Configure the Static Route and make sure every pc is reachable .. (Sir i need the working in file of packet tracer softwar

Q: Classify each of the following as a property of TCP or UDP protocols No. Property protocol 1 It…

A: I have provided a solution in step2.

Q: Which of the following characteristics does UDP have? A. three-way hand shake for connection…

A: UDP stands for User Datagram protocal. It is a connection less protocal ( option B incorrect) No…

Q: Total latency is equal to a summation of network delay contributors such as frame transmission time,…

A: Below is the answer to above question. I hope this will helpful for you..

Q: Perform a configuration of SSH in Cisco Packet Tracer. Note : Share all screenshot while performing…

A: Asked: Perform a configuration of SSH in Cisco Packet Tracer.

Q: a- Given the following screenshot, some errors are preventing PC-C from accessing the Redundant…

A: Introduction: In part a we are provided with few lines of code and we have to remove errors from it.…

Q: Moving to the next question prevents changes to this answer. 06 Question 5 Save Amer Suppose that a…

A:

Q: n UDP the datagram contains the source and destination IP address and the source and destination…

A: Answer : False.

Q: Given the following topology of a network (see photo,) the router Node 3 connects the two subnets…

A: ANSWER:-

Q: Total latency is equal to a summation of network delay contributors such as frame transmission time,…

A: The answer is..

Q: Total latency is equal to a summation of network delay contributors such as frame transmission time,…

A: The answer is...

Q: XY system uses “Selective Reject” to control errors. Let us assume host A has established a…

A: Selective Repeat Protocol (SRP) :This protocol(SRP) is mostly identical to GBN protocol, except that…

Q: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 & 192.166.10.0 to…

A: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 &…

Q: a.Using a cisco packet tracer Connect 3 computers to a switch, and router and configure statically…

A: Computer Networks is the set of the computers which are connected by the transmission medium either…

Q: A. An IPv4 packet arrives with a fragmentation offset of 0 and M bit of 0. Comment on the…

A: A.About the fragmentation of the packet and B. The original packet was fragmented or not

Q: Draw a NAT Table Entry at the Router for the Computer (A) (shown with a smiley face J) trying to…

A: The above question is solved in step 2:-

Q: XY system uses "selective reject " to control errors. let us assume host A has established a…

A: Selective reject protocol allow a receiver to reject a frame selectively and sender resends only…

Q: 45. Which of the following protocols is an application layer protocol that establishes, manages and…

A: 45. Which of the following protocols is an application layer protocol that establishes, manages and…

Q: what is hexadecimal values for the source and destination address in the Ethernet frame containing…

A: Given: what are hexadecimal values for the source and destination address in the Ethernet frame…

Q: Edit TCP Wrappers access control files as appropriate and allow user1 and user3 from 192.168.1 and…

A: 1. To allow user1 and user 3 from the 192.168.1 and example.net to access vsftpd : # vi…

Q: Total latency is equal to a summation of network delay contributors such as frame transmission time,…

A: The answer is

Q: Q. Assume the two packets arrive at about the same time at two separate router input ports. Often…

A: Q. Assume the two packets arrive at about the same time at two separate router input ports. Often…

Q: After establishing a connection with the local DNS server PC1 now knows the IP and MAC addresses of…

A: solution :As we already know that ARP is a broadcast protocol in which ARP packet is broadcasted all…

Q: Total latency is equal to a summation of network delay contributors such as frame transmission time,…

A: The answer is...

Q: How can an Ethernet frame with a Length of 42 bytes be recorded in the packet trace? Why does it not…

A: The padding of the ethernet frame is completed on the NIC of the system. The capturing of packets is…

Q: A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of…

A: Answer: a. 5h/(5h+M)

Q: Is it possible for a router to direct packets to MAC addresses? If your response is YES, please…

A: Yes, a router direct packets to the MAC addresses The router contains forwarding table which…

Q: layer(s) are involved in encrypting the data of a packet? Which address(es) does not change at each…

A: The seven layers of the OSI model have their own functionalities and concerned properties. A data…

Q: Host A sends a huge TCP link to Host B. The amount of unrecognized bytes A sends cannot surpass the…

A: Host A sends a huge TCP link to Host B. The amount of unrecognized bytes A sends cannot surpass the…

Q: Timeout period ---> RTT for the retransmitted packet. why? explain briefly.

A: 1.RTT TIMEOUT: RTT ( Round Trip Time) is an important metric in determining the health of a…

Q: Which of the following statements is true about routing functions? A router uses network addresses…

A: Routers On computer networks, a router receives and transmits data. Occasionally, network hubs,…

Q: Below you can see access-list number 1 has 3 statements, number 10, 20 and 30. Whenever a packet…

A: Answer: Given access list and what will happen if new packets arrived and match with statement. So…

Q: the terms for the addresses: inside global, inside local, outside local, and outside global. Provide…

A: (i).inside global, inside local, outside local, and outside global

Q: What information is used by a typical packet-filtering router? What are the flaws of a router…

A: Introduction: What information is used by a typical packet-filtering router? What are the…

Q: a- Given the following screenshot, some errors are preventing PC-C from accessing the Redundant…

A: Introduction: In part a we are provided with few lines of code and we have to remove errors from it.…

Q: In NAT, users in the same local network have internally the same IP addresses and they are…

A: Network address transalation  basically searches the translation table based on the destination port…

Q: Which layer of the ISO/OSI Reference Model performs encryption or compression for a communications…

A: The answer:

Q: Assuming that all routers and hosts are working properly and that all software in both is free of…

A:

Q: Explain : An attacker is sending packets with URG flag set to the target to scan the status of the…

A: Ans:) URG flag stands for the URGENT flag, which when set the data present in the segment will…

Q: Should DHCP be used to set up server ip? True False     QUESTION 17 RSA is a public cryptography…

A: NOTE: SINCE THE QUESTION IS MULTIPART WE ARE ADVISED TO DO ONLY FIRST THREE PARTS: 1. The statement…

Q: 16) a layer 4 connection, what action should a system take if it receives a synchronize packet?…

A: In this question we need to find that if a system receives a synchronize packet in layer 4…

Q: DNS employs UDP over TCP. No automatic recovery if a DNS packet is missed. Is this a problem, and if…

A: DNS uses UDP rather than TCP because UDP is faster. Due to three-way handshake, TCP is slower. DNS…

Q: In NAT, users in the same local network have internally the same IP addresses and they are…

A: Network Address Translation (NAT) is a method of representing an entire group of computers with a…

Q: Write the command to force the HSRP protocol to conduct a re-election process when a router with…

A: Hot Standby Router Protocol (HSRP) A large class of legacy host of implementations that don't…

Q: what is hexadecimal values for the source and destination address in the Ethernet frame containing…

A: Given:- what is hexadecimal values for the source and destination address in the Ethernet frame…

Q: Assume a computer transmits a packet via the Internet's transport layer to another computer. At the…

A: At the transport layer, the question is about exchanging packets between two computers. A package is…

Q: Enable OSPF on the routers in the provided Packet Tracer file as follows: • All three routers use…

A: As a link-state protocol, OSPF is designed to not only find the fastest available route, it is…

Q: An IP address can be separated into parts. What are these parts? 1. Network ID and Host ID O II.…

A: The IP has two parts: 1)Network ID 2)Host ID example for IP address is: 192.168.32.170 192.168.32 is…

Q: a- Given the following screenshot, some errors are preventing PC-C from accessing the Redundant…

A: Router0(config-router)#ip route 0.0.0.0.0.0.0.0.209.0.0.1Router0(config)#router rip…

Linux

An operating system (OS) is the software which manages hardware and resources, like CPU, storage and memory. The OS bridges the applications and hardware and makes the connections between all of your software and the hardware resources.