With in a quantization, if the total input voltage range is subdivided into two smaller sub-ranges and coded in a mirror image of two halves except first bit, such a coding is called as; O a. Folded Binary Code O b. Unfolded Binary Code O c. Combinational code d. Manchester Code

Q: Explain multiplication of binary with block diagram and perform hardware implementation of 12 and 10

A: Binary Multiplication:  There are two methods of binary multiplication, (i) paper method and (ii)…

Q: Design a 8 bits DAC and convert the following binary numbers to Analog 1- (10011101)2 = ? 2-…

A: DAC is a circuit which converts the digital input analog output.

Q: What will be the binary representation of 66 DEC in BCD coding system

A: Given: Decimal number 66

Q: 1- Design a 3-bit UP-DOWN synchronous counter such that the UP or DOWN counter is selected by a…

A: The state diagram for the UP-DOWN synchronous counter is shown in the below figure.

Q: Design an excess 3 to binary decoder using the unused combinations of the code as don’t care…

A:

Q: 1. Convert the following unsigned binary number to base-10 representation. (10100010)2 = ? 2.…

A:

Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…

A: consider the given question;

Q: IS sampled, que system. The coded signal is then transmitted over a transmission channel of…

A: 53.

Q: For the binary sequence 1101011101, construct RZ, AMI and Manchester format.

A: We will consider the following figures for the solution.

Q: Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active Low,…

A:

Q: clock signal frequency for a 4-bit up counter is 20kHz. What is the frequency of the most valuable…

A: Option :b  Answer

Q: Design a combinational circuit, using the block diagram of Decoders and external gates to accept…

A:

Q: Home Work If the enable pulse frequency in Figure below were halved, determine the binary numbers…

A: Given waveform: To find: If the enable pulses frequency was halved, determine the binary numbers…

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

A:

Q: In an M-ary 64-QAM digital system a) How many level does the system support? b) How many bits per…

A: QAM : quadrature amplitude modulation

Q: If the enable pulse frequency in Figure below were halved, determine the binary numbers represented…

A: Analog to digital converter (ADC) is a device that converts the analog input voltage to digital…

Q: The sum of two binary numbers using BCD format will equal to the sum in binary code If [0 ≤ Sum ≤…

A: Given statement: "The sum of two binary numbers using BCD format will equal to the sum in binary…

Q: Design don't-care conditions. an excess-3-to-binary decoder using the unused combinations of the…

A: Design an excess 3 to binary decoder using the unused combinations of the code as dont care…

Q: 2- Draw the logical diagram of a 2 line to 4 line decoder using NOR 1- Draw the circuit for 3 to 8…

A: Demultiplexer is many to one logic circuit. It is also known as distributor or serial to parallel…

Q: Ex (2):-, If the number of binary bits = 3 and the sampling rate is 2 sample/sec find the signaling…

A: SIGNALING RATE OR BIT RATE =nfs no of quantization levels=2^n

Q: Convert the decimal number 27.315 to binary. and Calculate the binary equivalent of 2/3 to eight…

A: (a)27.31510→11011.01012

Q: Q1. Design asynchronous (ripple ) binary counter and timing diagram for the following sequence…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q2. (a) In Figure 1 below, if the output line 5 goes low, then specify the input (including the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The addition of two 5-bit binary numbers in parallel implies that all the bits of the augend and…

A: We need to draw the circuit diagram providing the carry output in carry-look ahead adder.

Q: Q3/ A. Design 4-Bit Asynchronous counter the sequence for the 4-bit binary counter from 0000 through…

A:

Q: 5) An 8-bit register contains 10010110. What is the corresponding value (in decimal) if it…

A:

Q: (3) A digital system is required to amplify a binary encoded audio signal. The user should be able…

A: For a digital system we need to calculate the minimum number of bits required to encode in staraight…

Q: What hex value do you need to put in the Pullup resistor register in order to initialize the GPIO…

A: In the GPIO port, the output ports are both writable and readable, while input ports are only…

Q: Consider a binary sequence with a long sequence of Is followed by a single "0" and then a long…

A:

Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…

A:

Q: In digital communication .explain all the methods/mechanism used for the minimization of bit error…

A: The methods used for minimisation of bit error rate: The Wireless Deep Fading Environment (WDFE)…

Q: We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot…

A:

Q: VHDL Difference between function and task. What is logic data type.

A: Bit is 2 state data type. It can take 0 and 1 only. Reg is driven by always  block it can't be…

Q: 5) Design an Encoder system using the following truth table for a system. a) Find the out-put…

A: Part a: Redraw the truth table for showing the input and output variable,

Q: A data of 111e is serially transmitted using both binary and BCD? Which encoding technique is faster…

A: Bartleby has policy to solve only 1st question.  For solutions of rest questions re-upload them.

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

A: It is given that: fm=5kHzDynamic range=54dBVmax=±5.01V

Q: binational circuit shown below, list th Vhere A. B, and C are the inputs where ld a binary numbers…

A: The full adder is a combinational circuit which has three input and two output sum and carry.

Q: - Explain the difference between binary and BCD using a decimal value 20.

A: Note :As per our Guidelines we are supposed to answer only 1 question. Kindly repost the other…

Q: Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active…

A: Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active…

Q: (3) A digital system is required to amplify a binary encoded audio signal. The user should be able…

A: Given that, Number of increments = 60. In straight binary, minimum number of bits required to encode…

Q: For conversion binary to octal the binary numbers are divided into groups of 4 bits each Select one:…

A:

Q: I have one question left. If ever please answer this three question? *Design a decoder that…

A: "According to the Company's policy, we will provide a solution for the first subpart of the question…

Q: What is the binary representation of whole number 1,234 as a 12-bit signed integer? What is the…

A: In 12-bit signed integer, MSB is use to represent sign and rest of 11 bits are used to represent the…

Q: Q4\ design synchronous counter with irregular binary count sequence shown in below using negative…

A: Design synchronous counter with irregular binary count sequenc shown  in below using negative edge,…

Q: l-Design a 3 – bit binary decoder (3 – to -8 decoder),

A: 1.

Q: For the following sequence {1.2, -0.2, -0.5, 0.4, 0.89, 1.3.), quantize it using a uniform quantizer…

A: When the signal is in finite range we use uniform quantization. Interval given are mapped with the…

Q: Discussion: 1. What are the advantages of PCM system over other types of modulation systems? 2. What…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask rest again.

Q: Synthetize function: y=E(0,1,8,10,14,15(2,11)) using two-bit multiplexer and gates Write address…

A: Consider the following expression, y=∑0,1,8,10,14,15 (2,11) Using the above expression, the Karnaugh…

Q: Find the number of bits given if the PCM system has a quantization error of 0.4 V and maximum input…

A: Given: Quantization error = 0.4 V Maximum input = 6V

Q: (b) Draw a block diagram of 3 bit synchronous binary counter.

A: 3-bit binary synchronous counter design :