Answered: You charge a 2.00-μF capacitor to 40.0…

You charge a 2.00-μF capacitor to 40.0 V. 1)How much additional energy must you add to charge it to 110 V? (Express your answer to three significant figures.)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter8: Capacitance

Section: Chapter Questions

Problem 46P: Suppose you have a 9.00-V battery, a 2.00F capacitor, and a 7.40F capacitor, (a) Find the charge and...

See similar textbooks

Related questions

Q: Three capacitors charged with the following capacitances and corresponding voltages, (a) calculate…

A: Let us consider three capacitors having the capacity (Ca),(Cb) & (Cc) in Farad and different…

Q: What total energy is stored in the capacitors in the figure below (C1 = 0.123 µF, C2 = 48.7 µF) if…

Q: Consider the system of capacitors shown in the figure below (C1 = 2.00 µF, C2 = 9.00 µF). (a) Find…

A: Given that the capacitors C1=2.00μF, and C2=9.00μF.

Q: A 9.0 µF capacitor and a 21.5 µF capacitor are connected in parallel across the terminals of a 6.0 V…

Q: Two capacitors C1 and C2 are connected in parallel. Which of the following statements is correct? O…

Q: Two capacitors are connected in parallel across a 38.0-V battery. If their capacitances are 28.0 HF…

A: Given data: Voltage (V) = 38.0 V Capacitance (C1) = 28.0 μF Capacitance (C2) = 38.0 μF

Q: Given a 3.00 µF capacitor, a 4.00 µF capacitor, and a 6.50 V battery, find the charge on each…

Q: C3 C = 6.00 aF, C2 C2 = 1.00 aF, Cs = 3.00 paF, CA C4 = 6.00 paF, Vab- 12.0 V Figure 1. Network of…

Q: Five capacitors are connected as shown in the following figure. 2.0 μF 1.0 μF 2.0 μF a b 4.0 μF 4.0…

Q: Three identical capacitors are connected in series across a potential source (battery). If a charge…

A: Capacitor are connected in seriseries Net charge through all capacitor = Q

Q: A 46.83 mF capacitor is fully charged. If the potential difference measured across its two terminal…

A: Given that:- Capacitance of capacitor=46.83mF Voltage across capacitor=185.86Volt

Q: Find the following. (In the figure, use C, = 12.80 µF and C2 = 6.80 µF.) 6.00 uF CuF C2 µF 9.00 V…

A: Introduction: Capacitor is the passive electronic device used to store the charge. Energy stored in…

Q: Four capacitors are connected as shown in the figure below. (Let C = 12.0 µF.) 3.00 μΕ th. |20.0 µF…

A: C = 12μF C1 = 3μF C2 = 6μF C3 = 20μF ∆Vab = 20 volts

Q: Two capacitors C1 = 1 μF and C2 = 4 μF are connected in parallel and charged to V = 3V. What is the…

A: Given:capacitors,connected in parallel C1 = 1 μF C2= 4 μF Charged, V = 3VFind the total energy…

Q: Consider the following. (LetC₁ = 20.40 μF and C₂ = 14.40 µF.) 6.00 με + 9.00 V (a) Find the…

Q: ith the same capacitor and fixed capacitance, when the applied voltage is doubled, the final…

A: Energy stored in capacitor U = (1/2) CV2

Q: A fully charged defibrillator contains 1.20 kJ of energy stored in a capacitor.in a discharge…

A: Given: Energy stored in the capacitor= 1.20 KJ Electrical energy =6 x102 J Time taken = 2.50 ms…

Q: Four capacitors are connected as shown in the figure below. (Let C = 10.0 µF.) (a) Find the…

A: Capacitor C is in series with capacitor C3. This series connection is in parallel with the capacitor…

Q: For the system of four capacitors shown in the figure below, find the following. (Use C, = 3.00 µF,…

A: Given data: C1=3 μF=3×10-6 F C2=6 μF=6×10-6 F C3=1 μF=1×10-6 F C4=5 μF=5×10-6 F The potential is…

Q: Three parallel plate capacitors have the same dimensions. The area of each capacitor is A=250 cm?…

Q: (a) the equivalent capacitance of the system (b) the charge on each capacitor on C1 µC on C2…

Q: For the connection of capacitors shown in the figure, it is known that the energy stored by the…

Q: Consider two capacitors of 20 µF and 10 µF. The first is charged by a 18 V battery and disconnected;…

Q: Consider the combination of capacitors shown in Figure 5.36. Determine the energy stored in (a) the…

A: (a) Let C1, C2, C3, and C4 denote the capacitance of the four capacitors, C5 denotes the equivalent…

Q: Which of the following forms is another formula for energy in a capacitor? Select one or more: O a.…

Q: It takes 160 V to store 0.0000000574 C of charge in a certain capacitor. a) How much potential…

Q: In the figure below, a potential difference V = 200 V is applied across a capacitor arrangement with…

Q: Find (a) the equivalent capacitance of the capacitors in Figure P16.39, (b) the charge on each…

A: Part A:

Q: Consider the following. (LetC,1 34.00 µF and C2 = 28.00 µF.) = 6.00 µF C, 9.00 V

A: Given values: Voltage applied,V=9.00 V Capacitance: C1=34.00 μFC2=28.00 μF

Q: For the system of capacitors shown in the figure below, find the following. (Let C₁ = 1.00 μF and C₂…

Q: A parallel-plate capacitor is connected to a battery. What happens to the stored energy if the plate…

A: With the changing distance between the plates, both C and V will change, what wouldn't change is the…

Q: Initially a charged capacitors stores 2000 μJ energy. When the potential difference decreases by 3.0…

A: The energy stored by the capacitor of capacitance C is:U=12CV2………(1)where,V is the applied voltage…

Q: A parallel-plate capacitor is connected to a 2-volt battery. If the plate separation is doubled…

Q: Which of the following is not a equation for the energy stored in capacitor? A. Q^2/2C B.…

Q: Two capacitors, C1 = 5 uF and C2 = 5 uF are connected in parallel and charged with a 54 V power…

Q: A fully charged capacitor can store 500 J of energy. Assuming it is charged using the typical 120V…

A: Energy stored in capacitor is E=CV22

Q: #1 Charge Stored in a Capacitor Suppose the potential difference across a 3.50 mF capacitor is 300…

Q: A 2.00 uF capacitor and a 6.50 uF capacitor are connected in serles across a 3.00 v battery. How…

Q: Four capacitors are connected as shown in the figure below. (Let C = 12.0 µF.) C. 3.00 µF th. 20.0…

A: When capacitors are connected in series, their equivalent capacitance is given by 1Ceq=…

Q: If the 10.0 μF capacitor of a heart defibrillator is charged to 9.00×10³ V, what is the energy…

A: Given Data Capacitance C = 10.0 μF Voltage V = 9×103 V Energy Stored in Capacitor W to be known?

Q: 7.5 nF A potential difference of 25 V is maintained across ab. (a) What is the equivalent…

Q: For the system of four capacitors shown in the figure below, find the following. (Use C, = 5.00 µF,…

Q: For the system of four capacitors shown in the figure below, find the following. (Use C, = 9.00 µF,…

Q: Find the following. (In the figure, use C1 = 10.00 μF and C2 = 5.00 μF.) (a) the equivalent…

A: Solution: Given that: where C1 = 10.00 μF and C2 = 5.00 μF

Q: Two capacitors C1 = 1 μF and C2 = 4 μF are connected in parallel and charged to V = 3V. What is the…

A: Given: The capacitors are C1=1 μF and C2=4 μF. The supply voltage is 3 V.

Concept explainers

Dielectric Constant Of Water

Water constitutes about 70% of earth. Some important distinguishing properties of water are high molar concentration, small dissociation constant and high dielectric constant.

Electrostatic Potential and Capacitance

An electrostatic force is a force caused by stationary electric charges /fields. The electrostatic force is caused by the transfer of electrons in conducting materials. Coulomb’s law determines the amount of force between two stationary, charged particles. The electric force is the force which acts between two stationary charges. It is also called Coulomb force.

Question

You charge a 2.00-μF capacitor to 40.0 V.

1)How much additional energy must you add to charge it to 110 V? (Express your answer to three significant figures.)

You charge a 2.00-µF capacitor to 40.0 V.
1) How much additional energy must you add to charge it to 110 V? (Express your
answer to three significant figures.)
mJ Submit
You currently have O submissions for this question. Only 10 submission are allowed.
You can make 10 more submissions for this question.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Suppose that the capacitance of a variable capacitor can be manually changed from 100 pF to 800 pF by turning a dial, connected to one set of plates by a shaft from 0° to 180°. With the dial set at 180° (corresponding to C — 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. If friction is negligible, how much work is required to turn the dial from 180° to 0°?
Check Your Understanding The potential difference across a 5.0-pF capacitor is 0.40 V. (a) What is the energy stored in this capacitor? (b) The potential difference is now increased to 1.20 V. By what factor is the stored energy increased?
Check Your Understanding When a cylindrical capacitor is given a charge of 0.500 nC, a potential difference of 20.0 V is measured between the cylinders, (a) What is the capacitance of this system? (b) If the cylinders are 1.0 m long, what is the ratio of their radii?
Check Your Understanding When a dielectric is inserted into an isolated and charged capacitor, the stored energy decreases to 33% of its original value, (a) What is the dielectric constant? (b) How does the capacitance change?
Suppose you have a 9.00-V battery, a 2.00F capacitor, and a 7.40F capacitor, (a) Find the charge and energy stored if the capacitors are connected to the battery in series, (b) Do the same for a parallel connection.
Check Your Understanding What is the potential on the x-axis? The z-axis?
Check Your Understanding What is the potential inside the metal sphere in Example 7.10?
A parallel-plate capacitor with capacitance 5.0F is charged with a 12.0-V battery, after which the battery is disconnected. Determine the minimum work required to increase the separation between the plates by a factor of 3.
(i) Rank the following five capacitors from greatest to smallest capacitance, noting any cases of equality, (a) a 20-F capacitor with a 4-V potential difference between its plates (b) a 30-F capacitor with charges of magnitude 90 C on each plate (c) a capacitor with charges of magnitude 80 C on its plates, differing by 2 V in potential. (d) a 10-F capacitor storing energy 125 J (e) a capacitor storing energy 250 J with a 10-V potential difference (ii) Rank the same capacitors in part (i) from largest to smallest according to the potential difference between the plates, (iii) Rank the capacitors in part (i) in the order of the magnitudes of the charges on their plates, (iv) Rank the capacitors in part (i) in the order of the energy they store.
A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.
Two capacitors, C1 = 18.0 F and C2 = 36.0 F, are connected in series, and a 12.0-V battery is connected across the two capacitors. Find (a) the equivalent capacitance and (b) the energy stored in this equivalent capacitance. (c) Find the energy stored in each individual capacitor. (d) Show that the sum of these two energies is the same as the energy found in part (b). (e) Will this equality always be true, or docs it depend on the number of capacitors and their capacitances? (f) If the same capacitors were connected in parallel, what potential difference would be required across them so that the combination stores the same energy as in part (a)? (g) Which capacitor stores more energy in this situation, C1 or C2?
Check Your Understanding The capacitance of a parallel-plate capacitor is 2.0 pF. If the area of each plate is 2.4 cm2, what is the plate separation?