Which of the following statements about Fixed length subnet mask (FLSM) is true? O a. Subnet mask is same for all the subnets O b. Subnetting is done multiple time depending upon requirement of hosts O c. Subnet mask may be different depending upon requirement of hosts O d. Used when the requirements for the hosts is different

Which of the following statements about Fixed length subnet mask (FLSM) is true? O a. Subnet mask is same for all the subnets O b. Subnetting is done multiple time depending upon requirement of hosts O c. Subnet mask may be different depending upon requirement of hosts O d. Used when the requirements for the hosts is different

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter8: Connecting To And Setting Up A Network

Section: Chapter Questions

Problem 2TC

See similar textbooks

Similar questions

Which two of the following hosts on a corporate intranet are on the same subnet? a.192.168.2.143255.255.255.0b.172.54.98.3255.255.0.0c.192.168.5.57255.255.255.0d.172.54.72.89255.255.0.0
Please answer all thefollowing two questions from the choosing the answer option. Thanks a lot in advance. 10) _______________A passive IDS can send an alart, but it is the network administrator's job to interpret the degree of the threat and to respond acfcordingly. Answer: True or False 13) Which of the following ACL configuration command on your router is correct for taking actions such that Only 120.3.6.7 has the right to access. Any other incoming packets from any other source will be blocked and denied any service. (Assuming that you can use any ACL name and any ACL number within the correct range. And using Basic-ACL Category) a) Rule is Deny source IP Address 10.3.65.7 configure a rule with ID 10 b) Rule is deny Source IP address 20.3.67, Configure the second rule without specifying an ID. c) Rule is permit source IP Address 120.3.67, Configure a rule with ID 20. d) All of the above
The command below illustrates the configuration of the static route. Router(config)# ip route network-address subnet-mask {ip-address | exit-intf [ip-address]} [distance] What is the function of the parameter distance in the given command? a. To assign bandwidth b. To assign matric value c. To assign AD value d. To assign protocol value
Which one of the following statements is FALSE? File Transfer Protocol (FTP) is a TCP service that operates on ports 20 and 21. Telnet is a TCP service that operates on port 23. Simple Network Management Protocol (SNMP) is a TCP service that operates on port 25. Dynamic Host Configuration Protocol (DHCP) is a TCP service that operates on port 80.
I NEED ONLY CORRECT OPTION NO NEED TO EXPLAIN IN DEPTH,PLEASE SOLVE ALL THE QUESTION, DON'T LEAVE ANY QUESTION AND IF YOU DON'T KNOW THE CORRECT ANSWER THEN PLEASE LEAVE IT OTHERWISE I WILL DOWNVOTE IT.... 1. Which of the following statements are correct?I. The User Datagram Protocol (UDP) is used for applications that requires constantdata flow.Il.The header size in Transmission Control Protocol (TCP is small when compared tothe header size of User Datagram Protocol (UDP).I!.The Transmission Control Protocol (TCP) is byte oriented.IV. The User Datagram Protocol (UDP) is used for routing.(a) I, II, and III only(b) II, Ill, and IV only(c) I, Ill, and IV only(d) I, Il, and IV only 2. Which of the following statements are true when the block size in a fixed block size filesystem is increased?1. disk throughput is increased2. disk throughput is decreased3. disk space utilization is increased4. disk space utilization is decreased 3. What is the output of below…
Write the commands to configure the interface FastEthernet0/0 with IP address 192.168.1.1 and subnet mask 255.255.255.0. Given that initially, the prompt is at user mode that is Router>. Show also the prompts. Giving detailed explanations.
Choose the correct option: You need to make 100 subnets, each with 1024 hosts. Which prefix mask would you use at the beginning before starting subnetting? A) /12 B) /14 C) /8 D) /15 E) /16 F) /18
which of the following statements is not correct regarding VPN tunneling? 1. A VPN tunnel is a virtual circuit between 2 VPN devices 2. Data transmitted in a VPN tunnel is encrypted 3. The destination IP address of an IP packet captured in a VPN tunnel should be the web sever that the user wants to access 4. a Layer 2 VPN device will encapsulate an entire Ethernet packet
Refer to the following dynamic NAT configuration. The router R1 has 2 interfaces with the following configurations: G0/0 – inside network – 10.1.1.1/24 S0/0/1 – outside network – 209.165.200.225/27 End users are complaining that they can not access the Internet and, as a network engineer, you have been asked by your manager to analyze the NAT configuration and fix the problem. What part of the configuration is most likely incorrect? How it can be fixed? R1(config)# ip nat pool nat-pool1 209.165.200.226 209.165.200.240 netmask 255.255.255.0 R1(config)# ip nat inside source list 1 pool nat-pool1 overload R1(config)#interface G0/0 R1(config-if)# ip address 10.1.1.1 255.255.255.0 R1(config-if)#ip nat inside R1(config)#interface S0/0/1 R1(config-if)# ip address 209.165.200.225 255.255.255.224 R1(config-if)#ip nat inside R1(config)#access-list 2 permit 10.1.1.0 0.0.0.255
Using tcpdump,read the packets from tcpdump.pcap and filter packets to include ip address 184.107.41.72 and port 80 only. Write these packets to a new file and md5sum that file. what is the md5sum shown?
Suppose you have created six subnets on a network that leases a group of Class C IPv4 addresses. What subnet mask must you specify in your clients’ configurations to adhere to your subnetting scheme?a. 255.255.255.6b. 255.255.255.128c. 255.255.255.192d. 255.255.255.224e. 255.255.255.0
For the given IP address 193.105.1.60/27, find the network address, First Address, Last address for the host, Broadcast address and next subnet address. please tery to anser in differnt way coz i dont same this answers to avoid plag try to do it in diffrent way with same answers Step 1 Given IP address 193.105.1.60/27 is a Class C address with CIDR /27 /27 means that the subnet mask is 255.255.255.224 Default subnet mask of Class C is /24 or 255.255.255.0 Here the CIDR is /27, so 3 bit subnetting is used, ie, 3- bit is borrowed from host part to network part. Number of hosts/subnetnetwork = 2m - 2, where m is the remaining bits in the host part, here m=5 =25 - 2=30 hosts Given IP 193.105.1.60/27 is in the network range 193.105.1.32 - 193.105.1.63 Step 2 Network address: It is the first address in the network range. So, 193.105.1.32 is the network address First Host address: It is the first valid host IP address which is…