A voltage waveform given by 70.1 Sin 108.72t is applied across a resistor of 98.71 ohms.What power is dissipated in resistor?

Q: What is the Carnot efficiency of a typical geothermal plant and its power capacity in MW? The…

A: Given in the question: The average temperature is: TAVG = 210 C Ambient temperature is: TAMB = 880C.…

Q: A light source producing 1500 candela is suspended 2.2m above a horizontal surface. Calculate the…

A: We have given an light source of , Luminous Intensity = 1500 Candela We have been asked to find…

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A:

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when…

A:

Q: Consider the following waveform. Volts 4 18 12 t (sec)

A: Given waveform  shown

Q: 11 The following diagram shows an analogue waveform that is powering a device. If the power rating…

A:

Q: A coffeemaker has a rated power of 1,000W at 240 V rms. Find the resistance of the heating element.

A: Let P be the rated power of the coffeemaker, V be the RMS voltage across heat, R be the resistance…

Q: Calculate the electric field intensity in millivolts per meter (mV/m) at 30kW from a 5 km source.…

A:

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: Given Data: P = 90 kW V = 480 V rms I = 260 A rms

Q: Calculate for the value of VL(peak). Please show your complete solution. Thank you.

A:

Q: a voltage waveform is shown below, where Vmax and Vmin are the maximum and minimum voltage values.…

A:

Q: Calculate the conductivity of intrinsic Si at 27oC and write your answer in 1/(Ω.m).

A:

Q: Q6/An air conditioner removes heat steadily from a house at a rate of 750 kJ/min while drawing…

A:

Q: ) A heater with resistance 10 N is driven by an AC voltage source (120 V). For the circuit shown…

A: As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q: The value of the total charge entering a circuit terminal is given as Q=5 sin(30t) C What will be…

A: The value of the total charge entering a circuit terminal is given as Q=5 sin(30t) C What will be…

Q: A constant current of 2.8 A exists in a resistor. The rms value of current is A.

A: Given: In a resistor the constant current is I=2.8 A

Q: a midday if the instantaneous irradiation is 800 W/m2? this power is focused in a small area of S cm…

A: Given,   Radiation =R =800 W/m2 dish (concentrator) diameter d1=10 m receiver area diameter d2 =5 cm…

Q: ii, The electric current flowing in a resistor is given by 1= 20 sin(100t) where I is in Amperes…

A:

Q: The value of the total charge entering a circuit terminal is given as Q=5 sin(30t) C What will be…

A:

Q: If the skin temperature is 310 K and area of the human surface is approximately 1.8m2 then the power…

A: For the given skin temperature and area we need to compute power radiated from the surface of the…

Q: A microwave operating at 120v has a resistance of 50kohms. How much power does the microwave consume

A: According to the question we have to find the value of power consumed.

Q: Electrical conductivity increases with increasing temperature. TRUE FALSE

A: Correct option is False Why because, for a given conductor, if temperature increases , There is…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 61 ohms R2 = 31…

A:

Q: The conductivity of a material with currer density 1 unit and electric field 200 µV is Select one:…

A:

Q: The amount of solar energy collected on a surface for 6 hours and another 6 hours 3 kWh/m² and 6…

A:

Q: The intensities of a particular type of light bulb that consumes 66W to produce 6,300 lumens are…

A:

Q: Find the reading of the ac ammeter if it is in series with a 270 ohm resistor that has a peak power…

A: AC ammeter measures only rms value. Given is the Peak power dissipation. From Ppeak= Ipeak2R which…

Q: a generating station has an overall efficiency of 15% and 0.75% kg of coal is burnt per kwh by the…

A: Given data Overall efficiency = 15% Coal required to produce the 1kwh energy = 0.75 kg

Q: 120kn 240 V 60 Hz ODeg 2N2574 1.0kN ECG6412 100nF

A: The given schematic is shown below:

Q: Compare Wind & Solar Energy

A: This is basic problem from power system. The solution is given below.

Q: Electrical energy is converted to heat at the rate of 6.04kJ/min in a resistor which has 2 C/min…

A:

Q: A wire carries a current of i=3cos314t amperes. What is the instantaneous current at 180°

A: Standard expression for current is Im cos(wt) Where Im is the peak value of current.  Given current…

Q: Explain the different categories of energy consumption (residential, commercial, and industrial) and…

A: Residential use of energy : The energy which is used for household purpose is known as residential…

Q: 3. If w = 240 rad/sec, what are the period (time) and frequency? How many cycles %3D occur in 27…

A:

Q: solar energy as a energy source example?

A: we can explain how we can use solar energy.

Q: A current has an angular velocity of 754 rad/s. "Vhat is the frequency? 8.33 ms O 120 Hz 6.238 rad…

A: W is the angular frequency measured in radians f is the frequency measured in Hertz

Q: what is the depth of discharge of battery 12V, 8AH/20HR

A: The batteries are voltage source elements of DC circuits. These consists of many smaller charge…

Q: Silicon 5 R1 V1 AC 10 V3 2 Vout

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Determine the power absorbed by the 1k0 resistor and the average (real) power delivered by each…

A: The circuit given in the question is The circuit has both ac and dc sources. So, this circuit can…

Q: ww IT 12 3Ω 32 ww 12 100V 22 22 ww 12 ww

A: Here we have used the the delta to star conversion. And we also used the ohm's law to calculate the…

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: In this answer let us try to estimate the power factor of the circuit as shown below.

Q: An electric heater carries 12A at 110V, is submerged in 22.5 lbs of water for 30 minutes. What will…

A: For an electric heater   Current I=12 A Voltage V=110 V Time t=30 minutes Mass of water = 22.5 lbs…

Q: 120kn 240 V 60 Hz 2N2574 ODeg 1.0kn ECG6412 100nF

A: The given power electronics circuit is shown below:

Q: The human body uses 7500 kJ of energy every day. What is the rate of energy consumption per second…

A: This question belongs to basic electrical . It is based on the relation between energy consumption…

Q: What is the instantaneous  maximum value  of power

A: The incandescent lamp act as a resistive load. So, its power factor is unity. The rms current…

Q: During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a…

A: Given, The current that passes through the person, I = 0.7 A The man's body resistance (between his…

Q: Which one of the following energy sources can create the problem due to CO2 gas?

A: some of the sources of the energy generaters the CO2 gas which is harmful for the environment

Q: a voltage waveform is shown below, where Vmax and Vmin are the maximum and minimum voltage values.…

A: Given data, Vmax = 8 V. Vmin = -5 V.

Q: 102 200pF 200 10 sin(100t-40) V 3100MH 302

A: Evaluating the equivalent impedance of the circuit:

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.