what is the computed load for an electric range with a nameplate rating of 12kW

Q: lomp2 22

A: Concept of Parallel Circuit:  In Parallel Connection the positive terminal of all the elements are…

Q: the voltage between the star-point of the load and the supply neutral.

A: Given: An unbalanced star-connected load is fed from a symmetrical 3-phase system.            Phase…

Q: ) Wattmeter

A:

Q: Q10: mentioned the purpose of the following:: 1-Halid torch 2-Refrigerator lamp

A: 1) Halide torch: A halide torch is a device to detect the leakage of halo-carbon refrigerants. It…

Q: A full-electric car with the battery terminal voltage 900 V is connected to a 3-phase, 380V, 50 Hz…

A: Given: Terminal voltage of the battery, V=900 VV=900 V And the supply is 3-phase, 380V, 50 Hz AC…

Q: A 25 watts, 120V has a cold resistance of 45 ohm. When the voltage is switched on, what is the…

A:

Q: small appliances circuits used in dwellings must be calculated on the basis of not less than ____…

A: NEC -National Electricity code It is regionally adoptable standard for the safe installation of…

Q: Calculate the power rating of a range element that draws 7.5 amperes of current when connected to…

A: Power rating= voltage rating of element × current drawn by the element Given rated voltage =230…

Q: What is the power rating of the device which uses a 9-V battery and has a resistance of 180 ohms?

A:

Q: A 12 ampere electric fan and blower with a power factor of 0.90 was connected to 240 volts…

A: The question is about circuit current and power in the circuit.

Q: what is the power factor of the load on a 460volts, 3phase system if the ammeter indicates 100amps…

A:

Q: Determine the power delivered or power absorbed by the voltage source VA. IA=63 Amperes, IB=34…

A: Given circuit is - Given values are - IA=63AIB=34AVA=38Volt

Q: A 60 ohms bulb is connected to a 220V source for 1 hours. How much energy is taken from the source?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: A generator produces 400V and supplies a load 1000' away. The load consists of one electric motor…

A: generator output voltage = 400 V  The load is an electric motor of 3HP and Heater at 3kW What would…

Q: Which of the following devices are not belongs to Thermal power station. a. Steam Turbine and Boiler…

A:

Q: What are the two factors that can disrupt the power supply

A: In this case, the two factors that can disrupt the power supply needs to be discussed.

Q: Three dry cells with internal emf’s of 1.5 volts, 1.4 volts and 1.6 volts are connected in series…

A:

Q: Calculate the total electrical energy consumed for a load usage of 5 lamps (24 watts each) for 8 hrs…

A: Total lamps=5 power of each lamp=24 watt light on for 8 hrs per day

Q: A power supply has a voltage regulation of 1 %.  If teh no-load voltage is 30 V, wat is teh…

A: Voltage regulation =no load voltage-full load voltagefull load voltage×100. Given vo load voltage…

Q: A single phase 230V watt-hour meter has correctly adjusted having a meter constant of 500 rev/ kWh.…

A: Given values are - Meter constant=500revkWhVt=230VI=20APower factor=0.5Lagging

Q: Overall efficiency of a thermal plant is

A: The explanation is as follows.

Q: 1. Explain why the generated voltage decreases when the load current increases.

A: As per our policy we can provide solution of first question only. In the shunt generator, output…

Q: c) Identify three (3) residual measures you can use to mitigate the effects on the power system…

A: In the power system, frequency is generally changed to the sudden change of load.  In a power plant,…

Q: 3. Determine the total conductance G, total current I, and total power Pr. 30A 40n 20V lon 200

A: According to Bartleby question answer rules I have to solve first question only because of this I…

Q: Enumerate the steps in making a power supply

A: Assuming that you are asking for the  design of laboratory DC power supplies.

Q: Explain how to use the ohmmeter portion of a VOM

A: A VOM(volt-ohm-milliammeter) is also known as multimeter. It is used to measure voltage, current and…

Q: what  will be the total energy consumed  by the 18 ohms load resistor in 8 seconds?

A: what  will be the total energy consumed  by the 18 ohms load resistor in 8 seconds?

Q: Please i need solution (electric circuit)

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: A 50-ohm load dissipates 200W of power.How much is the voltage and current across the load?

A: Given Data: Power P = 200W Resistance  = 50 ohm

Q: Voltage what equal

A: In this question, we will define voltage..

Q: In a circuit, 3200J of work was done to draw 9A of current in 45 minutes. Calculate the EMF of the…

A: Write the given values in the question.

Q: 1. Did your experimentala results verify the equivalence between the delta and star connections?…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The working fluid in a thermal power station is ..

A: Thermal power station is used to generate the electricity by burning the coal.

Q: write information about calibration of wattmeter using voltmeter and ammeter .

A: The measurement devices are used to measure electrical quantities. The true value and the measured…

Q: Explain the operating principle for a wattmeter, ampere-hour meter, power factor meter, synchroscope…

A: A wattmeter or electrodynamometer wattmeter has a very simple working principlewhich states that " a…

Q: 3. A fluorescent lamp unit connected to a 110 v AC line takes 1.2 A and requires 110 w power. What…

A: The solution is given below

Q: what is the depth of discharge of battery 12V, 8AH/20HR

A: The batteries are voltage source elements of DC circuits. These consists of many smaller charge…

Q: How the potential coil of watt meter is connected Answer:

A: How the potential coil of watt meter is connect

Q: TITLE OF 3MINSVIDEO ON YT: Automatic on off light switch with phototransistor   Please check…

A: Automatic Light Control - Automatic  Lighting Control ideally is to control the lights even when one…

Q: 29B. For the circuit shown in the figure, is the terminal voltages of the batteries 4.8 V and 4.8 V…

A: According to question: Applying KVL in loops [abcda] and [ebcfe], this will give…

Q: age value of the voltage wa

A: The average value is defined based on the charge transfer. The given voltage wave-form is a periodic…

Q: Formula of wattage

A: Formula of wattage

Q: If a 100 v, 60 lamp is connected to a 200 volt 50 Hz supply, calculate the net inductance required…

A:

Q: calculate the power absorbed by a load of

A: DC Shunt Generator   Given,Ra=1 ohm,RL=10 ohm           Rch=50 ohmNumber of Pole (P)=4Flux per…

Q: 4 A 2V 2 V

A: So we have to find if the left box is absorbing power or supplying the power.

Q: Resistor (R) 12 volt battery Voltmeter indication = 12.3 volts Ammeter indication = 4.556 milliamps

A:

Q: Predict power consumption for a month if the temperature is 770F

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Voltage = 120 resistance =30 and Cap reactance =40 what is the current at the power source

A:

Q: A capactance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

A: This problem comes under basic electrical. It is related to capacitance . Rating of capacitor…