Answered: Which of the following diode is used in…

Which of the following diode is used in high frequency switching operations? O a. Silicon junction diode O b. Schottky diode O. General purpose diode O d. PN junction diode

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: Determine Vo, Vdc, PIV and sketch the output waveform for the circuit below. Ideal diodes 2.2 ka 170…

Q: A single-phase full-wave transistor rectifier feeds power to motor load. The source voltage is 230V,…

A: In this question we will find average value of output current for single phase full wave rectifier…

Q: For positive half of the signal below, what is the peak output value of the circuit? NOTE: use…

A: During negative cycle when vin< -9.3V diode will conduct and capacitor will charge upto Vc=…

Q: To rectify A.c signal with small peak value we use : O Si diode Ge diode O Zener diode O None

A: Silicon diode has a voltage drop of approximately 0.7 V And Germanium diode has a voltage drop of…

Q: Draw the output wave shape of the following biased diode clipping circuit.

A: Given- Two diodes =D1 and D2 Input voltage = Vin To find- Output wave voltage = ?

Q: Determine the ripple factor for the filtered rectifier circuit below when RL= 4KN. Then explain…

A: Given : Load resistance RL = 4 K ohm Capacitance C = 50 u F They are interested in the…

Q: 5- The frequency of the output voltage obtained from three-phase Wye/Delta connected rectifier is :…

Q: 27 - Which of the following is Mosfet's trigger tip? A) Anode B) Beyz C) Gate D) Cathode E)…

Q: a2/a.Design Circint as the following pescripton: A- the positive Cycle of the vout signal is 3.2 and…

A: Given, Input voltage = 10 V Positive cycle output voltage = 3.2 V Negative cycle output = 4.3 V

Q: The larger the value of the filter capacitor, the Select the correct response smaller the de voltage…

A: The solution is given below

Q: Draw the diode equivalent circuit for the Exclusive OR gate (EX-OR) with two inputs (A) and (B) and…

A: Exclusive OR Gate Equation C= AB'+A'B Draw the diode equivalent circuit for this gate.

Q: Q5/ For the circuit shown below, Draw Vout determine Vpeak Secondary, VODC What is the peak inverse…

Q: A half-wave rectifier circuit employing an SCR is adjusted to have a gate current of 17.86mA. The…

Q: The current produced in a reverse-biased diode is called as Breakdown Current O Negative Current O…

A: the diode can be connected in two configurations , forward bias and reverse bias.

Q: Tilt of the output waveform for the circuit is 1%. Given that input is a square wave ± 10 V, f = 2…

A: Given: Tilt of the output waveform is 1%. Input is a square wave of maximum and minimum amplitude…

Q: Which one of the following semiconductor device is used for high frequency and low power application…

A: Which one of the following semiconductor device is used for high frequency and low power…

Q: Draw a full wave bridge rectifier circuit with input voltage is vz = 18 sin(1100t), design the…

Q: For full wave bridge rectifier, Ripple Factor=19% and Vdc=9V. Find Vrms. . Volt and Vr(P.P). .Volt.…

A: Full wave rectifier Ripple factor = 19% Average voltage Vdc= 9V Then value of rms? Ripple…

Q: How many diodes conduct in the Full-Wave Bridge Rectifier with filter, while the capacitor is being…

A: An device which convert alternating signal in to pulsating direct signal. The half wave rectifier…

Q: 4. Sketch the output Vout for the given input Vin (shown on the right hand side) for each of the…

Q: a. Explain the use of a capacitor filter with the aid of a diagram. b. Draw the V-l characteristic…

Q: 2. A diode has the reverse recovery time, trr = 4 µS and the reverse recovery current time in di/dt…

A: We need to find charge and current for given diodes

Q: Design the Clipper-Clamper circuit to perform the output waveform shown in figure below. GaAs Diode…

A: Clipper and clampers

Q: For the given input waveform to the given circuit, what is the minimum value of the .output…

A: Input waveform is given , it's is triangle waveform. Find the minimum output voltage?

Q: 2. The harmonic spectrum of the following figure belongs to the input current of which of the…

A: To solve above problem, one should know what three phase semi converter is and how it is working. To…

Q: A single-phase diode bridge is supplied at 120 V. Determine the mean load voltage for firing delay…

Q: hat happens for the bias voltage, depletion region a miconductor diode? Draw appropriate figures.

A: When use an external voltage it across the semiconductor diode in such a way that the p-side is…

Q: R1 D1 D2 10 kQ V1 5 V +\V2 5V Vout Vin R3 10 kQ R2 10 kn

Q: Design the Clipper-Clamper circuit to perform the output waveform shown in figure below. GaAs Diode…

A: Give are Clipper and clampers Output is 10 V an d input is 13 vwe have to reduce them as 3vAssume…

Q: 6. Choose the incorrect statement about SCR* Uniploar voltage withstanding саpabilty O Pulse gate…

Q: Draw the circuit used in Full Clipping with the input and output signal as a function of time for a…

A: The solution can be achieved as follows.

Q: Q3) The boost converter has parameter Vs. = 20 V, R = 12.5 N, L=10 µ H, C =40 µ F, and the switching…

A: There are AC and DC supplies available. Different loads have different requirement of voltages.…

Q: O The time during which the diode(s) is (are) conductir O The time during which the diodes are not…

Q: In a Fully controlled rectifier with RL load, if the average output voltage is half of the maximum…

Q: In a Schottky diode, the silicon is usually O a. silicon is not used O b. P-type O c. un-doped…

A: Schottky diode has fast recovery rate .They have low turn on voltage . It is formed by semiconductor…

Q: Match the diode application to the type of diode Oscillator circuits Choose... Modulating device…

Q: (2) In the adjacent circuit, the input signal Vin F15V is a square wave. Draw the output signal as a…

A: In this question, We need to draw the waveform of the output voltage? If zener diode Vz = 6V Input…

Q: Application of the Standard & Schottky Diode.

A: Since it is only asked to write the applications of a normal diode and a Schottky diode. The…

Q: 1. A six-pulse uncontrolled recti load. The inductance is very 1 (a) Determine average load o (b)…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Draw the diode reverse direction model.

Q: Vin R M D₁ A Evaluate output using ideal diode model and .Dz + Voutput constant voltage drop model.

Q: reverse leakage current. conventional current. reverse breakdown current. forward-bias current.…

A: In the given question the first two words are missing. The complete question should be The current…

Q: The Schottky diode is used O in very fast-switching circuits. O in power supply rectifiers. O in…

A: Power diodes are a two-layer, two-terminal p-n junction semiconductor device; it has one p-n…

Q: Ideally the voltage drop across a diode under off state must be O a. higher than the forward biased…

A: 1) Ideally the voltage drop across a diode under of state must be. Ans . 0 during off state diode…

Q: R1 9V R2 ZENER 3k (+ 1

A: we need to explain What is the advantage of using a transistor zener regulator circuit instead of a…

Q: 1. Given the circuit, VA=15V (ignore the variable symbol) CR1 CR2 VA R1 R2 3.ЗК 3.ЗК a.) Which diode…

A: Diode cr1 is forward biased and diode cr2 is reversed biased.

Q: Q/ Name a Schottky diode that operates at small frequencies

A: The Schottky diode is a type of metal– semiconductor junction diode. Schottky diodes are also known…

Q: Which diodes are "closed" during the negative half-cycle of the input signal? * D1 D3 A + AC Source…

A: We need to tell about which diode will be on and output voltage .

Q: 7. A PFC circuit is designed with the following parameters. V.- 100Vms, Va- 400V, L-2A. What is the…

A: Vin=100 VrmsVout=400VIout=2A

Question

Electrical Engineering _ Power Electronics

Notes: pls try to answer in less than 30 min.

Which of the following diode is used in high frequency switching operations?
O a. Silicon junction diode
O b. Schottky diode
O. General purpose diode
O d. PN junction diode

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is CEMF?
What is the difference between a diode and rectifier?
How is a solid-state diode tested? Explain.
Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
The diode that has a metal-to-semiconductor junction and used in fast-switching is: Select one: a. Schottky diode b. Laser Diode c. PIN diode d. Tunnel Diode
Basic signal system...
plz solve this signal and system subject ...
Calculate the output voltage and Zener diode current of the given regulator circuit.
. Give the short answer offollowing questions each question carries equal marks Don’t need tobriefly explain Its better to give point to point answer . (a) How zenerdiode is a special diode (b) Explain the difference between zener and avalanche effect (c) Explain break down voltage (d) Draw the symbol of PN junction diode, tunnel diode , Zener Diode. (e) How collector size is more than emitter (f) How NPN transistor is more good as compare to pnp (g) Why collector have more size than emitter
Veb diode= 0.7, beta= 100, Vt= 25mV, ignore ro solve Ib, Ic, Ie, Vb, Ve, gain, Rin, Rout
What characteristics are there in 8255's mode 2?
1. The applied voltage in a Germanium diode is found to be 0.41 V with a threshold voltage of 26 mV and saturation current of 1 nA Calculate for the diode current. 2.The voltage as the switch is closed for an SCR circuit is found to be 4V and the current is 0.2A Compute for the average power conduction loss for a frequency of 60 H2 Assume the tum on and turn off time is 0.12 m and 0.25 ms respectively 3.If the trigger voltage in the circuit is replaced by SV, the series resistor by 330 ohms, compute for the gate current at the SCR when Switch 1 and 2 are momentarily switched on. The voltage at the gate to cathode is 0.7V while that of the voltage from anode to cathode is 10V 4.Id=11.84 mA n=2, and the applied bias voltage is 0.5V and the temperature requirement is at 20°C. Findthe diode saturation current 5.For a frequency of 60 Hz, compute for the average power conduction loss if the difference in the turn off and turn on time is 10 ms and the instantaneon power is given as a…