With frequency f= 500 cycles/sec, what is the pure element in series with the R=25 ohms which causes the current to lags the voltage by 20 deg?

Q: A parabolic dish antenna has a conical beam 20° wide, Find the directivity of the anten

A:

Q: A 230 V, 250 RPM, 100 A Seperatly excited DC motor having r(a) = 0.50, is connected to a 230 V…

A:

Q: A camera with a focal length of 20 cm fitted in an aircraft is used for taking vertical aerial…

A: Given,Focal length, fl=20 cmAverage elevation, E=1200 mScale, S=1:8000

Q: A 1 km long microwave link uses two antennas each having 30 dB gain. If the power transmitted by one…

A: Given: Link distance between two antennas: R=1 Km=1000 mEach antenna gain: Gt=Gr=30 dBPower…

Q: 6) Find the Fourier transform of the figure given below. 10 sin 1 R

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: In a T connection, how much is it preferred for the teaser transformer to contain?

A:

Q: A very lossy, long, 50 transmission line is open circuited at the load end. Find the input impedance…

A:

Q: Plane z = 10 m carries surface charge density 20 nC/m². What is the electric filed at the origin?…

A: Given: Plane z = 10 m Carries surface charge density, ρs=20 nCm2

Q: 1- Consider a PCM system for a sinusoidal signal 2 cos2 2000t. It is desired to represent this…

A: The given data are: The message signal is given as: mt=2cos2π2000t=Vmcos2πfmt where Vm is the…

Q: 4. Consider the following circuit as a fun puzzle³. Each resistor has 40 of resistance and each…

A: 4.

Q: What in the 24 VT ILZ 5000 22 What is the cha What is the not 80mF en oos alter we close the switch?…

A:

Q: 24 V For the following circuit, R1 ww 5002 $1 R3 www 50 Ω C1 90 mF R2 ww 500 S2 a. With Switch 1…

A:

Q: In the RLC circuit shown below, determine VR1 and VL1 when VC1 =4e-3000(t) Hint: See file "EET111…

A:

Q: A motor generator set used for providing variable frequency AC supply consist of a three-phase,…

A: Given- A motor-generator set- 3 phase, 10 pole synchronous motor, 24-pole, 3 phase synchronous…

Q: Q3: find the current through the 48ohm resistor in the circuit and assume the diode is silicon diode…

A:

Q: 8√ 1+ 252 M +√3 - + V₁ + عما 452 M V₂ Find V₁, V₂ x V₂. - pol

A: We need to find out the voltage for given circuit by using of KVL and KCL .

Q: R(s) +

A:

Q: Write a MATLAB program to plot the signals: a. 8(n-1) b. u(n-1) c. x(n)= exp (0.2n) 3mm d. x(n) =…

A: Given, a) X1(n) = delta(n-1) b) X2(n) = u(n-1) c) X3(n) = exp(0.2n) d) x4(n) = sin(3πn/5) We need to…

Q: 75V 5 ΚΩ 10 ΚΩ 10 ΚΩ (t) + v(t) —— 40nFS 40 ΚΩ a b = 1100 V

A: We need to find out the voltage across capacitor and current through resistor .

Q: Problem 1. Determine the stability of a system represented by the following transfer function: s+8…

A:

Q: R₁ R www R R Luv. www R₂ R.

A:

Q: Use the Karnaugh map to minimize the two equations below.  a. F1= CAB+BC’

A:

Q: H.W 4: Calculate the error constants and determine ess for a unit step, ramp and parabolic functions…

A:

Q: Determine the instantaneous and effective voltage of the series RC circuit as shown below with the…

A:

Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…

A:

Q: + 5. ¹? R し、

A:

Q: Vm= 18 sin (27 ft) 3 O {2x when 0 - Vo • For what values of Vin is 10 OFF? •When Dis off, what is…

A:

Q: تو R ш √₁=&v V₂=3v Vo

A: Assume diode is ideal i,e  If diode is reverse bias then it is replaced by open circuit and if it is…

Q: D) Minimize F = A' + ABC + A(B+C) + AB'C' by algebraic manipulations

A: b) The given expression is,  F=A'+ABC+AB⊕C+AB'C' On simplifying the above expression by implementing…

Q: 4. Explain if any of the two fields aescnoca by the expressions below can describe an electrostatic…

A:

Q: 5. A 400 volts shunt generator has a full-l

A:

Q: R E K1 F(s) + + G(s) K2 ... Y

A:

Q: H.W 3: Find the steady-state errors for inputs of 5u(t), 5tu(t), and 5t²u(t) by first evaluating the…

A: Given diagram:- ess = ? K = ?

Q: A very lossy, long, 50 transmission line is open circuited at the load end. Find the input impedance…

A:

Q: The average value of the sawtooth waveform with v()t) = Vm T (limits from 0 to T) is OVm T 0.5 Vm T…

A:

Q: Problem 02: A three phase transmission line is made up of aluminum conductor wires 80 km long. Find…

A: Length of conductor is L = 80 km = 80×103 mDiameter of conductor d = 480 milesRadius of conductor is…

Q: 2. For the circuit shown below, find the current ip and voltage V1. Assume the forward bias voltage…

A: The diode conduction state can be calculated by finding the value of voltage across diode and based…

Q: Question 1: If the current is 1.07 mA at an applied voltage of 606 mV, and the current is 4.05 mA at…

A: Given, The currents, I1=1.07 mAI2=4.05 mA The voltages,  V1=606 mVV2=640 mV The value of thermal…

Q: 5. A 400 volts shunt generator has a full-load current of 200 A. Its armature resistance is 0.06…

A:

Q: What is the difference between a open-clamp voltage and the short-circuit current. When do you use…

A: An electric circuit connects the system with electric current and to consume current we use to add…

Q: Is 28V +1 +51 ww RI 12 Kn Iz R₂ 12 Kn R3 3kR gkr M RY PS 6kR MI +V5² . Іь 10.6 R6 KR Find currents…

A: Given, The circuit diagram,

Q: A 220-V d.c. machine has an armature resistance of 0.5 . If the full-load armature current is 20 A,…

A: Voltage V = 220 V Armature resistance Ra = 0.5 Ω Armature current Ia = 20 A

Q: Solve for the transfer function, G₂ (s) c (t) = 3 (1+2e-²t); r(t) = 2 = C(s) R(s) if:

A:

Q: Question 3: If we assume the reverse current is -99 pA, the built-in voltage is 0.64 V, and the…

A: Given data, Reverse Current IRC1=-99 pA Built-in-voltage IBV=0.64 V Applied voltage Va=-26 V

Q: Find Va 12 V | Μ ΖΩ ΖΩ 2· Va Va ΖΩ

A:

Q: An ammeter has an f.s.d. of 100 mA and a resistance of 50 ohms. The ammeter measures the current in…

A: f.s.d = 100 mA Resistance Ra = 50 Ω Load resistance R = 500 Ω Voltage V = 10 V

Q: Plane x = 10 carries a current of 100mA/malong ā while line x = 1, y = -2 carries a filamentary…

A: It is given that: plane x=10 carries a current of 100 mAm along ayline x=1,y=-2 carries a…

Q: Given that vs = 8 V. NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: We need to find out the voltage across capacitor in resistor capacitor circuit.

Q: 2- Which of the following sequences cannot be a valid Auto Correlation Sequence (ACS)? For each…

A: Given,  We need to tell the auto correlation functions given above.

Q: 3 Find the power factor of the source and us(t) in Fig. E9.19 if f = 60 Hz.

A:

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.