Each grid box...

Concept explainers

Magnetic Field Of Coaxial Cable

The word coaxial means same axis. So for a long straight cable to be coaxial, it must have concentric cylindrical shaped conductor around it. Coaxial cable (popularly called ‘coax’) has various applications ranging from current conductors to radiofrequency signal transmitters. This cable has lower emission losses and provides protection from electromagnetic interference which allows signals with less power to transmit over longer distances.For example, currents produced in the pickup of a stereo turntable generally travel to the amplifier through a coaxial cable.The self-inductance of a coaxial cable is another important characteristic, because it influences the propagation of electrical signals in the cable.

Question

Which of the Following can be a source of EMF?

A. battery

B. Wind generator

C. Power Lines

D. All of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Integrated Concepts A light-rail commuter train draws 630 A of 650-V DC electricity when accelerating, (a) What is its power consumption rate in kilowatts? (b) How long does it take to reach 20.0 m/s stalling from rest if its loaded mass is 5.30 1()4 kg, assuming 95.0% efficiency and constant power? (c) Find its average acceleration. (d) Discuss how the acceleration you found for the light-rail train compares to what might be typical for an automobile.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain what AC and DC are. Why is AC used by electric utilities? Why is DC used in flashlights?
Explain how you could thaw out a frozen water pipe by wrapping a coil carrying an alternating current mound it. Does it matter whether or not the pipe is a conductor? Explain.
Verify than the direction of the line force in an MHD drive, such as that in Figure 22.32, does not depend on the sign of the charges carrying the current across the fluid.
Integrated Concepts (a) What is the direction of the force on a wire carrying a current due east in a location where the Earth’s field is due north? Both are parallel to the ground. (b) Calculate the force per meter if the wire carries 20.0 A and the field strength is 3.00105T. (c) What diameter copper wire would have its weight supported by this force? (d) Calculate the resistance per meter and the voltage per meter needed.
A motor operating on 240 V electricity has a 180 V back emf at operating speed and draws a 12.0 A current. (a) What is its resistance? (b) What current does it draw when it is first started?
A GFI may trip just because the live/hot and neutral wires connected to it are significantly different in length. Explain why.
Why must pan of the circuit be moving relative to other parts, to have usable motional emf? Consider, for example, that the rails in Figure 23.11 are stationary relative to the magnetic field, while the rod moves.
A student in a physics lab mistakenly wired a light bulb, battery, and switch as shown in Figure 21.44. Explain why the bulb is on when the switch is open, and off when the switch is closed. (Do not try this-it is hard on the battery!)
A plug—in transformer, like that in Figure 23.29, supplies 9.00 V to a video game system. (a) How many turns are in its secondary coil, if its input voltage is 120 V and the primary coil has 400 turns? (b) What is its input current when its output is 1.30 A?
Which is more likely to interfere with compass readings. AC current in your refrigerator or DC current when you start your car? Explain.
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.