Which of the following compounds give aldol condensation product? a. p-nitrobenzaldehyde b. Acetaldehyde c. Trimethyl acetaldehyde d. Formaldehyde

Q: Q1:Identify the name and the function of the following equipment used in the Wet Crude oil Treatment...

A: 1) It is pressure vessel: This equipment is used to hold fluid at high pressure . Construction metho...

Q: 1. Dropwise condensation occurs on a.clean and dirt free surfaces b.contaminated cooling surfaces ...

A: Condensation usually occurs in two types- Filmwise and Dropwise Dropwise condensation occurs when th...

Q: 3. In an experiment, a mixture of oxygen and nitrogen gas is collected over water at 30°C and 700 to...

A: T = 30 0C P = 700 torr Partial pressure of nitrogen = 550 torr Vapor pressure of H2O at 30 0C = 4.24...

Q: A feed of a distillation column contains 40 mol% of n-pentane and 60 mol% of n-hexane will be separa...

A: Given Distillation column:  Feed- 40mol % n-Pentane 60 mol% n-hexane Flowrate of feed=2500 lbmolh te...

Q: A kind of liquid is flowing through a pipe. Diameter of the pipe is 20 cm, initial temperature of th...

A: Fluid flowing in a pipe D=20cm Ti=22℃ Flow velocity, u = 20cm/s TW=2℃ To=20℃ Properties table F...

Q: Q3: How many 100 lb sacks of Barite are used to increase the mud weight of 100 bbl of 10 ppg mud to ...

A: Weighting up is an important part of the drilling process. There are various weighting agents such a...

Q: ( N2) gas have molar mass = 28g\mol , (7 g ) is 0.25 mol of gas , temperature is T = 353 K, we do kn...

A: Given: The moles of N2 gas is nn2 = 0.25 mol Temperature T = 353 K The volume of gas reduces as V2= ...

Q: H.w. Plat us Pressare gradient , tind the slopy Cal Caulate & K W AL

A: Plot pressure gradient and q/Ac Slope in plot Value of K

Q: 100 moles of a mixture containing 60% moles of n-pentane and 40 moles of n-heptane is evaporated unt...

A:

Q: A Simple Rankine cyele works befween pressures 3100 kpa andd loo kpe, the initial eordifion of Steam...

A: Given data P1=3100 Kpa = 31 bar P2=1000 Kpa = 10 bar Find out  cycle efficiency Work ratio Specific ...

Q: Identify the name and the function of the following equipment used in the Wet Crude oil Treatment pl...

A: Crude oil is fractioned into gasoline ,diesel, other fuels , wax, paraffins and many other products....

Q: FLUID DYNAMICS The pipeline have (QA = 15 L/s), (QB = 3QD), (DA=100 mm), (DB= Dc = 25mm), (Dp= 50 mm...

A:

Q: A Simple Dankine Cycle works heturen pressure 3400 kp9and beahpa.the inthial candition of steam beln...

A: Find cycle efficiency Work ratio Specific steam consumption Where P1= 3400 Kpa = 34 bar P2=1000 Kpa ...

Q: How many moles of MgCl₂ are present in 54.0 mL of 0.135 M MgCl₂ solution?

A:

Q: Problem 1 A full-scale reactor is to be designed using hydrogen peroxide (k = 0.03/min. and initial ...

A: The vessel in which chemical reaction happens is chemical reactor. Different type of reactor are PFR...

Q: QUESTION 3 THERMODYNAMICS: A 1.09 g sample of acetic acid (HC2H302) was burned in excess oxygen in '...

A:

Q: A tensile stress is to be applied along the long axis of a cylindrical brass rod that has a diameter...

A:

Q: THERMODYNAMICS: A 1.09 g sample of acetic acid (HC2H302) was burned in excess oxygen in a bomb calor...

A:

Q: Propanal (CH3CH2CHO) is used in the pharmaceutical industry to make essential ingredients, organic c...

A: (i) Reaction Kinetics is limited by irreversible reaction CH2CH2 + CO +H2→CH3CH2CHO selectivity = 90...

Q: Maximizing selectivity for Trambouze Reactions Three competing reactions: 1) zero, 2) first and 3) s...

A: given: k1=0.0001 mol/dm3.s k2=0.0015 s-1 k3=0.008  mol/dm3.s  

Q: Calculate the volume of an FCC unit cell in terms of the atomic radius R

A: Given data  FCC unit cell Atomic radius=R

Q: What is the appropriate extraction time for SDME Is it low extraction or high extraction

A: SDME single drop micro extraction is a simple,fast micro extraction technique of combining stirring(...

Q: THERMODYNAMICS: A 1.09 g sample of acetic acid (HC2H302) was burned in excess oxygen in a bomb calor...

A: Given data: Mass of acetic acid = 1.09 g Heat capacity of calorimeter = 2.67 kJ/0C Mass of water = 7...

Q: The irreversible, first-order, liquid phase reactions AR S are currently carried out in two CSTRS in...

A:

Q: 11.3-16 An equimolar mixture of ethanol and ethyl acetate is maintained at 75°C and 10 bar. The pres...

A:

Q: Straight-chain, saturated carboxylic acids, a class of hydrocarbons, has the general formula CnH2n+1...

A: Given Carboxylic acid have General formula = CnH2n+1COOH Where 1<n<18 If n=1 Find %  C by ma...

Q: Q3/ Estimate the Watson characterization factor K, molecular weight, Aniline point, carbon to hydrog...

A: Give data: Mean average boiling point = 99 0C API gravity = 52

Q: An evaporator-crystallizer is to produce 13,000 kg dry salt/h from a feed solution having 20% NaCI. ...

A: Refer to the figure shown below for the given evaporator-crystallizer system:

Q: Q3. A 1-mm-diameter wire is maintained at a temperature of 400 °C and exposed to a convection enviro...

A:

Q: Q.3 a). A tensile stress is to be applied along the long axis of a cylindrical brass rod that has a ...

A: The magnitude of load is to be calculated.

Q: Discuss the possible use of LiNbO3 and YAG as possible hosts for Cr3+ as laser materials. In your an...

A: So we have to find out why we are choosing the levels with proper reason.

Q: 4. For a capillary glass tube of 1 mm diameter, compute the rise of water above the water surface if...

A: Since there is no effect of oil on capillarity hence, rise of water is only due to surface tension o...

Q: 3-10 Determine the atmospheric pressure at a location where the barometric reading is 750 mmHg. Take...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: (4) calculate the volume of a drilling mud prepared from water and bentonite only (bent %=8%), to wh...

A: Given, The density of mud, ρ = 10 ppg = 10 lbgal×119.826 kg/m31 lb/gal = 1198.26 kg/m3 The volume of...

Q: QUESTION 10 A dilute solution of acetic acid produced by fermentation and oxidation of natural carbo...

A:

Q: 3. The irreversible first order liquid phase reaction A »R is to be carried out in an insulated mixe...

A:

Q: 3-IC What is the difference berween gage pressure and absolute peessure?

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Calculate the power to move a load of 850 tons/h of a granular material on a conveyor belt, 1 m wide...

A: Given data: Flow rate of granular load = 850 tons/h Width of conveyor belt = 1 m Length of conveyer ...

Q: Calculate the molality of a 4.21 M ethanol (C₂H5OH) solution whose density is 0.9479 g/mL.

A: Given : Molarity of solution =4.21 M density = 0.9479 gml WE have to find out Molality of solution. ...

Q: Methanol is synthesized from carbon monoxide and hydrogen in a catalytic reactor according to the fo...

A: Reaction is CO + 2H2 --> CH3OH Reactor effluent flow rate=550kmol/h Composition of Reactor efflue...

Q: Q.2 а). Calculate the Poly Dispersity Index PDI for given data. Number of Molecules Mass of each Mol...

A:  

Q: Density and viscosity saturated fatty acid at 20 degree celcius and 1 atm

A: Given T=20oC and P=1 atm Density of fatty acid=910 Kg/m3

Q: I need the answer as soon as possible

A: Peat gas analysis: Component % CH4 22 C2H6 12 CO 15.8 N2 7 O2 43.2 Total  100 Sol...

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with o...

A: Oil density = ρ1 = 1500 kg/m3  Depth of oil = Z1 =  1 meter  Water density = ρ2 = 1000  kg/m3   Dept...

Q: A continuous single-effect evaporator is to be fed with 5000 kg/hr of solution containing 1 wt% solu...

A:

Q: How filtration is different from screen? As a process engineer, which parameters would you consider ...

A: Screening  Screening is a unit operation primarily applied for the purification of wastewater or any...

Q: There are 30 kg of solute in 100 liters of water. The weight of solute that will be extracted by 35 ...

A: Given m=4 Volume of ether=35 L also density of ether=3.623 Kg/L mass of ether=35×3.623=126.805 Kg m=...

Q: The equilibrium constant, Kc, for the following reaction is 55.6 at 698 K. H2(g) + I2(g) 2 HI(g) Cal...

A: Equilibrium constant, KC= 55.6 Temperature, T= 698 K   Reaction is: H2 (g) + I2 (g) → 2HI (g)   H2 =...

Q: 1. Baffles in the shell side of a shell and tube heat exchange a.Forcethe liquid to flow parallel t...

A: Baffles which are basically metal plate and integral part of shel and tube heat exchanger.

Q: How the equipment works for Fixed-bed leaching

A: Leaching basically involves use of solvent to remove solute from a solid mixture. Here generally we ...