Which of the following instruments has its reading independent of the waveform and frequency of the AC supply?

Q: Determine R and Vz Given: ILMAX=200 micro ampere ILMIN=0 ampere V₁=12V R V-12V

A: Given data, Circuit diagram is given as,

Q: What are the shortcomings of one dimensional parity error detection scheme? And discuss the…

A: Shortcomings of one dimensional parity error detection scheme : There are mainly two shortcomings of…

Q: II. Refer to Figure 2. 1. State if the circuit below in Figure 2 is a high pass or low pass filter,…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: A coil is wound from a 10 m length of copper wire having a cross sectional area of 1.0 mm².…

A: This question belongs to circuit theory . It is based on the concept of formula of resistance .…

Q: rite a short note on quadra

A: Quadrature amplitude modulation : Quadrature amplitude modulation is also known as QAM it is the…

Q: 25 If p.f of a circuit is unity, its reactive power is O a minimum O equal to the square of I…

A:

Q: 10m V Refer to Figure 5. 1. If v, = 5 mV, find current io 4k(2 8k(2 + V 2k2 Va Fig. 5 2. If v, = 20…

A:

Q: Q3: A 3-phase half wave-controlled rectifier is fed from 3-phase 400V, 50Hz source and is connected…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Subject to a step input, the voltage drop across the resistor took 696.3103us to reach 13% of its…

A: for study state , L gets short so  ,i = ViR  ,  V0=Vi As voltage drop across L is 0 at study…

Q: Q.2 Consider the control system shown in Figure below in which a PID controller is used to control…

A:

Q: 2. The unit impulse response of a system is given by T(t)= e-(1-cos2t). Determine its transfer…

A:

Q: Q2: Determine the particular solution of the difference equation y(n) = zy(n-1) - by(n - 2) + x(n)…

A:

Q: R₁ R₂ R₂ R₂

A:

Q: Optical fibers are very reliable communication channels and they transmit data in… A. Analog B. Both…

A:

Q: For a control system shown in figure below, find the value of K & Ke

A:

Q: Given point P(—2, 6, 3) and vector A = yax + (x + z)ay, express P and A in cylindrical and spherical…

A: Given, point P(—2, 6, 3) and vector A = yax + (x + z)ay

Q: An unbalanced star connected load is connected across a

A: as per our guidelines we have done 3 answers

Q: Given an LTI  system with the transfer function H(jΩ)= e-jΩ (2+2cosΩ), the input signal…

A:

Q: b. Choose the suitable choice for nine of the following sentences. 1. In order to tune a parallel…

A: As per the honor code I will do first three questions. Kindly repost the other questions again.…

Q: D +10 V R 2.0 ΚΩ Assume the diode is a practical diode with Vy= 0.7 V. If the diode is reversed, the…

A: Given circuit,

Q: Determine the poles and zeros of the system whose transfer function is given by G(s)=- 2s +1 s²+35+2…

A: Given: The transfer function of the system is Gs=2s+1s2+3s+2

Q: A current balance bridge shown inFigure 1, has resistance of R1 = R2 = 1kn2, R4 = 5900, R5 = 102,…

A: Resistance: It is the property of a material that resists the flow of the current in it. The power…

Q: 4. Given k = 0.4 * 10-³ A>V² and ID(on) = 3 mA with VGs(on) = 4 V, determine VT.

A:

Q: P1: Calculate current I, using Thevenin method. Assume i(t)=2√2 sin (wt-45°), e(t)=4√2 sin 3wt,…

A: Note: Since units are not mentioned, we will take the units of current sources as 'A', for voltage…

Q: 75 Find Rab in the four-way power divider circuit in Fig. 2.135. Assume each element is 10.

A:

Q: Electrical Engineering 2. Using known DTFT's or results derived in class, determine the complex…

A: As F(x)=F(-x)  is even function for even function signal the value of Coefficient bn=0 As…

Q: Describe in your own words the characteristics of the ideal diode and how they  determine the on and…

A: What is an ideal diode? When voltage is applied forward biased, an ideal diode works as a perfect…

Q: -V W To/2 7. T. find C₁, X(+) :- scetch the amplitude and phase Spectrums

A:

Q: . Refer to Figure 3. 1. Determine the gain v /v, 2. If v, = 6 mV, find Io and Vo. 3. Find Input…

A: To determine 1) Gain Vo/Vs 2) if Vs = 6 mV , then find Io and Vo 3) input and output resistance

Q: 1. The negative feedback circuits are of (a)One (b) Two (c) Three types (d) Four

A: We are authorized to answer only 1 question at a time so i am answering only 1st please repost your…

Q: In a balanced network, AB is a resistance of 500Ω in series with an inductor of 0.18 H, BC  and DA…

A:

Q: Solve for the base current if collector current is 600 mA and the current gain is 20.

A: Given  Collector current is 600 mA Current gain is 20.

Q: 3. The vector current density is given as J = (4/r²) cose ar + 20e-2r sine ae - rsinecos ao at r =…

A: Given: Vector current density is given as:J→=4r2cosθar+20e-2rsinθaθ-rsinθcos∅a∅ Required:J→ at…

Q: a coil of resistance 10 ohm and inductor 0.02 henry is connected in series with another resistance…

A: Inductance is the ration of the induced voltage and the rate of change of current cause it. It is…

Q: 1. Define Pitch Factor /Distribution Factor and present the formula to calculate. 2. Draw the

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 7. The type of active filter is: (a) active low pass filter (b) High pass filter (c)active band pass…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Consider a single phase transformer of rating 150 KVA, 3600/360, 50 Hz. Let the series resistance…

A: Formula to calculate voltage required to produce rated current at short circuit is: VSC=V1×ZPUwhere…

Q: R A series type ohmmeter, designed to operate with a 9-V battery, the meter movement has an internal…

A: Given data, Voltage Vb=9V Resistance R1=49kohm Current Ifsd=100microA Internal Resistance Rin=2kohm

Q: 7.03. Find the type of the feedback in the given circuit Vcc Re Vo RE (A) Current - series (B)…

A:

Q: Determine the Memory, Causality and Stability properties of the syste

A:

Q: The voltage at the sending side (source) of a transmission line is 1 KV (Vs = 1 KV). The voltage at…

A:

Q: Q2) For the circuit in the figure below, calculate the input power, output power, and power handled…

A: Given: A power amplifier circuit.  According to question:  The peak input voltage is calculated…

Q: 6 A series type ohmmeter, designed to operate with a 9-V battery, the meter movement has an internal…

A: Solution- Given, Series type ohmmeter, a) Vb'= 8.8 VWhen Rx = 0,IR1 =Vb-VR2R1=9-2×100×10-349…

Q: for the cct. as shown + in fig. U 3 Jc a) 1 = 4 (0, w = 10 w = 10 red/sec find cif V = 80+√200 b)…

A: Given circuit

Q: 10m V Refer to Figure 5. 1. If v, = 5 mV, find current io 4kQ2 8K02 to V₁ 2k12 Vo Fig. 5 2. If v, =…

A:

Q: Two identical 20 MW three-phase alternators operate in parallel. The governor of first machine is…

A: Given data : Rated load PL=20MW Frequencies on no-load and full load are 50Hz and 48Hz After drop…

Q: For the JFET amplifier circuit of Fig. 4-7, determine the lower- and higher-cutoff frequencies and…

A:

Q: 1. An aluminum conductor is 1000 ft.

A:

Q: Assume an amplifier has a midrange voltage gain of 22. Expressed in dB, this is 13.4 dB 3 dB 40.3 dB…

A: Given: An amplifier has a mid range voltage gain of 22.

Q: A single phase transformer of (k) transformation ratio is to be used as a step-up autotransformer.…

A: Given data : Transformation ratio = K KVA capacity is increased by 50%.

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.