Write less than thirty lines about Power consumption in noc and power saving techinques.

Q: Using nodal analysis, what is the power absorbed by the 2-ohms resistor?

A: Given circuit is,

Q: The bill of commercial load based on Iragi electricity tariff of 1600 kWh costs

A:

Q: what is  an Overview of Power System?

A:

Q: What is sourcing current, and its connection to switching of power? It's confusing. Please help.

A: Power: It is amount of energy which transferred per unit time, it means rate of doing work. It is a…

Q: The current flowing through the neutral will be zero under load condition.

A:

Q: Which are the conductors that connect power to consumers but do not come out of the midpoint or star…

A: In this question we will write about Which are the conductors that connect power to consumers but do…

Q: What is earth voltage?

A: What is earth voltage.

Q: 13. Refer to the graphic D. What is the resistance seen by the power supply?

A: The given circuit is shown below:

Q: Answer the question quecly please Electrical circuit

A: Given circuit:

Q: Assume the maximum amount of power a plant can generate is 10,000 MW. For half the year it generates…

A: In this question, Assume the maximum amount of power a plant =10,000 MW. For half the year power…

Q: determine total power consumed by resistor 3?

A:

Q: Why power losses are useless? Give 3 reasons

A: The solution is given below

Q: what is the computed load for an electric range with a nameplate rating of 12kW

A: => Article 220 (Table 220.55) NEC mentioned the loads and demand factor for various household…

Q: Which resistor in Figure 1 must have the largest power-dissipation rating?Explain.

A:

Q: 1. Explain the reasons for the low power factor in the power system network

A: Power factor (PF) is the ratio of working power, measured in kilowatts (kW), to apparent power,…

Q: 1. Two generators have the following fuel cost functions: C:75 + 10P, + 0.015P? C2: 80 + 8.5P, +…

A: Given: Two generators have the following fuel cost functions: C1=75+10P1+0.015P12…

Q: How do you measure power consumption and can you provide a overview of power consumption topic and…

A: Power can be calculated theoretically as the product of voltage and current and power factor of the…

Q: POWER AND ENERGY Determine the power delivered or power absorbed by the voltage source VA. IA=63 A,…

A:

Q: Determine the power being absorbed by circuit element in (a). Determine the power being…

A:

Q: describe how you will make use of green technology to sustain the electricity supply in North coast(…

A: Few people understand that the bulk of energy in the North Coast is generated by water rather than…

Q: 22 wwww 52 lou Pind I and at 2s2 and 7sr www www Or .

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element…

Q: :- A- what is the cost of running bo0 min a week for 7 months at 9¢ per kilowatthour ? using 200 w…

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…

Q: 1. Explain why the generated voltage decreases when the load current increases.

A: As per our policy we can provide solution of first question only. In the shunt generator, output…

Q: State the types of power station then explain briefly one of them

A: Power plants can be of multiple types:-  Nuclear power plants Hydroelectric power plants  Diesel…

Q: A 50-ohm load dissipates 200W of power.How much is the voltage and current across the load?

A: Given Data: Power P = 200W Resistance  = 50 ohm

Q: Electric power supply based on the type of power transmission may be classified as under ground…

A: Electrical power system is normally comprising of power generation, transmission, distribution and…

Q: If Rout is 3kilo-ohms, find its power dissipated

A: We will use nodal analysis to find node voltage then we will find the current through the resistance…

Q: What is ohms low

A: Current: It is a flow of electrical charge carriers like electrons. It is time rate of change of…

Q: End product of Thermal power plant is O a. Smoke and Ash O b. Ash and Electricity O c. Smoke and…

A: To find out the correct answer

Q: How do you do the 2 wattmeter and 3 wattmeter method?

A: A two Wattmeter Method can be used to measure the power in a 3 phase, three-wire star or delta…

Q: 204 2e for the Circuit shown betoet find the fotal Power delivered to the Circuit? and find The…

A: We will try to find the power delivered to the circuit and also the current passing through the 12…

Q: Which is a disadvantage of wind energy? O a. It does not use any water. O b. It needs more…

A:

Q: Define what is Wattage. What is its formula?

A: Wattage is a unit of power.

Q: How the potential coil of watt meter is connected Answer:

A: How the potential coil of watt meter is connect

Q: 13. i) The data for a wind turbine is given below: Wind speed = 14 meters/sec, Length of blade = 10…

A:

Q: A 300- kw alternator has an efficiency of 90 % at full load. Calculate the power losses?

A:

Q: WHATIS THEEASIEST 10A WAY TO SOLVE THE QUESTION? 30-OHM 10-OHM 20-ОНМ 10V 40V 60-ОНМ

A:

Q: Write the necessity of power supply and briefly describe different types of SMPS and UPS.

A: We use a lot of electronic devices in our homes, industries, and workplaces. These electronic…

Q: Subject - Explain the different methods of electricity distribution   Question -  Explain…

A: Electrical energy is dominant because it is easier to transport and distribute than other sources of…

Q: Is it correct

A:

Q: List some loads that you use in your household and identify the form of output energy. (Complete…

A:

Q: is type of energy resource which uses the rise and fall of water along the coastal areas.

A: In this we will write which type of energy resources which uses the rise and fall of water along the…

Q: Sketch and explain each part of general block diagram of a complete electrical power system.

A: Power is the basic need for the economic development of any country in the world. Availability of…

Q: Can you do it using Ohm's Law?

A:

Q: Question 3 а. Design a multistage circuit for generation of high voltage DC with the help of neat…

A: The use of DC sources is gaining importance among the industries and also among the distribution.…

Q: a single line diagram of power system

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…

Q: What is the max power delivered to the load? Need help.

A:

Q: How to convert 10 kW of power into the unit dBW?

A: In this case, the amount of power given is P=10 kW=10×103 W. This power is to be converted into the…