Q3 /For the circuit shown below calculate the voltage across R1 if multiplevoltmeter are used with different internal resistances as given in table belowXMM1R4R150001.5kOR35000R21kOV120VHow you can get best voltmeter accuracyReadingRmV1Percentage error110Ω100231kΩ4100k25900k2

Answered: Image /qna-images/answer/61851e34-f31a-437b-a3b9-98c5be9d53ca.jpg

Answered: XMM1 R4 R1 5000 1.5kO R3 5000 R2: 1k0…

Engineering

Electrical Engineering

XMM1 R4 R1 5000 1.5kO R3 5000 R2: 1k0 V1 20V

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 7PP: In an R-L parallel circuit, ET=120 volts, R=120,XL=150. Find IL.

See similar textbooks

Related questions

Q: Q2/(b) Find Vo for the network shown below

A: The given circuit is shown below:

Q: If the information signal frequency range is 300HZ to 3KHZ, what is the bandwidth of the 100% modula...

A: Given, Information signal frequency range is 300 Hz to 3 kHz. Signal is 100% modulated.

Q: The screw eye is subjected to two forces, F, and F2. Determine the magnitude and direction of the re...

Q: 4- For an electromagnetic wave, the distance between five successive crest (peak) is 50 inches, Calc...

Q: What is zener effect?

Q: 12. In the given circuit the current I, is 1) 0.4 A 2) - 0.4 A 30 3) 0.8 A 4) - 0.8 A 40 an 40 80

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: explain what happened as the lamp load increasing through shunt generator

A: The ammeter displays the load current readings, while the voltmeter displays the end voltage value. ...

Q: What is the Vmax and Vrms of 169sin 377t?

Q: A ww ww www www ww

Q: Instructions Calculate the DC voltages and currents in the circuit. Find for the current emitter, co...

A: Thee circuit diagram is shown below,

Q: if IL(0)=-5, IL(0)=4,7=2.5, then IL after 4 sec equals to O 2.431 O 3.1829 O 5.361 O 1.095

A: Given data: iL∞=-5iL0=4τ=2.5t=4 sec

Q: Question 10. Consider H(z) with the zero-pole diagram as shown below. Determine which frequency resp...

Q: - An| b(1 – con(0)/ /1+ cos(0) etermine the values of the constants (A and B) so that the value of V...

A: The value of voltage V at given coordinate is 800V, putting it in question we have: 800=AlnB(1-cos75...

Q: 7) Determine the stability of a closed loop control system whose characteristic equation is s + s + ...

Q: Rice .. grow in cold climates. O didn't O doesn't

A: GivenRice...........grow in cold climates →The given question is in simple present tense→simple pese...

Q: 52 10 2 V1 A 20 v(+ 10 2 4 A VTh

Q: A simple one-pole system has transfer function H(s) = What is the magnitude of the frequency respons...

A: Given, A simple one pole system with transfer function Hs=11+τs

Q: dy d d'x d²x d² :+y=本 +5+ +&x + &r dt

Q: Ten 500-Ohm resistors are connected in parallel, find the equivalent resistance and the current in e...

A: Equivalent resistance 1/Req=1/500+1/500+1/500+.......( ten times) Then 1/Req= 10 /500 Req= 500/10= ...

Q: A load of 1500 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

Q: A 400/800 ratio transformer has secondary winding resistance of 0.5 ohm. What is the total resistanc...

A: Total resistance referred to primary side = Secondary winding resistance×primary voltagesecondary vo...

Q: 1) The resistive load inverter shown below is to be designed for VL = 0.5V. (a) What are the value o...

Q: The load current in a system is 100 A. The short-circuit current for the smallest fault is 1000 A. A...

A: we have given The load current in a system is 100 A The short-circuit current for the smallestfault ...

Q: a) Y(ω) = 1/(5+jω) The expression above defines the frequency domain signal Y(ω) from a time domai...

Q: A singer voice is sampled for 4 second by an 8-bit ADC at a sampling frequency of 10 kHz. The sample...

A: Given that n=8bit fs=10kHz t=4sec

Q: nogeneous PensTok was established Ke ban Dam based on the below in Forme Height of dam) = 2 lom Flow...

A: It is given that: Height of dam=h=210 mFlow rate=Q=80 m3/sg=9.81 m/s21 m3 of water=1000 literEfficie...

Q: 3- In a High Pass Filter, the filter response curve has a slop of 6dB/ octave with a cut of frequenc...

Q: Find the poles and zeroes of the functions and mark these on the s-plane. K(s + 2)(s + 10) G(s) s(s ...

Q: The transfer function is, s(s² +s+2) s* +3s° +s? +5s +10 Calculate the angle of arrival of the compl...

A: The root locus plot is the plot of movement of poles and zeroes when the open loop gain is varied. T...

Q: The information in an analog signal voltage waveform is to be transmitted over a PCM system with an ...

A: The solution is given below.

Q: Y-connected, solid grounded and is operated at rated voltage at no-load and is disconnected from the...

Q: This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in el...

A: Capacitor: It is an element used to store electrical energy in the electrical field. A capacitor is ...

Q: Find the current I, in the circuit shown. I. 50 2 100 2 ww 60/0° V j80 Q -j40 Note: The current I, r...

Q: Determine the differential equations of the given system diagram below:

A: In this question We need to Determine the differential equations of the given system. This system i...

Q: 7. The voltage generated across one inductor of a 3Ø alternator is 6 volts. There are 120 slots and ...

A: q=slot per pole per phase=SP×3=1203×10=4 g=slotpole=12010=12 Υ=180°g Υ=18012=15°

Q: CHAT MATH SOLVER Question A load is composed of a 4 ohm resistance connected in series with a ...

A: Given data : R=4 ΩXL=3 ΩVS=120 V

Q: What is the nature of a circuit if its total impedance is 4-j4 ohms? Group of answer choices reactiv...

Q: (2v2 + i) – i (1+v2i)

A: Function is given, 22+i-i1+2i

Q: What is the bandwidth of an oscilloscope with 17.5ns rise time? Can a 5MHZ square wave with 9 signif...

A: Rise time is given tr=17.5 ns Frequency of square wave is 5 MHz.

Q: O A 30 60 2A 4A 6A OB The value of the equivalent voltage source at the AB ends of the circuit in th...

A: Given circuit,

Q: 0.5 15 05 x(t) y(t 05 0.5 05 Determine the impulse response of the single system representation of t...

Q: Calculate the frequency a 15 V sinusoidal source should be set to so that a 800 mH inductor connecte...

A: Given, Source voltage, Vs = 15 V Inductance, L = 800 mH Inductive reactance, XL=1350 Ω

Q: Base on the picture, find the power dissipated in each resistor

Q: 5. Decompose the following signals into even and odd parts (a) x(t)= cos(2t) + sin²(3t) (b) x(t)= u(...

A: The even and odd part of the signal x(t) is given as: xe(t)=x(t)+x(-t)2xo(t)=x(t)-x(-t)2 (a) x(t)=co...

Q: Q15: Determine Vo, and Vo; for the network of the figure below 12 ka -10 V 33ka

Q: 1. The Equivalent resistance to this set of resistors? 2. The total current of the circuit? 3. The v...

Q: 1. Use Kirchhoff's Laws to find the branch currents indicated in the following networks: 2420°v 50 2...

Q: The Figure below shows an electric circuit. Calculate: 1. The Equivalent resistance to this set of r...

Q: A 4-bit pulse code modulation (PCM) modulator is used with a 0-2 V signal. How many quantization lev...

Q: Question 6- Calculate the drift velocity of an electron in a conductor is? The conductor (copper) nu...

A: Given a copper conductor having, Free charge per unit volume, n=8.46×1028 Cm3 Current density, J=382...

Concept explainers

Solar Cell

A solar cell, or photovoltaic cell, is a device that converts light into electricity directly through a photovoltaic effect, i.e., a physical and chemical event. It is a type of electromagnetic cell, defined as being used for its electrical properties, current, voltage, or resistance, which vary when exposed to light. Everyday cellular gadgets are usually the building blocks of photovoltaic modules, collectively known as solar panels. Single junction silicon solar cell can generate an open circuit of about 0.5 to 0.6 volts.

Question

Q3 /For the circuit shown below calculate the voltage across R1 if multiple
voltmeter are used with different internal resistances as given in table below
XMM1
R4
R1
5000
1.5kO
R3
5000
R2
1kO
V1
20V
How you can get best voltmeter accuracy
Reading
Rm
V1
Percentage error
1
10Ω
1002
3
1kΩ
4
100k2
5
900k2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an R-L parallel circuit, ET=120 volts, R=120,XL=150. Find IL.
solve using thevenins theorem(draw the step by step changes in the circuit diagram)solve the computed values1. RTH (measured values from tinkercad=56.8 ohms)2. VTH (measured values from tinkercad=2.27 V)3. I (measured values from tinkercad=0.04 A)
For the circuit shown in the figure above, what is the equivalent resistance Req as seen from the a-b terminals? Assume R1 = 83 , R2 = 55 , and R3 = 91
VIII) Find (iv) 1011011010.102 by 11012 Please write the steps for the solution
Finding the direction of the currents. Finding currents given that R2: 10.94 x 10^2 ohmR3: 9.89 x 10^2 ohmR4: 25 ohm Terminal Potential: Battery 1: 5 V using Kirchoff's laws. You will check some of the laws that govern electrical circuitsDirect current: conservation of current in a node, addition of potentialsfor series components, addition of currents for parallel components
Create this circuit in tinker caduse, Resistors, powersupply, and multimeter if possiblecomputational answers:( i have already solved this using mesh analysis i just need the simulation in tinker cad that shows this answers in the powersupply) Ia=0.1441 AIb=0.2 AIc=0.01162 A
Using ∆-Y / Y-∆ transformation, calculate total resistance.As you solve the circuit, present the new configurations and the full answer. To four decimal places, round your answers.
Using ∆-Y / Y-∆ transformation, calcuate total resistance.As you solve the circuit, present the new configurations and the full answer. To four decimal places, round your answers.
6. PLEASE SOLVE AND SHOW YOUR DETAILED SOLUTION WITH FBD. The currents at the junction point in a circuit have the following values I1 = (15 – j4) A and I2 = (12 + j22) A. Calculate I1 + I2.
this is incorrect. answer should be vc(t)=4+ radical5cos(2t+angle) (v,s) and angle=arctan(1)-arctan(3) please re-solve correctly and only submit your answer if it is IDENTICAL TO THE ONE I GAVE and solve it in great detail. thank you. thumbs up is ready if correct
How much current will flow in a series RLC circuit when VT = 100 V, XL = 160 ohms XC = 80 ohms , and R = 60 ohms ? A. 1 A B. 1 mA C. 6.28 A D. 10 A
A moving coil ammeter gives a full scale deflection for a current i = 300 mA and its coil has a resistance RC = 1Ω. To use this ammeter as a voltmeter that measures 9V at full scale deflection a multiplier resistance, RM, is added in series with the coil. What is the value of the multiplier resistance? Select one: a. 31 Ω b. 32 Ω c. 30 Ω d. 29 Ω