. Determine the shear and moment in the floor girder as a function of x. Draw the shear and moment diagrams for the beam shown. FN lb/ft 6 ft 6 ft B MN lb/ft

Q: Concrete is required for a column that will be moderately exposed to freezing and thawing. The cross…

A:

Q: Using Three Moment Equation. Draw the Shear and moment diagram. Please Show Complete Solution…

A: Three Moment Equation : Three moment equation gives the relation between bending moments at three…

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…

A:

Q: Determine change in volume of the block.

A: Given data, Steel block is subjected to a, hydrostatic pressure is=10 MPaYoung's modulus=150…

Q: Determine the Aeration Basin Dimensions for a town of 30,000 population. Mixed Liquor  Suspended…

A:

Q: Determine the forces in members BC and CG. The forces are positive if in tension, negative if in…

A:

Q: problem : Check whether the depth of a cantilever beam in the following dequate for controlling…

A:

Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…

A:

Q: 2000 lb A 20¹ Determine the internal force on: B 1000 lb D Member AB positive (+) if Tension and…

A:

Q: A small shallow lake with a surface area of 180 hectares had the following average values of…

A:

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…

A:

Q: Find reynolds number of the

A: Given data; Water flows through a pipe having an, Inner radius,r=20 mm Rate of,m= 42…

Q: Two uniformly distributed loads of w = 3500 lb/ftact on the simply supported beam shown in Figure A.…

A: Find maximum bending compressive and tensile stress for BC.

Q: -0.13 Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data  h1 = 24 in h2 = 11 in Length of seepage (L) = 100 in

Q: A sailboat moving in the direction shown is tacking to windward against a north wind. The log…

A:

Q: 1. Given are the stations and elevations of a proposed symmetrical parabolic highway curve. POINT A…

A: Stations and elevations of a proposed symmetrical parabolic highway curve are given, It has been…

Q: إلا 1.4 m A = 50 mm^2 E = 200 Gpa A 1000 KG block 4 m COMPUTE stresses at A and B and vertical…

A:

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…

A:

Q: Determine the minimum flow capacity Qfilter, in units of liter per minute (Ipm), of the return line…

A:

Q: the road stretch (in vehicles/h) is

A: Given data, Average free flow speed,V=60 km/hJam density on a road, ρj=120 vehicles/kmFor a linear…

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…

A:

Q: 2 Refer to Figure 10.43. A strip load of q = 1450 lb/ft² is applied over a width with B = 48 ft.…

A:

Q: Answer carefully the following questions : 1-What is the effect on physical properties of cement, if…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The 99-lb force P is applied to the 240-lb crate, which is stationary before the force is applied.…

A:

Q: 7-What is the effect of aggregate grading on the properties of concrete? 8-Describe kinds of slump…

A: Answer 7. Effect of aggregate on the properties of concrete.

Q: Explain why costs of copper and other materials continue to increase

A: Copper is used in our daily life for a variety of purposes such as in electrical equipment. It’s…

Q: .A rectangular open channel has a width of 5m and a bed slope of 0.001. For a uniform flow of depth…

A:

Q: A 100mm* 40 mm* 20 mm steel block is subjected to a hydrostatic pressure of 10MPa. The Young's…

A:

Q: Answer carefully the following questions : 1-What is the effect on physical properties of cement, if…

A: This question is related to Building Material from Civil Engineering. In this question ask about…

Q: The 75-lb force P is applied to the 160-lb crate, which is stationary before the force is applied.…

A:

Q: NOTE: COMPLETE SOLUTION. SHOW ALL OF THE FREE BODY DIAGRAMS USED. Find the support reactions 9m 6m…

A:

Q: Calculate the change in 5 m long copper wire when its temperature changesby 60º C.

A:

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A:

Q: 1. A bar of 16-mm in diameter is only allowed to decrease at a maximum of 4.84% of its total length.…

A:

Q: If 2% solution of a sewage sample is incubated for 5 days at 20 degrees and depletion of oxygen was…

A: Given data, Percentage of sewage sapmle solution= 2% Dissolved oxygen, At 20°c = 5PPM Bod5=?

Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…

A:

Q: 4.5 m 3.2 m ↓ A B C D 24 kN E

A: Given: P= 24KN To Find: The force in member AC  is____  kN. The force in member CE  is____  kN. The…

Q: 6. The infinite sand slope shown in the figure is one the verge of sliding failure. The ground water…

A:

Q: what was the error in 30 meter

A: Solution: Givendata, distance between two station with 20 m chain D'= 1500 m distance between two…

Q: What is the head loss in pipe due to friction over the length of 30 km, if the diameter of pipe is…

A:

Q: 7.5 m B 2.5 m 6m 7m $3 Lift shaft 8m SA S5 S6 LL = 3 KPa Floor Finishes = 1.20 KPa fc'= 20.7 MPa…

A: Types of Slab : Two types of slabs which are considered while designing a structure are : One way…

Q: Determine the force in member CG. The force is positive if in tension, negative if in compression.…

A: Given, F1= 10kips F2= 13kips F3= 13kips Find, force in member CG.

Q: Which of the triangles are ill-conditioned and should be avoided in Triangulation surveys?

A: Given data, Four triangles of an interior angles are given, Find the triangles are ill- conditioned…

Q: The water-cement ratio (in percent, round off to the lower integer) to be used in the mix

A: Given data, Characteristic Compressive strength C=25 MPaObserved compressive strength,σ=4 MPaRatio…

Q: Determine the magnitude of the pin force at A. Assume W = 795 lb, a = 3.9 ft, b = 2.8 ft, r = 7 in.…

A:

Q: n electric motor M is used to reel in cable and hoist a bicycle into the ceiling space of a garage.…

A:

Q: Determine the outside diameter of the shaft?

A: Given data,  Determine the outside diameter of the shaft ?Where,   Shaft length,L= 1m Power…

Q: Determine the MAXIMUM SHEAR and MAXIMUM MOMENTS for using SHEAR AND MOMENT DIAGRAMS OR BY ANALYTICAL…

A:

Q: a 5

A: Using equation of the throw :P=Ls224RLs=length of the spiral =14.6mR=1719D

Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…

A:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.