0 ⁰C came into contact with material B with initial temperature of 15 ⁰C. What are the scenario/s that would likely to happen? W. Temperature of material B will be above 80 ⁰C X. Entropy of material A will increase Y. Energy transfer is from ma

Q: A rocket motor is operating steadily, as shown in Fig. P3.34.The products of combustion fl owing out…

A:

Q: A fixed volume insulated tank, which was initially empty, was connected by a valve to a distribution…

A:

Q: Thermodynamic Keys Second Law 91. A closed system undergoes a process in which the work is done by…

A: A close system undergoes a process in which the work is done by the system on the surroundings and…

Q: QUESTION 6 (12 pts) Steam enters a turbine at 120 bar and 400°C. At the exit, the pressure and…

A:

Q: Helium enters a continuous flow compressor at 336 K and leaves at 451 K. If the mass flow rate is…

A: Given that, Entering temperature of helium, Ti=336 K,Exit temperature of helium, To=451 K,Mass flow…

Q: One of the assumptions is not used in derivation of Bernoulli's equation?       a)compressible flow…

A: Solution:

Q: Heat and the first law of thermodynamics. Several types of gas equations of state are as follows: a…

A:

Q: Heat and the first law of thermodynamics. types of gas equations of state are as follows: a %3D…

A:

Q: An apple loses 3.6 kJ of heat as it cools per °C drop in its temperature. The amount of heat loss…

A: heat loss of apple 'Q'= 3.6 KJ            △Q△T=3.6 KJC°

Q: gas type B at temperature [(19/7) T,) . The tanks are then put into thermal contact with each other…

A:

Q: When a system undergoes a Isochoric process (P = 5 bar), the change in internal internal is 5 kJ and…

A: Isochoric Process: the process in which the volume of the process is constant throughout the process…

Q: A rigid tank of 1 m³ contains nitrogen gas (N2) at 600 kPa, 127 °C. By mistake someone let 0.5 kg of…

A: Given data as per question volume of the tank = 1 m3 The pressure of gas =600 kpa  The temperature…

Q: The first law of thermodynamics discusses a. Thermal equilibrium b. Energy conservation Direction of…

A: Note:  As per the policy of company, I supposed to answer first question. You can repost the…

Q: 2. In the engine of a car that uses petrol as fuel, when the piston is at its highest position, air…

A: Given:P1=10 barT1=100°CT2=1500°C

Q: Two persons A and B are served with 150 gm of hot (90°C) tea in cups and they are provided with cold…

A: Given: Mass of hot tea→mh=150 gm=0.15 Kg Temperature of hot tea→Th=90°C Temperature of cold…

Q: thermodynamics In order to describe the state of the water using the pure substance tables given…

A: As per our guidelines we are supposed to answer only 3 sub-parts if there are multiple sub-parts are…

Q: true or false Entropy is not a property

A:

Q: Evaluate the Nusselt number of Air at 100C (k=0.0307 W/mK). Let D=1m, V=1m/s and hc = 3W/m^2 K

A: Given data: D=1 mhc=3 W/m2Kk=0.0307 W/mK Need to determine the Nusselt number of Air.

Q: The higher the absolute temperature of a system, the smaller the increase in its entropy produced by…

A:

Q: When a system undergoes a Isochoric process (P = 5 bar), the change in internal internal is 5 kJ and…

A: First Law of thermodynamics: The first law of thermodynamics states that "Energy can never be…

Q: 4.3 Consider the semiclassical model of N particles with twoenergy levels (0 and e > 0). As in the…

A:

Q: When a system undergoes a constant volume process (P = 5 bar), the change in internal internal is 5…

A: First law of thermodynamics: The first law of thermodynamics states that "Energy can never be…

Q: A process occurs spontaneously and AS system 0 b. ASuniverse > 0 O c. The pressure is constant. d.…

A: Solution:

Q: A closed rigid container has a Volume of 1 m^3 and holds air at 344.8 kPa and 273 K. Heat is added…

A:

Q: While walking along the beach, a person sees a dented aluminum can whose mass is 100 grams. The can…

A: Calculate change in entropy of universe.

Q: Choose the correct statement/s with respect to entropy change during a process Entropy increases…

A:

Q: Q2: : Which statements are true for source of requirements and which are false? If false, please…

A: Solution:

Q: 53. An 8.00-L sample of gas at 99.0 kPa and 25 deg C is compressed. What is its final pressure at 25…

A:

Q: 4. Four (4) moles of helium gas undergo the following cyclic process (A→B¬C→A). If 1 atm = 1.0 x 105…

A:

Q: If 250(ft)3(s) of air at 122(°F) and approximately atmospheric pressure is preheated for a…

A: Convert the unit of the flow rate of the combustion chamber (Q) from feet cube per second to meter…

Q: An adiabatic process cannot decrease the entropy of a closed system. a) True b) False

A: adiabatic process is a process in which no heat in or out from system .

Q: The following data is obtained during a test on a steam boiler: Steam generation rate Steam pressure…

A: Given: steam generation rate=6.3 tonne/hr=6300 Kg/hr steam pressure=10 bar Quality of steam→x=0.95…

Q: When a system undergoes a constant volume process (P. 5 bar), the change in internal internal is 5 k…

A:

Q: 2. P (N/m) 500- 400 300- 200 B 100+ V (m) 10 20 30 40 50 60 70 80 One mole of an ideal gas is sealed…

A: Dear student,                    According to the guidelines I am allowed to answer only three…

Q: 5. In a T-s diagram, how are the isentropic and actual processes represented. Please select all…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Choose the correct statement/s with respect to entropy change during a process a. Entropy…

A: Entropy change during a process

Q: Choose the true statement       A)Clausius statement talks about refrigerators/heat pumps…

A:

Q: During their experimentation, a group of engineering students employed an unknown substance with a…

A:

Q: By burning a fuel, the rate of heat release is 500 kW at 2000 K. What would 07 be the first law and…

A:

Q: Which of the following statement(s) is(are) correct? Group of answer choices A. The actual work is…

A: The solution is given under:

Q: In the boiler of a steam engine the superheated steam is at 500 degrees Celsius and 20 mPa is…

A: The best gas regulation, additionally called the overall gas condition, is the condition of…

Q: 0.03m* of air s initially at 206°C and 7 bar is expanded at constant pressure to 0.09m? the followed…

A: Entropy: Entropy is the ratio of heat transfer to the temperature. The change in entropy can be…

Q: 5) A fluid fits the following equation of state.   a= 10-3 m 3K/(bar*mol) ve b = 8*10-5 m 3 /mol…

A:

Q: Air is to be compressed steadily and isentropically from 1 atm to 18 atm by a two stage compressor.…

A: Intermediate pressure  for minimum work can be calculate by  √(p1p2)  P= √(p1p2) P = √(1 ×18)  P =…

Q: Q. The thermodynamic parameters are 1. Temperature 2. Specific volume 3. Pressure 4. Enthalpy 5.…

A: Given  The thermodynamic parameters are 1. Temperature 2. Specific volume 3. Pressure 4. Enthalpy 5.…

Q: Entropy is one of the important coordinates in thermodynamics.  Entropy shows the ratio of heat…

A: given; Cv=c1+T*c2where;c1 and c2 cosntant.

Q: Question 1: The PV diagram shown below applies to 2.1 moles of an ideal diatomic gas. (a) (b)…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.