Which type of lines is implemented when authorities prohibit the use of Overhead Lines for general welfare and safety of the population? OA. OVERHEAD TRANSMISSION LINES O B. OVERHEAD DISTRIBUTION LINES O C. UNDERWATER TRANSMISSION LINES D. UNDERGROUND DISTRIBUTION LINES

Which type of lines is implemented when authorities prohibit the use of Overhead Lines for general welfare and safety of the population? OA. OVERHEAD TRANSMISSION LINES O B. OVERHEAD DISTRIBUTION LINES O C. UNDERWATER TRANSMISSION LINES D. UNDERGROUND DISTRIBUTION LINES

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 10R

See similar textbooks

Related questions

Q: The time interval needed for a surge to travel to the end of a 600 km long overhead transmission…

A: Given, Length of overhead transmission line, l = 600 km Surge travel at a speed of light = 3×108 ms

Q: What is The effect of increasing VS in power transmission line performance study?

A: Let a power transmission system, where Vs is sending end voltage Vr is receiving end voltage I is…

Q: 1.8 In the systems shown in Figure 1.21a and b, it is desired to achieve overlap between the zones…

A: Although switching unit of dead tank breaker is installed inside a metal box and earthing is…

Q: How ring main distribution network is different than radial systems?

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: Power system requires transmission of power from generation end to the consumer end. The power…

Q: Loop or ring type distribution system is the highest reliable and service continuity system True…

A: In this question we will write about ring type distribution system reliability...

Q: How does rise in voltage at the receiving end of an open circuited line depend upon the length of…

A: Given:-

Q: . Why in medium and long transmission lines, regulation is greater than voltage drop?

A: There are three types of transmission lines on basis of the distance of transmission: Short…

Q: 1. Draw the equivalent circuit of any transmission line, indicating all voltages, currents, and…

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: The bulk transportation of electrical energy from a generating station to a substation is known as…

Q: What are the maximum and the minimum value of VSWR of transmission line?

A: VSWR stands for Voltage Standing Wave Ratio. It is a function of reflection coefficient and it can…

Q: A)Ibc =? find the load current=?…

A: A)Ibc =? find the load current=? B)Vca calculate the line voltage =? C)Calculate the total complex…

Q: Explain the following terms in the distribution system 1) maximum demand, 2) coincident demand, 3)…

Q: 1) write down the factors considered for selection of conductor for overhead LT distribution line.

A: We have to write the factors considered for selection of conductor for overhead LT(Line…

Q: How many distance measuring units will be required for the complete three stepped protection of a…

Q: What is the necessary condition for matching transmission lines? In addition, what is a micro strip…

A: necessary condition for matching transmission line micro strip line

Q: State the factors affecting the sag in a transmission line? What is the chief argument that favours…

A: The vertical distance between the point where the line joins the tower and the lowest point on the…

Q: - The figure below shows the structure of which busbar? If CBF has occurred, please explain how many…

Q: QUESTION: Explain or describe or define in your own words and your own understanding, without…

A: Bundled Conductors for transmission lines: Sometimes, for certain advantages, the transmission lines…

Q: Give the reason of acharging current is exiting in a line even when line is open circuited at the…

A: In a transmission line, air acts as a dielectric medium between the conductors. When the voltage is…

Q: Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings?…

A: According to the question we need to Identify and Identify and describe the step-by-step process…

Q: It is not possible to locate electrical equipment in less-hazardous areas, or in nonhazardous…

A: Hazardous sites are defined in electrical and safety engineering as places where there is a risk of…

Q: Explain Basic Trip Circuit in Transmission line? Also, Discuss the Fundamental Requirements of…

A: Protection refers necessary isolationof healthy system from faultysystem, so that fault can not…

Q: Differentiate the Double Breaker Bus System vs. Double Bus System. Which do you think is more…

A: Double Breaker Bus System : A double breaker bus system consist of two breaker and two buses for…

Q: 8. How do the terms ‘impedance drop’, ‘voltage drop’ and ‘voltage regulation’, in connection of…

A: Impedance drop: Impedance drop is the product of the current and the internal impedance. The…

Q: evaluate the size of conductor for overhead transmission lines

A: In the past, copper was frequently used as a conductor for transmission lines, but aluminum…

Q: 10. Which type of transmission technique is employed by paging system?

A: The correct option along with the explanation is provided in the following section.

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: What is meant by Thicknet and thinnet? What is the difference in between both types? Note: Please do…

A: Ethernet based LANs using thick cable for inter-connection is called Thicknet. While ethernet…

Q: How does rise in voltage at the receiving end of an open circuited line depend upon the length of…

A: Given:-

Q: For underground and underwater transmission, why are line losses for HVDC cables lower than those of…

A: As per Bartleby guidelines we are allowed to solve only one question, since these parts are…

Q: Overhead Transmission Lines are preferred for Transmission of Power for Long Distances, why? Note…

A: The explanation is as follows.

Q: 3. What are the causes of voltage drop and line losses in a transmission line?

A: Line voltage drop occurs due to Voltage drop in line resistance Voltage drop in line inductive…

Q: 6. Which type of transmission technique is employed by paging system?

A: The solution is provided in the following section.

Q: 2) Write down the specification and types of insulators used in transmission line

A: The electrical insulator is a device that provides the required insulation between the line…

Q: a. What is communications system's main equipment? Write and explain with short sentences.

A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: 1-Draw the structure of single bus bar system

A: In this question we will draw structure of single bus bar system.... Note:- as per our guidelines, I…

Q: of a bus bu

A: Given: The answer is shown as:

Q: Briefly discuss the loaded and non-loaded telephone cables

A: Loading is the process to increase inductance of line by adding lumped inductors atpredefined…

Q: What is the box fill volume allowance for each conductor originating outside and terminating inside…

A: We need to answer what is the box fill volume allowance for each conductor originating outside and…

Q: Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings

A: according to question, Identify and describe the step-by-step process used to install cable in the…

Q: Estimate and costing for installing 11KV transmission line

A: 11kV Transmission Line:- The local transformers, which distribute power to the nearby buildings, are…

Q: Birds are known to perch on 2300V bare transmission line without apparent harm. Explain the reason…

A: The electricity to flow through ,it needs the closed loop and a voltage difference across the…

Q: Calculate the Reactance of the Line, Current flowing through the transmission line, Sending end…

Q: Explain why the low voltage problem at higher loading is more severe in an uncompensated over-head…

Q: Is it advisable to use Multi-pair punch in terminating cables in patch panels? Why?

A: Patch panel: It is a local area network (LAN) that is a mounted equipment gathering that contains…

Q: The copper line with a total length of 20 meters operates in the 220 volt city network. If three…

Question

Which type of lines is implemented when authorities
prohibit the use of Overhead Lines for general
welfare and safety of the population?
O A. OVERHEAD TRANSMISSION LINES
OB. OVERHEAD DISTRIBUTION LINES
O C. UNDERWATER TRANSMISSION LINES
O D. UNDERGROUND DISTRIBUTION LINES
1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please answer the question full sentence 5. Identify the minimum distance requirements between network cables and power sources and identify types and location for cable supports.
Construct a complete electrical plan layout of a residential type building which includes floor plans, lighting layout, power layout and load schedule.
An overhead transmission line has a span of 250 m and the weight of the line conductor is 0.68 kg per metre. Also the maximum allowable tension in the line is 1510 kg. Calculate the maximum sag and calculate the height above ground at which the conductor should be supported. Assume ground clearance required is 10 metre.
In your own words and from your own understanding, avoid plagiarism or copying from the Course Material, distinguish DIRECT BURIAL, TROUGH, and TUNNEL for UNDERGROUND POWER SYSTEMS.
Take a look at the wire supplying your house, another residential house, commercial and industrial buildings in your locality, count how many wires are connected to the building (from the electric meter to the weather head OR the service drop itself)? Are the wires different from each other? If so, why?
What is the width for 125 ohm microstrip transmission line design?
Subject: Electrical & Electronics Engineering Course: Power Systems Question: In case of modeling a Long Transmission Line, what are the available procedures? Which one is the best and why? Explain.
How does rise in voltage at the receiving end of an open circuited line depend upon the length of the line and system operating voltage? Subject Power Transmission and Distribution
2. How do you classify transmission lines?
Hello please I need the wiring diagram of a three phase transmission line system
The Voltage Regulation of a Transmission Line should be _____? A. very high percentage. B. more than 100%. C. zero or nil D. as low as possible.
Differentiate the Double Breaker Bus System vs. Double Bus System. Which do you think is more suitable to have a more reliable power supply?