Answered: 03/ For the circuit shown in figure…

03/ For the circuit shown in figure (2), by using mesh anal ysis, 1- Find the current through the (10 2) resistor? 2-Calculate the power dissipated in (5 2) ? 10 hon- %3D %3D -50 15 V 1 2 Figure(2)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 79AP: Consider the circuit shown below. (a)Determine the equivalent resistance and the current from the...

See similar textbooks

Related questions

Q: 17. A commercial printer uses an average power of 400 W while printing. If its total resistance is…

Q: ap www wwww (V,) (V2) A А V R 2 = 130 N connected as shown in the figure. Estimate the values shown…

A: Given values:- Resistance,(R1)=740 Ω ----(1) Resistance,(R2)=130 Ω ----(2) Potential difference…

Q: Assume that the capacitor has been charged by the battery. What do you think will happen to the…

Q: 4. For approximately the same maximum voltage, what happened to the maximum current resistors added…

Q: Electromotive Force: Terminal Voltage• Compare and contrast the voltage and the electromagnetic…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 3. In a circuit, a variable resistor is to be connected across a potential difference of 60 V to…

Q: During electric interruption, what is being lost? Is it the voltage source, electric current or…

A: During electric interruption, what is being lost? We know that the Computer systems and other…

Q: Integrated Concepts Hydroelectric generators (see Figure 20.43) at Hoover Dam produce a maximum…

A: a) The expression for output power is P=VI Substitute values in the above equation…

Q: 67. You're estimating costs for a new power line with your compa- ny's financial group. Engineering…

A: Given resistance 50mohm/km Density of copper =8.9g/cm^3 Density of aluminum =2.7g/cm3 Cost of…

Q: 2. In the circuit shown in Figure 2, solve the given circuit to find the current through 3 2…

A: We have to apply thevenin and Norton theorem here

Q: Why is the usage of Kirchhoff's Laws instrumental in the study of electricity? Isn't the knowledge…

Q: Small household electrical devices, such as vacuum cleaners, televisions, and floor lamps, each draw…

A: In series combination, the current is the same while the voltage is different across the circuit…

Q: 8. The negative terminal will be connected to METER PLUKE 79 SEEE OFF Hz PLESS 4on RANGE on 10A COM…

A: To answer the given question regarding multimeter.

Q: Determine the power dissipated in R1 if the current flowing through R2 is 0.62 = 11.5 Ohms, R2 =…

A: Since two resistance connected in serise so same current flow through R1

Q: 8. Find the circuit as shown, determine istance between terminals a & b. Open with -

A: Note: As per the guidelines, we can only answer first question of multiple question. Sorry for the…

Q: 14- Referring to the circuit below, should we connect the float switch as normally open or normally…

Q: 11- chapter27-question5 An ordinary light bulb is marked "6ow, 120V". Its resistance is(in 2):…

Q: 87. The capacitor in the flash of a disposable camera has a value of 160 µF. What is the resistance…

A: for RC series circuit charging capacitor Q=Q0 (1-e-t/RC ) where Q0 =maximum charge which can be…

Q: chapter28 In Figure, the ideal batteries have emfs & = 150 V and E = 50 V and the resistances are R…

A: Remember: If we are going in from negative terminal of battery to positive terminal, then use +ve…

Q: 32. An electronic device designed to operate at anytemperature in the range from –10.0ºC to 55.0ºC…

A: Given: range of temperature = -10o to 55o C. thermal constant of carbon = 0.5×10-3 /oC.

Q: 10 Ω 10 mH 25 μF w = 100sin(2000t)

Q: 6. (II) Suppose that you have a 580-n, a 790-N, and a 1.20-kn resistor. What is (a) the maximum, and…

A: in this question we connect resistance for maximum and minimum resistance.

Q: 7. In a portable speaker, only 16A of current pass through a copper wire. If the speaker is operated…

A: Write the given values with the suitable variables. I=16 AV=9 V Here, I and V are the current and…

Q: 20. Consider the voltage phasor diagram of an AC circuit shown below. What is the value of the…

A: Answer is option A)60V

Q: (2) What scenario or situation was the defibrillator compared to? Give evidence.

A: A defibrillator is a machine that delivers a high energy electric shock to a person who is…

Q: Current causes the temperature of a real resistor to increase. Why? What effect does this heating…

A: Current causes the temperature of a real resistor to increase because:

Q: 4 - In the circuit with the resistors R1, R2, and a DC power source, 20 V is observed from the…

A: We need to calculate the current through the ampermeter.

Q: 9:49 I O 種78%画 4GË Tap circuit element to edit. PKET : Circuit Construction Kit: DC Lab So, we have…

A: Electric potential or potential energy of battery is divided equally among all the bulbs only when…

Q: 8. How are ammeters and voltmeters used to measure electrical properties in circuits? (Which…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 77. If electric power is transmitted over long distances, the resistance of the wires becomes…

A: We will only answer the first question since the exact question to be answered was not specified.…

Q: 16- What is the value of the ampermeter in the given circuit? NOTE: The internal resistances of the…

Q: Integrated ConceptsA prankster applies 450 V to an 80.0 μF capacitor and then tosses it to an…

A: The expression for the energy stored in a capacitor, UC=12V2C

Q: 5) The circuit in Figure 3 is powered by a 30 V power source and utilizes three voltmeters and four…

Q: 5. During the Christmas season, Sel Erbate uses the equivalent of 45 strings of 100 mini-bulbs to…

A: Number of strings (N)= 45 Number of mini bulbs in each string (n) = 100 Power rating of each string…

Q: 11. If It = 8 amperes in the circuit in Fig 5-14, find Eg and 13. a. Eg b. 13 12. For the circuit in…

Q: Digital meters are able to detect smaller currents than analog meters employing galvanometers. How…

A: Digital meters are able to detect smaller currents than analog meters.

Q: 56. What is the maximum voltage that can be applied to a 10-k 2 resistor rated at W

A: Solution: Given that R = 10000 ohm P = 0.25 W By the Power formula we know that: Power (P) = V2 /…

Q: (LO-4) What is the current which is seen on ammeter in circuit given below? 3 ohm 1 ohm 2 ohm A 4…

Q: 5-Two resistors of resistances R and 2R are connected in parallel to an ideal battery. If the Power…

A: Power dissipated in a resistor in terms of voltage is given by the relation P…

Q: 12. Integrated Concepts. A prankster applies 450 V to an 80.0 µF capacitor and then tosses it to an…

A: Given: The voltage is V=450 V. The mass is m=0.2 g. The capacitance is C=80 uF. Also, the specific…

Q: 36. To protect an expensive circuit component from being delivered too much power, you decide to…

A: Given:To protect an expensive circuit component from being delivered too much power,Now,The minimum…

Q: What is the cause of power dissipation in the circuit? Explain and why?

A: Power dissipation occurs when the device produces unwanted heat released due to inefficient in the…

Q: 7. Most household circuits in North America use 120 V, wh in Europe 240 V is most commonly used.…

A: When Edison invented bulb, he used 3 lines +110 v, 0v, -110v. He used dc voltage than ac voltage as…

Q: 5) What happens to the reading of the ammeter if you reverse the connections? The voltmeter?

A: The ammeter has a very low resistance , which can pull of a large amount of current from voltage…

Q: 5. How would the current divide in a parallel branch of a circuit containing two resistorsD and R,…

Q: 8. One light bulb in the kitchen burns out and suddenly several lights go out in the house. This…

Q: 6) If we double the resistance in a circuit but keep the current in it constant, the power…

A: Given data, Final Resistance(R2)=2×Initial Resistance (R1) Final Current(I2)=Initial Current (I1)

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

03/ For the circuit shown in figure (2), by using mesh analysis,
1- Find the current through the (10 2) resistor?
2- Calculate the power dissipated in (5 2) ?
10 n
3
15 V
1
2
:20
Figure(2)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The temperature in Philadelphia, PA can vary between 68.00F and 100.00F in one summer day. By what percentage will an aluminum wire’s resistance change during the day?
Integrated Concepts A short circuit to the grounded metal case of an appliance occurs as shown in Figure 23.60. The person touching the case is wet and only has a 3.00 k(resistance to earth/ground. (a) What is the voltage on the case if 5.00 mA flows through the person? (b) What is the current in the short circuit if the resistance of the earth/ground wire is 0.200 ? (c) Will this trigger the 20.0 A circuit breaker supplying the appliance? Figure 23.60 A person can be shocked even when the case of an appliance is grounded. The large short circuit current produces a voltage on the case of the appliance, since the resistance of the earth/ground wire is not zero.
Knowing that the severity of a shock depends on the magnitude of the current through your body, would you prefer to be in series or parallel with a resistance, such as the heating element of a toaster, if shocked by it? Explain.
Analog meters use a galvanometer, which essentially consists of a coil of wire with a small resistance and a pointer with a scale attached. When current runs through the coil, the point turns; the amount the pointer turns is proportional to the amount of current running through the coil. Galvanometers can be used to make a voltmeter if a resistor is placed in series with the galvanometer. Consider a galvanometer that has a resistance of 25.00 and gives a full scale reading when a 50A current runs through it. The galvanometer is to be used to make an voltmeter that has a full scale reading of 10.00 V, as shown below. Recall that a voltmeter is connected in parallel with the component of interest, so the meter must have a high resistance or it will change the current running through the component, (a) What is the potential drop across the series resistor in the meter? (b) What is the resistance of the parallel resistor? Av = lo.oo v
Before World War II, some radios got power through a “resistance cord" that had a significant resistance. Such a resistance cord reduces the voltage to a desired level for the radio’s tubes and the like, and it saves the expense of a transformer. Explain why resistance cords become warm and waste energy when the radio is on.
Referring to the example combining series and parallel circuits and Figure 10.16, calculate in the followingtwo different ways: (a) from the known values of Iand I2 (b) using Ohm’s law for R2 In both parts, explicitlyshow how you follow the steps in the Problem-Solving Strategy: Series and Parallel Resistors.
What are the largest and smallest resistances yon can obtain by connecting a 36.0- , a 50.0- , and a 700- resistor together?
Suppose you are using a multimeter (one designed to measure a range of voltages, currents, and resistances) to measure current in a circuit and you inadvertently leave it in a voltmeter mode. What effect will the meter have on the circuit? What would happen if you were measuring voltage but accidentally put the meter in the ammeter mode?
During open-heart surgery, a defibrillator can be used to bring a patient out of cardiac arrest. The resistance of the path is 500 and a 10.0-mA current is needed. What voltage should be applied?
Integrated Concepts Use the ECG in Figure 20.34 to determine the heart rate in beats per minute assuming a constant time between beats. Figure 20.34 A lead II ECG with corresponding arterial blood pressure. The QRS complex is created by the depolarization and contraction of the ventricles and is followed shortly by the maximum or systolic blood pressure. See text for further description.
Nichrome wire is used in some radiative heaters. (a) Find the resistance needed if the average power output is to be 1.00 kW utilizing 120-V AC. (b) What length of Nichrome wire, having a cross-sectional area of 5.00mm2, is needed if the operating temperature is 500°C ? (c) What power will it draw when first switched on?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M resistor to 90.0% of its final voltage.