An electric teakettle has a multi position switch and two heating coils. When only one of the coils is switched on, the well-insulated kettle brings a full pot of water to a boil over the time interval ?t. When only the other coil is switched on, it requires a time interval of 2?t to boil the same amount of water. Find the time interval required to boil the same amount of water if both coils are switched on (a) in a parallel connection and (b) in a series connection.

An electric teakettle has a multi position switch and two heating coils. When only one of the coils is switched on, the well-insulated kettle brings a full pot of water to a boil over the time interval ?t. When only the other coil is switched on, it requires a time interval of 2?t to boil the same amount of water. Find the time interval required to boil the same amount of water if both coils are switched on (a) in a parallel connection and (b) in a series connection.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.48P: A motor in normal operation carries a direct current of 0.850 A when connected to a 120-V power...

See similar textbooks

Similar questions

A motor in normal operation carries a direct current of 0.850 A when connected to a 120-V power supply. The resistance of the motor windings is 11.8 . While in normal operation, (a) what is the back emf generated by the motor? (b) At what rate is internal energy produced in the windings? (c) What If? Suppose a malfunction slops the motor shaft from rotating. At what rate will internal energy be produced in the windings in this case? (Most motors have a thermal switch that will turn off the motor to prevent overheating when this stalling occurs.)
Two concentric circular coils of wire lie in a plane. The larger coil has 42 turns and a radius of a = 9.20 cm. The smaller coil has 4 turns and a radius of b = 0.25 cm. The current in the larger coil has a time dependence as shown in the figure. Approximately what is the magnitude of the EMF induced in the small coil at t = 2 s? Note that on the graph of current versus time, the two ends of the diagonal part of the graph are at (0, 0) and (3, 5)
Two concentric circular coils of wire lie in a plane. The larger coil has 68 turns and a radius of a=8.1 cm. The smaller coil has 99 turns and a radius of b=0.6 cm. The current in the larger coil has a time dependence as shown in the figure. A) Approximately what is the magnitude of the EMF induced in the small coil at t=2 s? Note that on the graph of current versus time, the two ends of the diagonal part of the graph are at (0, 0) and (3, 5). For my answer I keep getting 3.616E-4 V or 1.0849E-4 V both of which are wrong B) Approximately what is the magnitude of the EMF induced in the small coil at t=5 s? For my answer I keep getting 8.068E-5 V or 2.4208E-5 V both of which are wrong.
A DC motor delivers power to a load at a speed of 1500.0 r/min. The armature current drawn by the motor is Ia = 130 A. The armature circuit resistance of the motor is R = 0.1 Ω and total losses are Pf = 400 W. On the motor nameplate it says U = 280 V and P = 2850.0 W. a) Determine the power developed in the rotor: b) Determine the mechanical power delivered by the engine: c) Determine the load torque at the specified load: d) What is the efficiency of the engine:
A coil formed by winding 4 turns of thick copper tube has the following dimensions: diameter of each turn D = 50 mm, outer diameter of tube d = 6.0 mm. The conductivity of the copper is σ = 5.0 × 107 Ω-1 m-1. Estimate the resistance of the coil at a frequency of 13.6 MHz
In the figure below, R1 =10.0kΩ, R2 =15.0kΩ, C=0.40μF, and the ideal battery has an emf E=20.0V. First, the switch is closed until the system reaches steady state; then, the switch is opened at time t = 0 and the capacitor starts to discharge. What is the current in R2 at t = 3.00 ms?
The bolt of lightning depicted in the figure passes 200 m from a 90 turn coil oriented as shown. If the current in the lightning bolt falls from 7.00x106 A to zero in 9.9 μs, (b) what is the average voltage induced in the coil?
The metal rod (shown below) moves to the right on essentially zero-resistance and zerofriction rails at a speed v = 3.0 m/s. The magnetic field B = 0.75T everywhere in the region.a. What is the current through the 5.0-Ω resistor? b. Does the current circulate clockwise or counterclockwise?c. What is the rate at which the resistor produces heat (i.e., the power dissipated bythe resistor)?d. The rod moves 3.0 m/s to the right because an external agent is exerting a constantforce on it to the right. What is the magnitude of this force? e. Use your answer to part (d) to find the rate at which the external agent does workon the rod.f. Discuss the significance of your results for parts (c) and (e).
A motor in normal operation carries a direct current of 0.750 A when connected to a 120 V power supply. The resistance in the motor windings is 17.2 . Determine the following values. (a) While in normal operation, what is the back emf generated by the motor? (b) While in normal operation, at what rate is internal energy produced in the windings? (c) What If? Suppose that a malfunction stops the motor shaft from rotating. At what rate will internal energy be produced in the windings in this case in kW (Most motors have a thermal switch that will turn off the motor to prevent overheating when this occurs.)
In the diagram below, a rectangular 40 loop coil of width w=10 cm and length l= 14 cm begins in a region with no electric field and then moves to be completely inside a region of uniform B=1.3 T coming out of the page. If this process occurs over a time period of 3 s, what is the magnitude of the induced emf in the coil of wire? a) 0 V b) 0.0061 V c) 0.243 V
In the illustration below, suppose a moving rod is 0.15 m long, the velocity v is 251 cm/s, the total resistance of the loop is 0.030 Ω, and the magnetic field is 4258 G. Find the force acting on the rod. Final answer should be in two (2) decimal places. For the final answer, express the unit in symbols. For example: 5.00 Kelvin should be expressed as 5.00 K DO NOT answer in exponential form Units are case sensitive, sample units: N/m, degree C, m^2 Round your answer into the nearest 2 decimal place.
A PMMC instrument has a coil area 12 mm X 10 mm. The flux density in the airgap is 1.5 m wb/m² and the spring control is 0.12 μ N-m / rad. i) Determine the number of turns required to produce an angular deflection of 90 degrees when a current of 5 mA is flowing through the coil. ii) Determine the current through the coil if turns are 100, Flux density is 1 wb/m and spring constant is 240 x 10 μ N-m.