Which of the following processes is best represented by the work-energy bar chart below? W+Q=AUint A rigid can of soda is placed into a refrigerator, where its temperature decreases. The system consists of the soda inside the can O Water is placed inside a high-powered blender, which increases the temperature of the water as it spins. The system consists of the water inside the blender. A balloon is placed into a refrigerator, where it deflates as its temperature decreases. The system consists of the air inside the balloon. Hot gas is placed inside a balloon, which expands as the temperature of the gas decreases. The system consists of the gas inside the balloon. +

Which of the following processes is best represented by the work-energy bar chart below? W+Q=AUint A rigid can of soda is placed into a refrigerator, where its temperature decreases. The system consists of the soda inside the can O Water is placed inside a high-powered blender, which increases the temperature of the water as it spins. The system consists of the water inside the blender. A balloon is placed into a refrigerator, where it deflates as its temperature decreases. The system consists of the air inside the balloon. Hot gas is placed inside a balloon, which expands as the temperature of the gas decreases. The system consists of the gas inside the balloon. +

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter9: Energy In Nonisolated Systems

Section9.7: Thermal Energy

Problem 9.5CE

See similar textbooks

Similar questions

Mountain climbers carry bottled oxygen when at very high altitudes. (a) Assuming that a mountain climber uses oxygen at twice the rate for climbing 116 stairs per minute (because of low air temperature and winds), calculate how many liters of oxygen a climber would need for 10.0 h of climbing. (These are liters at sea level.) Note that only 40% of the inhaled oxygen is utilized; the rest is exhaled. (b) How much useful work does the climber do if he and his equipment have a mass of 90.0 kg and he gains 1000 m of altitude? (c) What is his efficiency for the 10.0-h climb?
Energy that is not utilized for work or heat transfer is converted to the chemical energy of body fat containing about 39 kJ/g. How many grams of fat will you gain if you eat 10,000 kJ (about 2500 kcal) one day and do nothing but sit relaxed for 16.0 h and sleep for the other 8.00 h? Use data from Table 7.5 for the energy consumption rates of these activities.
Work done on a system puts energy into it Work done by a system removes energy from it Give an example for each statement.
Kanellos Kanellopoulos flew 119 km from Crete to Santorini, Greece, on April 23, 1988, in the Daedalus 88, an aircraft powered by a bicycle-type drive mechanism (see Figure 7.43). His useful power output for the 234-min trip was about 350 W. Using the efficiency for cycling from Table 7.2, calculate the food energy in kilojoules he metabolized during the flight. Figure 7.43 The Daedalus 88 in flight. (credit: NASA photo by Beasley)
A hydroelectric power facility (see Figure 7.38) converts the gravitational potential energy of water behind a dam to electric energy. (a) What is the gravitational potential energy relative to the generators of a lake of volume 50.0 km3(mass=5.001013Kg), given that the lake has an average height of 40.0 m above the generators? (b) Compare this with the energy stored in a 9-megaton fusion bomb. Figure 7.38 Hydroelectric facility (credit: Denis Belevich, Wikimedia Commons)
What is the efficiency of a subject on a treadmill who puts out work at the rate of 100 W while consuming oxygen at the rate of 2.00 L/min? (Hint: See Table 7.5.)
A 50.0-kg student evaluates a weight loss program by calculating the number of times she would need to climb a 12.0-m high flight of steps in order to lose one pound (0.45 kg) of fat. Metabolizing 1.00 kg of fat can release 3.77 107 J of chemical energy and the body can convert about 20.0% of this into mechanical energy. (The rest goes into internal energy.) (a) How much mechanical energy can the body produce from 0.450 kg of fat? (b) How many trips up the flight of steps are required for the student to lose 0.450 kg of fat? Ignore the relatively small amount of energy required to return down the stairs.
In Chapter 7, the work-kinetic energy theorem, W = K, was introduced. This equation states that work done on a system appears as a change in kinetic energy. It is a special-case equation, valid if there are no changes in any other type of energy such as potential or internal. Give two or three examples in which work is done on a system but the change in energy of the system is not a change in kinetic energy.
A 75-kg sprinter accelerates from rest to a speed of 11.0 m/s in 5.0 s. (a) Calculate the mechanical work done by the sprinter during this time. (b) Calculate the average power the sprinter must generate. (c) If the sprinter converts food energy to mechanical energy with an efficiency of 25%, at what average rate is he burning Calories? (d) What happens to the other 75% of the food energy being used?
Work done on a system puts energy into it. Work done by a system removes energy from it. Give an example for each statement.
Consider the energy transfers and transformations listed below in parts (a) through (e). For each part, (i) describe human-made devices designed to produce each of the energy transfers or transformations and, (ii) whenever possible, describe a natural process in which the energy transfer or transformation occurs. Give details to defend your choices, such as identifying the system and identifying other output energy if the device or natural process has limited efficiency. (a) Chemical potential energy transforms into internal energy. (b) Energy transferred by electrical transmission becomes gravitational potential energy. (c) Elastic potential energy transfers out of a system by heat. (d) Energy transferred by mechanical waves does work on a system. (e) Energy carried by electromagnetic waves becomes kinetic energy in a system.
Sewage at a certain pumping station is raised vertically by 5.49 m at the rate of 1 890 000 liters each day. The sewage, of density 1 050 kg/m3, enters and leaves the pump at atmospheric pressure and through pipes of equal diameter. (a) Find the output mechanical power of the lift station. (b) Assume an electric motor continuously operating with average power 5.90 kW runs the pump. Find its efficiency.