Answered: Write a report to compare between Ac…

Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find The average power delivered to * .the circuit I 9Ω 100 0 v -j72 b ww

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Determine the complex power for the following a. P = 269 W and Q = 150 VAR (capacitive) b. Q = 2000…

Q: For the ac network of Figure Q5, calculate the following; i. The total impedance; ii. The inductance…

Q: 6. Find the characteristic impedance expression in terms of the inductance and capacitance…

A: In this question, We need to choose the correct options What is characteristics impedance of the…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

Q: if the sinusoid is expressed as V=Vsin (ot + 6), what is the value of in degrees? Note that the…

Q: * .circuit j6N I a 100| 0 v 82 -j72 bl فر إضافة ملف بـر

Q: Q Find the capacitance C necessary to improve the power factor to 0.95 lagging in the circuit shown…

A: Z = 20∠30°Z = 20(Cos 30°+j Sin 30°)Z = 20 32+j2Z = 103+j 10ΩBoth branches are parallel,Total…

Q: Look at the circuit. • It has a source voltage: v(t) = 149 Cos (2 t 640 t) · And it has a load such…

A: This question belongs to circuit theory . It is based on the leading or lagging concept between the…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A: The total current supplied by the source is calculated as iT=eTzT where zT is the total impedance of…

Q: An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum…

A: Given: Expression for alternating current i=200sin314t+π/6 amperes

Q: Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

A: Given two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

Q: For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re…

A: The period of the sinusoid is given; the frequency of the sinusoid is calculated as shown below:…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: Please answer these question complete solution and readable (I'll rate it if it is complete…

A: Given data, Expression of currents are given, i1=102sinωt, i2=202sinωt+600

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: 18 In the circuit shown in the figure value of C will the current-I be in phase with the sinusoidal…

A: Given: Brief description: In the given circuit we have an AC circuit. The circuit consists of…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is plied to the circuit shown.…

A: A Non- Sinusoidal Voltage; e=20+15sin1000t+10sin3000t+5sin4000tTo find the total power=?Power=V2Z

Q: A purely inductive load implies that: Select one: a. Load consists of inductor and capacitor b. Load…

A: a purely inductive load implies that: a. load consists of inductor and capacitor b. load consists…

Q: Q2) Assuming a sinusoidal source and uniform load flow. Analyze the following circuits and draw…

A: 1) The transformer is 1:1 transformer so the secondary voltage will be equal to primary voltage. For…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t Volt is applied to the circuit…

Q: V1(t)=__________________________, and, V2(t)=___________________________ What is the rms voltage of…

A: Find the value of the angular velocity.

Q: 9 Determine the time-averaged total power, the real power dissipated, and the reactive power stored…

A: Consider the impedance Z1. The current through this impedance is,

Q: 1. Show that the impedance Z a. For purely resistive is Z =R< 0° b. For purely inductive is Z = XL <…

Q: (e) Calculate: %3! (i) The voltage drop (in polar form) across the resistance R1 = (ii) The voltage…

Q: For both of the AC circuits shown in Figure 6a and 6b, find the complex power (S) supplied by the…

Q: An impedance load consisting of 12 ohms resistance and 16 ohms inductance reactance is connected…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: Determine the total impedance as seen by the voltage source. If the voltage source can be…

Q: please write the complete solution and the topic is AC parallel circuits thank you A sinusoidal 50…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

Q: What is the frequency in Hz =____________________ What is the angular frequency =__________________…

Q: 6. Find the phase relations for the following pairs of sinusoids. Sketch the curve e and i and…

A: Given the following pairs of sinusoids, a. v=60 sin377t+50° V ; i=3 sin754t-10° Ab. v=6.4…

Q: 7.18 A single-phase motor draws 220 W at a power factor of 80 percent (lagging) when connected…

A: The circuit diagram of the motor is shown below: First, we will calculate the equivalent impedance…

Q: Obtain the sinusoids corresponding to each of the following phasors: a. V1 = 60415°, w = 1 b. V2 =…

A: There are two questions. Since you have not mentioned which question you are looking for, so we are…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

A: Given data are: f=400 Hz R=16 Ohms L= 0.0119 H C = 16.6 Micro Farad The…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: 3) Write the value of VO as a function of the components and the Mutual inductance M. Use phasors.…

A: In the given circuit, applying KVL in loop 1, Vs=jωL1+jωL2(i1-i2)-jωMi2Vs=jω(L1+L2)i1-jω(L2+M)i2…

Q: express Power in fonction of time, it is When we a AC Circuit as a Called Instantaneas power PE) =…

Q: Q2) Assuming a sinusoidal source and uniform load flow. Analyze the following circuits and draw…

A: To analyse the given question

Q: Pmine the following from the given R-L-C series circuit: ) Impedance Z ii) Current i iii) Voltage…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression…

A: The voltage across the inductor can be evaluated using the Ohm’s law:

Q: Determine the values of the resistance and the series-connected inductance or capacitance for each…

Q: vs(t) 12 V t (s) T/3 a/2 (a) Repeat the previous problem for the sinusoidal-source excitation Vs (t)…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: R ell + 12 cos 3t V C Vo 4 sin 2t A 10 V If we would like to use Superposition to solve for v, in…

Q: Q5: The current through a 2 k2 capacitive reactance is given. Write the sinusoidal expression for…

A: In this question we will find voltage with given data...

Question

find The average power delivered to * .the circuit

الحل بطريقة الممانعات وشكرا

Write a report to compare between Ac
Through capacitance and AC through in
inductance then: For the circuit shown
beside, find The average power delivered to
* .the circuit
I
9Ω
100 0 v
-j72
b
ww

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is 1000 W. Determine (a) the real power absorbed by each of the impedances and (b) the source current.
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
Is the power factor in Question 6 a leading or lagging power factor? Explain your answer.
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
A 25- W resistor and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor and capacitor; (c) the total current; (d) true power and capacitive reactive power; (e) apparent power, power factor, and power factor.
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a and b and Circuit current (I)
A 25- W resistor and a 300-mH inductor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor and inductor; (c) the total current; (d) true power and inductive reactive power; (e) apparent power, power factor, and power factor angle.
Calculate the capacitance that when placed in parallel with the load, will raise the power factor to unity. Please answer in typing format please ASAP for the like Please
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator