. A 40 kg block is resting on an inclined plane making an angle of 20 deg. from the horizontal. If the coefficient of friction is 0.6, determine the force parallel to the incline that must be applied to cause impending motion down the plane.

. A 40 kg block is resting on an inclined plane making an angle of 20 deg. from the horizontal. If the coefficient of friction is 0.6, determine the force parallel to the incline that must be applied to cause impending motion down the plane.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter4: Dynamics: Force And Newton's Laws Of Motion

Section: Chapter Questions

Problem 22CQ: Ina traction setup a broken bone, with pulleys and rope available, how might we be able to Increase...

See similar textbooks

Related questions

Q: A rectangular block weighing 196N is being pulled along the floor with a force of 50N by means of a…

Q: What horizontal force P can be applied to a 100-kg block in a level surface with coefficient of…

Q: LEM REFER TO FIGURE E, • The body on the 42* incline in is acted upon by a force P inclined at 25°…

A: Given The angle at which the force P is applied is θ=25°. The parallel component of the Force P is…

Q: Using the system shown below, what would be the maximum mass, M, that can be supported by the…

Q: If an 80kg block is on an inclined plane (at 40 degrees), how do you find the magnitude and…

A: Given data: The mass of the block, m=80 kg. The angle of inclination of the slope, θ=40°. The…

Q: A rope making 1 ¼ turns around a stationary horizontal drum is used to support a heavy weight. If…

A: Given data: Number of turns is, n=114=54 turns. Coefficient of friction is, μ=0.4. Force is, F=50…

Q: A 30 kg box lies stationary on top of a 40 degree inclined plane. If the static friction is 189.172…

A: According to the Newton's second law Net force = mass x acceleration

Q: WITH FRICTION Find the minimum mass of ml in kg, in order to maintain the system to a state of…

A: To maintain the system at an equilibrium the net force on the system and on the blocks must be zero.

Q: A flatbed truck is supported by its four drive wheels, and is moving with an acceleration of 7.9…

A: Given : a=7.9 m/s2 g=9.8 m/s2a → given accelerationg→acceleration due to gravity

Q: If the coefficient of static friction between the 13 kg block and the surface on vhich it rests is…

A: For equilibrium net force acting on body must be zero and horizontal as well as vertical forces must…

Q: 300 mm H.W Blocks A and B have a mass of 7 kg and 10 kg, respectively. Using the coefficients of…

Q: What horizontal force must be applied to a 2150 N boulder to achieve horizontal acceleration of…

A: First find the mass of the boulder, and the use mathematical expression for Newton’s second law to…

Q: Ablock of weight 25 kg is resting on an inclined surface with dimensions of 4 meter wide and 3 m…

A: 2. Axes rotated 37° clock wise. Fx=Ff-mgsinθ=Ff-25×9.8sin37=Ff-245sin37 The above equation is…

Q: A mover needs to push a couch up an inclined ramp that makes 21o with the horizontal. If the couch…

A: Given Data: The mass of couch is, m=70 kg The coefficient of kinetic friction is, µ=0.22 The angle…

Q: The block shown is pulled across the horizontal surface at a constant speed by the force shown. If M…

A: Given M = 6.0 kg F = 15 N θ= 37o

Q: Find the tensions Tl and T2 when m 10 kg and 0= 30 degrees, given zero friction

Q: Determine the friction between the block and the plane in the figure and P the coefficient of…

A: Draw the free-body diagram of the system. Determine the force P.

Q: The block shown is pulled across the rough horizontal surface at a constant speed by the force…

Q: What force is needed to pull a 75 N box up a 35 degree incline at a rate of 1.5 m/s^2, if the…

A: Given : Mass of the box, mg = 75N Inclination of hill, θ = 35o Rate of acceleration, a = 1.5 m/s2…

Q: A 15.0 kg block is resting on an incline making 25.0° with the horizontal. What force is necessary…

Q: A worker is standing on a scaffold supported by a vertical rope at each end. The scaffold weighs…

A: Given Weight of scaffold W=185N Length of scafold L=3.35 m Weight of worker w=717 N Distance from…

Q: A 5.00 kilogram kerosene lantern is lowered down a 56.0 m deep and dark well, starting from rest at…

Q: Using the system shown below, what would be the maximum mass, M, that can be supported by the…

Q: Both Part Please

A: Let the forces can be resolved into parallel and perpendicular components. The net perpendicular…

Q: A 400 kg block is resting on an inclined plane making an angle of 20° from the horizontal. If the…

A: Mas of block: m = 400 kg Angle of inclination: Coefficient of friction:

Q: The drawing shows a per- son (weight, W = 584 N) doing push-ups. Find the normal force exerted by…

Q: Body A has a weight/force of 441.45N and the coefficient for Body A, Body B and ramp C is 0.10. What…

Q: Fig 1. shows a block W suspended by two light inextensible strings which are inclined at 30° and 60°…

A: Equilibrium condition demands net force acting on the system is zero. There are three forces acting…

Q: Pulling the string on a bow back with a force of 29.0 lb, an archer prepares to shoot an arrow.If…

A: Consider the forces acting where the arrow is held. The string has a tension T on both sides of the…

Q: Our 10kg mystery box rests on a horizontal floor. The coefficient of static friction is 0.40and the…

Q: A 330.4-lbm crate on the top of a 24.73-degree inclined plane is held by a horizontal cable attached…

A: Given: The mass of the crate is 330.4 lbm. The angle of the inclination is 24.73o. The free-body…

Q: A rope ABCD is looped over two pipes as shown. Knowing that the coefficient of static friction is…

Q: A steel beam is suspended from two ropes as it is lifted to the top of a building at a constant…

A: T1 = 722 N θ1 = 25.2oθ2 = 29.5oLet the mass of beam = m

Q: Two forces F,1 and F, act on a 3.60-kg object. F, = 30.0 N and F, = 10.0 N. 90.0° 60.0° m (a) Find…

Q: A person is pushing a wheelbarrow along a ramp that makes n angle a = 43.0° with the horizontal. The…

A: For equilibrium of object horizontal as well as vertical forces must be balanced.

Q: During most of the stance phase of the gait, the knee flexion is less than 20º. What force must the…

A: Given: Weight of the patient, w = 836N Distance from line of joint to center of gravity, d = 5 cm…

Q: A block of mass m = 1 kg is found on an inclined plane that makes an angle 30° with the horizontal.…

A: Given: The mass of the block is 1 kg. The angle of inclination is 30°. The coefficient of kinetic…

Q: A transmission tower is held by three guy wires anchored by bolts at B shown in Fig. 5. If the…

A: Given:- A transmission tower is held by three guy wires anchored by bolts at B, C, and D, as shown…

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 47.2 degrees with respect…

A: Answer (2) 11.57Kg Solution

Q: An object weighing 4.5kg originally suspended cord is pulled by a horizontal force until the cord…

A: for equilibrium net force acting on object must be zero .

Q: A 0.85 kg block of wood is stationary on an incline that is15◦above horizontal. A force of 3.0 N is…

A: Here normal force acting on block N = mgCos15° + 3 N = .85×9.8×Cos15° + 3 = 11.05 N Now, for…

Q: To hang a 6.20-kg pot of flowers, a gardener uses two wires—one attached horizontally to a wall, the…

A: Consider the free body diagram:

Q: O Arlene is to walk across a "high wire" strung horizontally between two buildings 20.0 m apart. The…

Q: A 10.0 kg mass is at rest on a board inclined at an angle of 30.0o above the horizontal. The mass is…

A: The expression for the net force at equilibrium,

Question

Help me with this one asap pls

5. A 40 kg block is resting on an inclined plane making an angle of 20 deg. from the
horizontal. If the coefficient of friction is 0.6, determine the force parallel to the
incline that must be applied to cause impending motion down the plane.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Ina traction setup a broken bone, with pulleys and rope available, how might we be able to Increase the force along the tibia using the weight? (See Figure 4.30) (Note that the tibia is the shin bone shown in this image.) Figure 4.30 A leg is suspended by a traction system in which wires used to transmit forces. Frictionless pulleys crw.ge the direction of the force T without changing Its magnitude.
Show that the acceleration of any object down an incline where friction behaves simply (that is, where fk=kN ) is a=g(sinkcos). Note that the acceleration is independent of mass and reduces to the expression found in the previous problem when friction becomes negligibly small (k=0).
A 5.00 [kg] block is pushed by a 30.0 [N] force against a rough wall that is inclined at an angle of 70°. What should be the minimum coefficient of static friction μsμs so that the block will not slide down the ramp?
A horizontal force of 85.2 N is applied to a 44.5 kg crate on a rough, level surface. if the crate accelerates at 1.13 m/s^2, what is the magnitude of the force of kinetic friction (in N ) acting on the crate?
A 5.00 kg block is pushed by a 30.0 N force against a rough wall that is inclined at an angle 70◦. What should be the minimum coefficient of static friction µs so that the block will not slide down the ramp?
A 0.85 kg block of wood is stationary on an incline that is15◦above horizontal. A force of 3.0 N is being applied toit 75◦below horizontal, directly into the incline (the force isperpendicular to the incline). What is the minimum coefficientof static friction required to keep the block stationary?
A 12kg slab is being dragged across a dirt path with an applied force of 300N, and has a net acceleration of 5m/s^2. What is the coefficient of static friction between the slab and the ground?
9. A 250 lb block is initially at rest on a flat surfacethat is inclined at 30o. If thecoefficient kinetic friction is 0.30 and the coefficientof static friction is 0.4. 9._____ Find the force required to start the block movingup the inclined plane.
Compute the acceleration of body B, and the tension in each cable supporting each block. wA= 200 N, wB= 300 N. Coeff friction is 0.2 DRAW FBD
A rubber block with a mass of 10 kg is on a surface that has a coefficient of static friction (µs) of 0.8. What is the minimum force needed to get it moving? If the surface is inclined to an angle of 30º, will the block slip?
A box with a mass of 9.52kg, is on a ramp with an incline of angle of 23.10°. What is the coefficient of static friction?
A 50.0 kg box is being pushed along a level floor with a force of 440N. If the coefficient of kinetic friction is uk = 0.25, what the accleration of the box?