You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0.225 1 0.310 2 0.420 3 0.510 4 0.610 0.720 6 0.810 7 0.915 8. 0.950 9 0.980 10 0.990 Set up a standard curve. What would the quality of the line-fit (R2 value) be if you do not exclude experimental outliers? (Give you answer to 4 decimal places)

You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0.225 1 0.310 2 0.420 3 0.510 4 0.610 0.720 6 0.810 7 0.915 8. 0.950 9 0.980 10 0.990 Set up a standard curve. What would the quality of the line-fit (R2 value) be if you do not exclude experimental outliers? (Give you answer to 4 decimal places)

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter26: Molecular Absorption Spectrometry

Section: Chapter Questions

Problem 26.1QAP

See similar textbooks

Similar questions

Mass spectrometry is an extremely versatile detection system for GC. However, interfacing an HPLC system to a mass spectrometer is a much more difficult task. Describe the major reasons why it is more difficult to combine HPLC with mass spectrometry than it is to combine GC with mass spectrometry.
Maria was tasked to determine the concentration of a Fe2(SO4)3 solution. She prepared 5 different standards of Fe2(SO4)3 using the table below as her guide. She ran the standards and the unknown solution through UV-VIS spectroscopy and recorded the absorbances of each solution. HINT: use the dilution equation to determine the concentration of Fe2(SO4)3 in each test tube before preparing the standard curve. NOTE: No need to force the line to pass through zero. Just graph the data as is. What is the slope of the line of the standard curve from the given data? What is the concentration of the unknown solution?
Calculate the specific absorbance ratio (SAR), where A620 = 0.285 and A280 = 0.795. Enter your result with 3 decimal places.
An ethanol solution of 3.5 mg/100 ml of compound Y (150.0 g/mol) in a 1.00 cm quartz cell has an absorbance (A) of 0.972 at λmax=235 nm. What is its molar extinction coefficient? Report your answer to the correct number of significant figures. Do not include units in your answer. I need to know what is the correct number of sig figs for this question which will determine what the correct answer is.
Standard solutions of a chemical species with different concentrations are analyzed using a UV-Vis spectrophotometer. The absorbance values obtained are plotted against concentration and the slope of the drawn calibration line is calculated as 55400. Since a 0.5 cm cuvette is used in this analysis, calculate the molar absorptivity coefficient of the analyzed species.