Answered: Which of the following is not a…

Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system? Ic = 0 la = 0 Ib= 0 None of these

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter10: System Protection

Section: Chapter Questions

Problem 10.12P

See similar textbooks

Related questions

Q: In the following 3-phase power system, the voltage at point a is initially 0.95 pu, and the motor is…

A: In this question we need to find a fault current of the given system when a ground fault occurs at…

Q: 1.2_ Three phase short circuit could occurre with or without the ground, which one has a greater…

A: We need to tell which one has a greater current magnitude.

Q: Which among the following faults does mostly happen in 3-phase power systems? Single line to ground…

A: As 3 phase fault in power system are, 1. Single Line to Ground fault 2. Three phase short circuit 3.…

Q: 5.The most frequently occurring fault in electrical power systems is Immersive reader. A)…

A: There are two types of fault namely, Symmetrical faults Assymetical faults

Q: The negative sequence current of a solidly grounded generator for single line to ground fault is j…

A: Given that negative sequence current of SLG fault is Ia2 =j2.5 pu. Although for single line to…

Q: The fault current level of a circuit breaker used in a transmission line with phase voltage 2.2 kV…

A: Given Phase voltage = 2.2kv S = 80MVA FIND CURRENT

Q: Q3/A/ Fill in the blanks: 1. The most common type of 3-phase unsymmetrical fault is 2. In a balanced…

A: The solution is given below

Q: A 30 kv, 50 Hz, 50 MVA generator has the positive, negative, and zero sequence reactances of 0.25…

A: Evaluating the value of the fault current for the single line to ground fault:

Q: Q5: A SL-G fault occurs on the low voltage side of a transformer that connects a motor to a…

A: Given data for generator, Given data for motor,

Q: The fault current level of a circuit breaker used in a transmission line with phase voltage 4.6 kV…

A: Fault current level? of the breaking capacity 70MVA Voltages = 4.6kV

Q: The fault current level of a circuit breaker used in a transmission line with phase voltage 4.6 kV…

A: Given, phase voltage = 4.6kV Breaking capacity=40MVA fault current=?

Q: For three phase motor control the type of wire used for control wiring Select one: O 2.5 mm square,…

A: This question is related to Control wire size of the three phase motor.

Q: Find, for a symmetrical three-phase symmetrical three-phase fault at node 2 the values during the…

A: Motor load rating SM3ϕ=150kVApf=0.8 lagV2ph=3k3VV2ph=1kV Before fault,…

Q: Data obtained from a short circuit test on a 132 kV 3-phase circuit breaker with earthed neutral are…

A: Given power factor =0.3 k1=sin (cos-1(0.3)) =0.954 k2=0.75 k3=1 fn=1600 Hz

Q: In a power system the fault is occurred in all the lines and to the ground without fault impedance…

A: all the line and to the ground fault is symmetrical fault.

Q: The positive, negative and zero sequence reactances of a 15 MVA, 11 kV three-phase wye-connected…

A: In this question, We need to determine the fault current If if single line to ground fault…

Q: For the network shown in the figure below, all reactances are in p.u. to a base of 100MVA and 13.8…

A: The power system is a network consist of power generation, transmission, and distribution. Power…

Q: Please solve the following problems show a step by step solution. Use four decimal places. Use the…

Q: current and fault MVA, if a 3-phase fau

Q: The fault current level of a circuit breaker used in a transmission line with phase voltage 3.3 kV…

A: Given Phase voltage = 3.3kv S = 60 MVA FIND CURRENT

Q: When all the three conductors of a 3-phase line are brought together simultaneously into a…

A: The three conductors brought together simultaneously into a short circuit condition is called LLL…

Q: It is required to put resistance in neutral of alternator to control the fault current to rated line…

A: Given data, Positive sequency reactance = 0.3 pu Negative sequence reactance = 0.4 pu Zero sequence…

Q: Type of voltage control method which will reduce inductive reactance of the line is O booster…

A: In this question we will define which method reduce inductive reactance of line..

Q: Problem #2: A transformer is fed from a 100 MVA, 18 kV generator via a 5-cycle breaker. Generator…

A: Given S =100 MVA V =18 KV Xd'' =18%Xd' =25%Xd =120%

Q: In a short-circuit test on a 3-pole, 110 kV circuit breaker. Power factor of the fault= 0.4.…

Q: An unloaded star connected solidly grounded 10 MVA, 11 KV generator has positive, negative and zero…

Q: What will be the fault current for a line fault in single-phase 3-wire system shown below? Load (1)…

A: The system is given as Here, we can see that once a fault occurs, the load will be short-circuited.…

Q: In a short circuit test on 132 kV, 3-phase system, the breaker gives the following results: Power…

Q: A three phase fault is applied at the point P as shown in the figure. Find the critical clearing…

Q: Three 6.6 kV altenators of ratings 8 MVA, 2 MVA and 5 MVA have per unit reactances of O.16, 0.08 and…

A: Given:3, 6.6 kV alternator1st generator rating=8MVA, Xpuold1=0.16 pu2nd generator rating=2MVA,…

Q: The least common fault in 3-phase power systems is O Line to line fault O Three-phase short circuit…

Q: B-For the radial shown in the figure below, calculate: 1- the fault currents for the faults.: FA and…

Q: A 25 MVA, 11 kV, 3-phase, 60 Hz, generator has its neutral grounded through a 4% reactor. It is…

A: Given X1=20% X2=20% Xg0=8% Xn=4% MVA rating of generator=25 MVA Voltage rating =11kV

Q: A 30 transmission line operating at 33 KV and having resistance is connected to the and reactance of…

Q: The 60 mile, 115 kV line GH (Figure P12.8) is operating with the voltages at each end 30° out of…

Q: Question 6 Which of the following has the highest percentage of occurrence in a power networl L-L…

A: In this question , we will find which fault has highest percentage of occurrence...

Q: Q2\ Calculate the fault current for the given system if symmetrical three-phase fault occurs at…

Q: In a short circuit test on a 130 kV, 3 phase system, the breaker gave the following results: p.f. of…

Q: Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system?…

A: Solution: Single line to ground fault (SLG fault) is the fault that occurs in the transmission line…

Q: Single line to ground fault of a solidly grounded generator positive sequence current is j2.5 p.u,…

A: Choose the correct option Positive sequence current= j2. 5 puri Then current flow in neutral?

Q: The fault current level of a circuit breaker used in a transmission line with phase voltage 4.6 kV…

A: Breaking capacity=50MVA Phase voltage=4.6kV

Q: STRF = 6 MVA XTRF = % 3 UB / Uc = 36 kV/6 kV Generator A B C D KA XHCD = j 0,5 Ohm Kci Kc KB XHAB =…

A: Consider the Base MVA =4 MVA Base KV=36 KV

Q: Q: A three phase alternator 100 MVA, 13.5 KV, exposure to types of faults are fallowing: i) Balanced…

A: 3 phase fault current = 0.437 pu I3ϕ =EX10.437 =1X1X1 =10.437 =2.28 pu Line to Line fault current =…

Q: Due to the failure of circuit breaker the two phases of bus bar connected to generator are short…

A: If two phases of bus bar connected to generator are short circuited through fault impedance of j0.l…

Q: A 3-phase 33 kV, 37.5 MVA alternator is connected to a earth fault on one phase at the remote end.…

Q: The minimum size raceway for the following branch circuit conductors is: One, 10 AWG…

A: Raceway sizing The conduit and tubing size required for an installationdepends on following factors:…

Q: A three-phase fault with fault impedance of j 0.12 pu occurs at bus 2. Find the fault current and…

A: In this question we need to find a fault current and bus voltage during fault.

Q: QUESTION 1 A 100 km, 400 kV transmission line is subject to an “a" phase to earth fault at 80 km. If…

A: We can only provide the solution of one question in multiple type of questions. Here we can only…

Q: In a short circuit test on a 120 kV, 3 phase system, the breaker gave the following results: p.f. of…

A: We have an breaker with the following data, KV = 120 KV Power factor of fault = 0.6 Natural…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system?
Ic = 0
la = 0
b= 0
None of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Analyzing the question

VIEW

Step 2 Answer of the question

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Data obtained from a short circuit test on a 132 kV 3-phase circuit breaker with earthed neutral are as follows: -the power factor fault was 0.3. -the recovery voltage was 0.75 of the full line value. -the breaking current was symmetrical. -the restriking transient had a natural frequency of 1600 Hz. Estimate the rate rise of the recovery voltage. Assume that the fault is grounded.
In a short circuit test on 132 kV, 3-phase system, the breaker gives the following results: Power factor of the fault = 0.45. Recovery voltage 0.9 time of full line voltage. The breaking current is symmetrical. The restriking transient has a natural frequency of 15 kHz. Calculate the rate of rise of restriking voltage (RRRV) in the following types of faults: (1) Grounded fault (2) Undergrounded fault.
In a short-circuit test on a 3-pole, 220 kV circuit breaker. Power factor of the fault = 0.8 Recovery voltage, 1.90 times (full line voltage) The breaking current was symmetrical the restriking transient had a natural frequency of 30000 c/s. Determine the average rate of rise of restriking voltage. (The natural is grounded and the fault involves earth).
In a short-circuit test on a 3-pole, 110 kV circuit breaker. Power factor of the fault= 0.4. Recovery voltage= 0.95 times (full line voltage) The breaking current was symmetrical the restriking transient had a natural frequency of 15000 c/s. Determine the average rate of rise of restriking voltage. (The natural is grounded and the fault involves earth). Explain in details.
The fault current level of a circuit breaker used in a transmission line with phase voltage 2.2 kV and breaking capacity 60 MVA is ......................kA. Complete the answer.
A 25 MVA, 13.2 kV alternator with solidly grounded neutral has a subtransient reactance of 0.40 p.u. The negative and zero sequence reactances are 0.20 and 0.3 p.u. respectively. Find the fault current when, (i) A single line to ground fault occurs at the terminals of an unloaded alternator and (ii) ALL fault occurs.
IN A POWER SYSTEM WITH NEGLEBLE RESISTANCE , THE THREE PHASE FAULT CURRENT AT A POINT IS 8 PU . THE SERIES REACTANCE TO BE INSERTED AT THE FAULT POINT TO LIMIT THE SHORT CIRCUIT CURRENT TO 5 PU IS
9.The most severe fault in the power system is three phase fault . Select one?: O True O False
4. A 25 MVA, 11 kV, 3-phase, 60 Hz, generator has its neutral grounded through a 4% reactor. It is having isolated neutral. Each generator has X 1 = 20%, X 2 = 20% and X go = 8%. If a single line-to-ground fault occurs at the common busbars with the generators unloaded at rated voltage, thefault current will be
In a short circuit test on a 120 kV, 3 phase system, the breaker gave the following results: p.f. of fault 0.6, recovery voltage 0.9 times full line voltage, breaker current symmetrical, and restriking transient had a natural frequency 12 kHz. Determine average RRRV. Assume fault is grounded.
In which portion of the transmission system is the occurrence of faults more common a alternator B transformer C transmission line D underground cable
A generator rated 100 MVA, 20 kV has X1=X2=20% and X0 =5% Its neutral is grounded through reactor of 0.32 ohms. The generator is operating at rated voltage with load and is disconnected from the system when a single line to ground fault occurs at its terminals. Find the subtransient current in the faulted phase and line to line voltage.