Which of the following congestion control mechanisms is based on "probing for bandwidth" , i.e., it increases the transmission rate on the receipt of ACK, until eventually loss occurs; then it decreases the transmission rate?

Which of the following congestion control mechanisms is based on "probing for bandwidth" , i.e., it increases the transmission rate on the receipt of ACK, until eventually loss occurs; then it decreases the transmission rate?

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 8TC

See similar textbooks

Related questions

Q: Question 13 Which of the following actions correspond to SDN approach? A router exchanges messages…

A: Software-Defined Networking (SDN) is a method of network design that enables a network to be…

Q: Which of the following characteristics does UDP have? A. three-way hand shake for connection…

A: UDP stands for User Datagram protocal. It is a connection less protocal ( option B incorrect) No…

Q: [rdt3.0] Now suppose that the network with a data rate of R b/s can deliver out of order and that…

A: Reliable data transfer 3.0---------Channels with Errors and Loss Approach: sender waits…

Q: A smart modem can dial, hang up and answer incoming calls automatically. Can you tell who provides…

A: A smart modem can dial, hang up and answer incoming calls automatically. The provider for the…

Q: ____ is a non-proprietary FHRP protocol that provides mechanism for determining which router should…

A: The correct answer is : (a) Virtual Router Redundancy Protocol

Q: QUESTION 29 If all the links in the Internet were to provide reliable delivery service, the TCP…

A: Given : 1) If all the links in the Internet were to provide reliable delivery service, the TCP…

Q: Q1: Choose the correct answer of the following 1- Storage facilities are distributed across all…

A: The answer for the above question is given in the below step

Q: 7. Which of the following statements is true? TCP is generally faster than UDP. TCP does not care…

A: an explanation for 7: TCP is a connection-oriented protocol. It requires a logical connection to be…

Q: phase. Connection C,'s RTT is 50 msec and connection C,'s RTT is 100 msec. Assume that when the data…

A: Answer : The additive-increase/multiplicative-decrease (AIMD) algorithm is a feedback control…

Q: COMPUTER NETWORKS QUESTION : If two hosts start communicating using TCP Reno (with fast retransmit…

A: Actually, TCP stands Transmission Control Protocol.

Q: UDP provides congestion control and flow control True False…

A: I have given an answer in step 2.

Q: Match the protocol with the correct protocol description. Transport-layer protocol that provides…

A: The application layer and the transport layer both are parts of the TCP/IP model in computer…

Q: Following which statements are correct about DR/BDR routers in an OSPF area? DR/BDR is primarily…

A: In order to minimize the number of repetitions of the information that flows in the network, In an…

Q: Computer Science Suppose RTT is constant at 100ms, MSS = 1460, transmission rate is 1packet/ms, and…

A: Over here TCP tahoe algorithm given Whose initial phase is slows-start and and when its cwnd reaches…

Q: a) In Stop and wait protocol, sender wait for ACK before sending next packet. But what if an ACK is…

A: Multiple questions: Kindly, as per our guidelines, we are supposed to answer only one question.…

Q: Which type of connection is used to transmit two packets over a medium at the same time? A…

A: Synchronous and Asynchronous transmission are the two types of serial data transmission techniques…

Q: Question: Explain and differentiate the different mechanisms of TCP for congestion control such as…

A: It is defined as a connection-oriented session with one another. Connection establishment is…

Q: A TCP connection has been running for a long time and the value of cwnd = 22759. The MSS is the…

A: ans is given below step

Q: to be transmitted, and can only begin transmission at 4, 5, 6, 7) under round robin scheduling.…

A: Dear Student, The following steps are performed - Step 1: Using round robin scheduling, the packets…

Q: Which one is not taken into consideration while calculating the end-to-end-delay ?. A propagation…

A: End-to-end-delay or one-way delay is the time taken for a packet to be transmitted across a network…

Q: If a host is monitored, and there are six TCP packets captured: {S1, E1, S2, E2,S3, E3}, where Si…

A: TCP follows Connection Oriented approach and all the packets will reach in same order

Q: Configure the Static Route and make sure every pc is reachable .. (Sir i need the working in file of…

A: Actually, a packet is a small segment of a larger message.

Q: b) SLTP is a new transport protocol that runs over UDP. Including the Interframe gap, calculate the…

A: b) SLTP is a new transport protocol that runs over UDP. Including the Interframe gap,calculate the…

Q: the TCP Tahoe configuration network is used, why packet losses during the beginning of the…

A: INTRODUCTION: Why are packet losses during the beginning of transmission larger than during the…

Q: Based on the description given above, ELABORATE your answer from the questions below: a) EXPLAIN any…

A: Q. Datagram Congestion Control Protocol (DCCP) is a connection-oriented protocol which works as a…

Q: MCQ: Which of the following is a better solution to defend DoS attack in a network? a. Packet…

A: Better solution to defend DoS attack in a network

Q: Network congestion is manifested by which of the following? a. packet loss caused by buffer…

A: Network gets congested when the traffic gets too much on the network.

Q: nd there are seven TCP packets captured: {S1, S2, S3, S4, S5, S6, E1}, where Si represents ith Send…

A: Echo protocol is used to measure round trip time of all packets. It maybe used separately for…

Q: Which of the following is true about the concern of “Taking turns” MAC (Medium Access Control)…

A: “Taking turns” MAC (Medium Access Control) protocols: Control token passed from one node to next…

Q: Which of the following characteristics associated with TCP is false? a. Carries larger overhead b.…

A: The header format of TCP includes header size. The size of header is 20 bytes. Thus the header…

Q: 11. In TCP, _ will not be acknowledged. A. Segment with SYN flag on B. Segment with FIN flag on C.…

A: Lets see the solution in the next steps

Q: In packet tracer application, which of the following is used to view the last command applied in…

A: Note: This is a multiple-question-based problem. As per company guidelines, only the first question…

Q: ***** When the load is greater than the capacity, the delay.. b. Increases linearly c. Goes to…

A: 1) C option is correct that is: Goes to infinity Explanation: Packets become blocked at nodes when…

Q: at 101 XY system uses "Selective Reject" to control errors. Let us assume host A has Q# 1:…

A: Selective reject protocol allow a receiver to reject a frame selectively and sender resends only…

Q: Which TCP/IP protocol, which handles and assures the delivery of packets, provides this guarantee?…

A: In Internet for interconnecting network devices TCP/IP protocol are used.

Q: Which task is performed by the dynamic routing protocols? * a. discover end devices b. update…

A: As networks increase in size and complexity, using a dynamic routing protocol to provide network…

Q: Which of the following is not true about Port Scanning? a. It identifies the version of particular…

A: Answer b. It determines the type of operating system of the target system.

Q: Which transmission technique guarantees that data packets will be received by the receiver in the…

A: here in this question we have asked that the transmission technique that guarantees the data…

Q: Using vlsm, subnet the network 192.168.42.0/24, there are 3 departments, ensure there’s enough…

A: The given IP address is 192.168.42.0/24 /24 means number of network bits is 24 and therefore number…

Q: Which answers below make the two IPs part of the same network and can communicate with each other…

A: 192.168.15.15 = 1100 0000.1010 1000.0000 1111.0000 1111192.168.16.15 = 1100 0000.1010 1000.0001…

Q: Which of the following are easy/difficult to handle in Virtual-Circuit and Datagram subnets, and…

A: Answer :- ISSUES DATAGRAM SUBNET VIRTUAL CIRCUIT SUBNET Router…

Q: Assume that a new TCP connection starts by sending 1 segment, and then increases it congestion…

A: Here in this question we have we have a tcp connection in which initially we have sent 1 segment and…

Q: When host A receives a TCP segment from host B, the values of the advertised window and the window…

A: TCP: It is used for organizing data in a way that ensures the secure transmission between the…

Q: Suppose that a TCP source (with unlimited amount of information to transmit) begins transmitting…

A: One source. We make the following assumptions:1. The receiver's advertised window is large enough…

Q: Host X transmits data to Host Y using the Go Back N protocol. If X has a timeout on frame 4 after…

A: Note:-As per policy we have entitled to answer First Question Step 1:- Go Back N:- Go Back N…

Q: Which of the following are important distinctions between TCP and UDP transport protocols? O TCP…

A: Let us see the answer: "Since you have asked multiple question I am solving first one for you if you…

Q: Which is an indication of a worse state of the network, the sender experiencing timeouts or the…

A: In the data transmission between the sender and the receiver, The timeouts are experienced by the…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

a. Traffic Throttling

b. Traffic-Aware Routing

c. TCP Congestion Control

d. Admission Control

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

THINKING CRITICALLY Which of the following hosts on a corporate intranet are on the same subnet? a. b. c. d.
Which two of the following hosts on a corporate intranet are on the same subnet? a.192.168.2.143255.255.255.0b.172.54.98.3255.255.0.0c.192.168.5.57255.255.255.0d.172.54.72.89255.255.0.0
Which of the following TCP congestion control mechanism defines only a linear growth rate in the number of segments sent to the receiver? BIC Congestion Avoidance Reno TCP Slow Start Taho TCP
After a timeout occurrence, we talked about doubling the timeout interval. Congestion control is achieved by the use of this method. Why does TCP require a window-based congestion-control method in addition to the doubling-timeoutinterval strategy?
Given evolution of TCP's congestion window, provide following: a. List the times, at which TCP is in slow start, congestion avoidance and fast recovery states. b. List the times, at which the first packet in the sent flight of packets is lost and indicate whether the packet loss is detected via timeout, or by triple duplicate ACKs. c. List the times at which the value of ssthresh changes and provide the new value of ssthresh.
We contemplated raising the timeout period after one of our users had a timeout. This is a method of reducing traffic congestion. In addition to the strategy of increasing the timeout period, why does TCP need a congestion-control mechanism based on windows?
Which of the following statements could be valid with respect to the ICMP (Internet Control Message Protocol)? a. It reports all errors which occur during transmission. b. A redirect message is used when a router notices that a packet seems to have been routed wrongly. c. It informs routers when an incorrect path has been taken. d. The "destination unreachable" type message is used when a router cannot locate the destination.
A. During which of the following intervals of time is TCP performing slow start*?B. During which of the following intervals of time is TCP performing congestion avoidance C. At the end of which unit(s) of time does TCP detect a loss via timeout
Network congestion is manifested by which of the following? a. packet loss caused by buffer overflow at routers b. high bit error rate c. long propagation delay d. None of the above