A 1.36-mF capacitor is connected to a North American electrical outlet (AV = 120 V, f = 60.0 Hz). Assuming the energy stored in the capacitor is zero at t = 0, determine the magnitude of the rms current in the wires at t = 174 S. Your response differs from the correct answer by more than 10%. Double check your calculations. A Need Help? Read It

A 1.36-mF capacitor is connected to a North American electrical outlet (AV = 120 V, f = 60.0 Hz). Assuming the energy stored in the capacitor is zero at t = 0, determine the magnitude of the rms current in the wires at t = 174 S. Your response differs from the correct answer by more than 10%. Double check your calculations. A Need Help? Read It

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 80AP: In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a...

See similar textbooks

Similar questions

Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
A 20.0 HZ, 16.0 V source produces a 2.00 mA current when connected to a capacitor. What is the capacitance?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
What is the capacitance of an oscillating LC circuit if the maximum charge on the capacitor is 1.60 mC and the total energy is 140 mJ?
In an RLC circuit assume that R =5.00 , L =60.0 mH, fd = 60.0 Hz, and m = 30.0 V. For what valuesof the capacitance would the average rate at which energy isdissipated in the resistance be (a) a maximum and (b) a minimum?What are (c) the maximum dissipation rate and the corresponding(d) phase angle and (e) power factor? What are (f) the minimum dissipation rate and the corresponding (g) phase angle and (h) power factor?
• A 4.40@mF and an 8.80@mF capacitor are connected in parallel to a60.0-Hz generator operating with an rms voltage of 115 V. What isthe rms current supplied by the generator?
Suppose the amplitudes of the voltages are VC0=29.2 volts, VR0=25.3 volts, and VL0=39 volts. Calculate the amplitude of the voltage source.