1 2 Ra 1.2 k C 31 100 F Fig 1.1 R-16 !2 8-40

Q: Given two thermal generating units. For an accuracy of 1.8 MW, and two iterations were performed…

A: First iteration resultssecond iteration resultsNote: Here initial values of P1 and P2  () are not…

Q: us 202 voz inge του us vas mo n suoh зол

A: It is given that:

Q: . Rea L Rea www 2 Ω 8 Ω Μ 15Ω 20 Ω 10 Ω 30 Ω Μ 10 Ω 40 Ω

A:

Q: Given the circuit below: Iin (w) jwI m Tout (w) R₁ www R₂ 1 jwC (a) Solve for the frequency response…

A:

Q: Both transistors shown in the figure below have K = 100μA/V2 and Vto = 0.5 V. Determine the value of…

A: Given data K=100 μA/V2 Vt0=0.5 V iD1=0.2 mA To find out We have to determine the value of Vx for…

Q: Describe the operation of a power factor correction capacitor and its role in improving power…

A: A power factor correction capacitor is an electrical device used to improve power efficiency in…

Q: Design a logic circuit for decoder that accepts 3-bit input and displays alphabet "387" at the…

A: The decoder circuit needs to be designed so that the number 387 is displayed in the 7 segment for…

Q: Consider the system shown in figure (1). Design a compensator network Ge(s) that the static velocity…

A: The static velocity error constant for a system is defined as Kv =lims →0sG(s) where G(s) is the…

Q: Construct the Bode plot for the phase of the following transfer function. 100(je + 1) (jo) (jo+10)…

A:

Q: M a R₁ R₂ R3- Figure 2.1a: KVL Series Circuit E A Vab a R₁ VE I b R₂ www R3 (Vbc Ved Figure 2.1b:…

A: The above question is based on DC circuit analysis.Power delivered/absorbed by an element of voltage…

Q: In the circuit shown in Fig.5, the magnitude circuit impedance is 15/0° V 1₁=2mA R I=1.5mA

A: Given circuit diagram is,

Q: A signal that has the highest frequency component of 4.2MHz and a peak to peak value of 4 volts is…

A: here we have to find the code word length and bitrate and output signal to quantization noise ratio.

Q: Question 2 Given the following standard SOP Boolean function F(A,B,C,D) whereby A is the Most…

A:

Q: Assume that all transmission lines LOW and HIGH limitation capacity is limited to 70MW. Given the…

A: Giventransmission line limit capacity =70 MWinitial loadingLine 1-2 =48 MWLine 1-5 =68 MWto find…

Q: 5 A discrete-time system can be (1) Static or dynamic (2) Linear or nonlinear (3) Time invariant or…

A: Since, the question posted by you has multiple sub-parts, we will solve the first three sub-parts…

Q: 好 2 以 认 以 2K 試 认 张 Vo

A:

Q: In cylindrical coordinates, let p = 0 for p 1.5 mm. Find D everywhere: ly

A: Electric/Displacement flux density Electric flux lines is always perpendicular to the displacement…

Q: QUESTION 4 Q4.1 Show how can a series RLC can be used as a crude band-reject filter? Q4.2 How would…

A: Band reject filter:-If the overall position of the interference in the frequency plane has been…

Q: Using the 74LS00 NAND gate chip, construct the circuit in the schematic and complete the…

A:

Q: 10 If x(n) = {1, 1, 1, 1} and h(n) = {2,0,0,2} ↑ a) Determine the output of system 1 what will be…

A:

Q: Charge 1: -5 microcoulombs Charge 2: 8 microcoulombs Force: 427.47 Newtons Determine the distance…

A:

Q: 4. In the circuit in figure, write the system of the mesh method and find i2. 10 2 40 V 10 WWW + Vo…

A:

Q: Ques: Find current in 1.12. resienter using Norton's theorem 184(1) 5-42 Tsh UF www Birz www DE

A: It is given that:

Q: 2₁ Z₁ 92 Z₂ Z₂ 3 93 U₁ = 10 V 93 =j5 A Z₁ = 10 +j10 Q Ξ, =j10 Ω 2 Ξ=-j5 Ω 2₁ = ? 2₂ = ? Výsledky…

A:

Q: Binary data is transmitted using ASK through a channel that adds AWGN with power spectral density…

A: here we have to find the amplitude of the received carrier signal.

Q: For the following discrete time system, the system frequency response is and the system function can…

A: y(n) is the convolution of x(n) and h(n) .y(n)= ∑k=-∞k=∞x(k)h(n-k) y(n)= x(n)*h(n)

Q: V₁ Ri V2 R + + R Vo=?]

A: Given: An op-amp circuit,  To find: The value of V0.

Q: 4- A system has the unit sample response h(n) given by h(n) = 8(n) +8(n-1) a) Find the frequency…

A: Given :To determine:

Q: The h parameters of the first two-port circuit in figure 3 are h₁=10002;h₂=5×10 *;h₂=40;h₂2-25 µS…

A:

Q: Question 4: Implement the following boolean expression using (1) primitive logic gates (AND, OR),…

A: The given boolean expression needs to be implemented by using the AND and OR gates , NAND Gates and…

Q: There is a parallel plate capacitor. The gap between the two conducting plates is filled with a…

A: Given:When the gap between two conducting plates is filled with a vacuum the capacitor capacitance…

Q: a) Find the electric field on the z axis produced by an annular uniform surface charge density p. in…

A: given that ring occupies in z = 0 regionand surface charge density -

Q: The oscilloscope has an input capacitance of 50 pF and a resistance of 2 MΩ and the voltage divider…

A:

Q: 6V 0,2K Τ 0.004 U 251 Find the U value in the circuit. 40K U10K

A: Circuit is given,

Q: How many address lines are required for 4 kB memory addressing Your answer

A: The given memory is 4kB.

Q: Figure 1 shows a potentiometer used to measure the displacement and velocity of an elevator. The…

A:

Q: 1. Calculate the value of drain current in the circuit below. (W = 5 μm, L= 0.5 µm and λ = 0) VDD= 3…

A: given that W=5 um and L=0.5um for an nmos given in the circuit, to find drain current

Q: 2.An open circuit test was performed on a 150 kVA, 1200V/600V single phase transformer. Applying 600…

A:

Q: Create the K-Map for the logic tables below: a. ABF 000 0 1 0 101 1 1 1

A:

Q: What is the voltage in Volts across the resistors where I=71, R1-2,493, and R2=3,165? | R1 R2

A:

Q: A 60 KW, 240V compound DC generator (as shown in the figure), has the given parameters: Rse=0.01 2,…

A:

Q: An electric field in free space is given as E = râ₂ + 4zây + 4yâ.. Given V(1, 1, 1) = 10 V.…

A:

Q: Example 3 Find the Thevenin equivalent of the circuit in Fig. 11 as seen from terminals a-b. 4Ω j3 Ω…

A: In Thevenin circuit the network is replaced by Thevenin's voltage in series with Thevenin's…

Q: V₁ = 120° p.u. jXj0.1 p.u. JX2)/0.1 p.u. JX) 10.15 p.u. V₂ - 120° p.u. j0.2 p.u. JX(1) 1 JX2) 0.2…

A: Positive, negative and zero sequence data of the given circuit are provided based on that we can…

Q: A 762 KVA. 2200V. 50Hz.three-phase.star- connected alternator has an effective resisance of 0.6 ohm…

A:

Q: Q5: 10 Calculate the electric potential due to a tiny dipole whose dipole moment is 4.3×100 Cm at a…

A: The dipole moment, P=4.3×10-30 Cm The distance of point,  r=4.1 nm=4.1×10-9 m

Q: A 400 kV transmission line is having per phase line inductance of 1.2 mH/km/phase and line…

A: It is given that: V=400 kVL=1.2 mHkmphC=12 nFkmph

Q: (a) Draw the small signal equivalent circuit assuming that the capacitors are short circuits for the…

A:

Q: You measure an electric field of 1.25 × 106 N/C at a distance of 0.150 m from a point charge. What…

A: E =electric field =1.25 x 106 N/Cr = 0.15 mWe need to find electric flux?

Q: Number 4 Number 5

A: The above question pertains to the operation of a simple motor.As requested, only parts 4 and 5 are…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.