(1) A signal m(t) band-limited to 3kHz is sampled at a rate 100/3% higher than the Nyquist rate. The maximum acceptable error in the sample amplitude (the maximum quantization error) is 0.5% of the peak amplitude mp. The quantized samples are binary coded. Find the minimum bandwidth of a channel required to transmit the encoded binary signal. If 24 such signals are time-division- multiplexed, determine the minimum transmission bandwidth required to transmit the multiplexed signal.

(1) A signal m(t) band-limited to 3kHz is sampled at a rate 100/3% higher than the Nyquist rate. The maximum acceptable error in the sample amplitude (the maximum quantization error) is 0.5% of the peak amplitude mp. The quantized samples are binary coded. Find the minimum bandwidth of a channel required to transmit the encoded binary signal. If 24 such signals are time-division- multiplexed, determine the minimum transmission bandwidth required to transmit the multiplexed signal.

Modern Physics

3rd Edition

ISBN:9781111794378

Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Publisher:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Chapter5: Matter Waves

Section: Chapter Questions

Problem 23P

See similar textbooks

Similar questions

Check Your Understanding Suppose that the diameter of the aperture in Example 6.16 is halved. How does it affect the resolving power?
If STM is to detect surface features with local heights of about 0.0200 nm, what percent change in tunneling-electron current must the STM electronics be able to detect? Assume that the tunneling-electron current has characteristics given in the preceding problem.
The binding energies of K-shell and L-shell electrons in copper are 8.979 and 0.951 keV, respectively. If a Ka x ray from copper is incident on a sodium chloride crystal and gives a first-order Bragg reflection at an angle of 74.1° measured relative to parallel planes of sodium atoms, what is the spacing between these parallel planes?
An unknown material was ground to a fine powder and subjected to x-ay diffraction measurement using a Bruker V8 system with Cukα radiation with wavelength λ= 1.452 Å. The following 2θ values were recorded: 28.5o, 47.4o, 56.1o, 28.5o, 69.1o, and 76.2o. Calculate the d spacing associated with each peak and Identify the miller indices for each XRD peak.Calculate the lattice parameter of this material assuming that it has a cubic structure then state what is this material.
A 50 cm long dipole is excited by a sinusoidally varying current with an amplitude I0 =5 A. Determine the total radiated power if the oscillating frequency is: (a) 1 MHz, (b) 300 MHz.
Can an incoming intercontinental ballistic missile bedestroyed by an intense laser beam? A beam of intensity108 W/m2 would probably burn into and destroy a nonspinningmissile in 1 s. (a) If the laser had 5.0 MW power, 3.0 mm wavelength,and a 4.0 m beam diameter (a very powerful laser indeed),would it destroy a missile at a distance of 3000 km? (b) If thewavelength could be changed, what maximum value would work?Use the equation for the central diffraction maximum as given byEq. 36-12 (sin u = 1.22l/d).
A beam of 2.0-keV electrons incident on a crystal is refracted and observed (by transmission) on a screen 35 cm away. The radii of three concentric rings on the screen, all corresponding to fi rst-order diffraction, are 2.1 cm, 2.3 cm, and 3.2 cm. What is the lattice-plane spacing corresponding to each of the three rings?
Solve the following, if a television signal (video and audio) has a bandwidth of 4.5MHz, this signal is sampled, quantized, and binary coded to obtain a PCM signal. I. If the signal is to be sampled at a rate 30% above the Nyquist rate, then sampling rate?II. If the samples are quantized into 2048 levels, determine the number of binary pulses required to encode each sample.III. Determine the binary pulse rate (bits per second) of the binary-coded signal.IV. Minimum bandwidth required to transmit this signal. V. Find the channel capacity using Nyquist rule.VI. Find the SNR using Shannon rule.
It is stated without proof with respect to Bragg’s law that when the atoms are not sym- metrically disposed to the incident and reflected beams (Fig. 8.3(b)), the path difference (AB + BC) = 2dhkl sin θ . Prove, using very simple geometry, that this is indeed the case.
A 0.500kg block rests on the frictionless, icy surface of a frozen pond . if the location of the block is measured to a precision of 0.150 cm and its mass known exactly,what is the minimum uncertainty in the block's speed?
During the deep X-ray therapy high energy X-rays are used. They are filtered by passing themthrough copper and aluminium plates. If the copper plate has thickness ?1 = 1 mm and aluminiumplate ?2 = 5 mm, find reduction in X-ray beam intensity. Linear attenuation coefficients for copperand aluminium are ?1 = 0,32 cm –1, and ?2 = 0,15 cm –1, respectively.
Calculate the minimum uncertainty in the position of the 25-g bullet from Sample if the uncertainty in its velocity is (a) ±1 percent and (b) ±0.01 percent.