Which of the following statement is correct? O Discontinuities can propagate and become defects. O all discontinuities are defects. all defects will lead to failure if undetected: discontinuities can be harmless. O discontinuities are external natural boundaries only; defects are internal flaws originating from errors in processing.

Which of the following statement is correct? O Discontinuities can propagate and become defects. O all discontinuities are defects. all defects will lead to failure if undetected: discontinuities can be harmless. O discontinuities are external natural boundaries only; defects are internal flaws originating from errors in processing.

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter13: Flux Cored Arc Welding

Section: Chapter Questions

Problem 19R: What are the visual inspection standard's limitations of acceptance?

See similar textbooks

Similar questions

What is the purpose of an inspection plan?
How is the size of a flaw determined using ultrasonic inspection?
Do it accurate steps by steps explanation
Give proper and correct explanation
What process is used to verify that a manufactured part or hardware component conforms/follows the intent of the design and customer specification? HINT: The answer is one word - not an acronym.
Please provide detailed workings to the statements in the image explaining why it's true or false. Many thanks
No you are wrong, time is displament over velocity. Please do number 2 as well
Please show everything step by step in simplest form. Please provide the right answer exactly as per the Question. Please go through the Question very accurately.
20) 3.In property enhancing process, the shape of part is altered. Select one: True False
Problem 21.2. An inspector reports a total of 16 defects out of a total batch size of 200 parts. On closer examination, it is determined that three of these reported defects were in fact good pieces, while a total of seven defective units were undetected by the inspector. What is the inspector’s accuracy in this instance? Specifically, what are the values of p1 and p2? (b) What was the true fraction defect rate?
Please read the question carefully give me a right solution
Research and identify one type of geometric tolerances (besides obvious specs like length, distance, diameter, etc.) that can be called out on a technical drawing. Discuss a specific feature in a specific product/design case where calling out this geometric tolerance would be relevant for performance, assembly, or general operation.