this is a thermodynamics question thank you already 1) Considersteampowerplantoperatingon the sinmpleidealRankinecycleSteamenterstheturbine2mPaatand360 °Candiscon denreolinthecondensera pressureatof 0.8 mpa.a) DeterminethenetworkdonebJ Determinethermal efficiency ofthis cycletheO.8O isentropicpump oparatenet work andatturbineandthethermalefficiency.thecaloulateefficiencybe neplecteowillnotThepumpwork

Given:P1=2 MPaT1=360°CP2=0.8 MPa

Answered: 1) Consider ideal Rankine and ar Jo09…

1) Consider ideal Rankine and ar Jo09 of 0.8 mpa. a) Determine th bJ Determine c)If the c)if turb efficiency cal The pump wor

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Isochoric: A reversible non-flow, constant volume process decreases the internal energyby 316.5 KJ for 2.268 kg of a gas for which R= 430 J/(kg –k) and k= 1.35. Forthe process, determine a. the work b. Q and c. ∆S The initial temperature is204.4 0 C.
A gas turbine with reheat has a TIT of 1230°C, a compressor pressureratio of 16, and compressor and turbine efficiencies of 0.88 and 0.91,respectively. The pressure ratios of both the HP and LP turbine stages arethe same. The reheat occurs up to a temperature of 1230°C. The compressor inlet conditions are 20°C and 1.01 bar. The fuel mass flow rate may beignored.Determine (a) the pressures and temperatures at all real states of thecycle, (b) the turbine and compressor specific works and their ratio, and(c) the cycle thermal efficiency.
Air enters the compressor of a gas-turbine engine at 300 K and 100 kPa, where it is compressed to 700 kPa and 580 K. Heat is transferred to air in the amount of 950 kJ/kg before it enters the turbine. For a turbine efficiency of 86 percent, determine: (a) the fraction of turbine work output used to drive the compressor, (b) the thermal efficiency. Assume: (a) variable specific heats for air. (b) constant specific heats at 300 K.Ans: 52.7%, 27.0%; 50.1%, 29.6%
Wet steam at 200 o C and 20 % moisture is compressed in an irreversible adiabaticthe process to a pressure of 2.5 MPa and 250 o C. Determine: a) actual work ofcompression, b) compression efficiency, c) irreversibility, d) internal reheat.
At the beginning of a cycle using air, the pressure, volume and temperature are 550 kN/m 2 , 0.025 m 3 and 15°C, respectively. The air is heatedat constant pressure until the temperature is 204°C. It is then expanded adiabatically until the temperature becomes 120°C. The air is cooled atconstant volume to a temperature of 15°C then restored to its original volume by isothermal compression. (a) Draw the pressure volume and temperature entropy diagram.(b) Determine for the cycle, the heat received,(c) the work done,(d) the thermal efficiency, Take Cp =1.00 kJ/kgK, Cp /Cv =1.4
Saturated steam at 0.16 MPa is compressed in an irreversible adiabatic process with an efficiency of 80.24%.For a final pressure of 0.45 MPa, determine (a) the final and initial entropies and (b) the ideal and actual temperatures of compressed steam. Ans. (a) 7.2 kJ/kg• K, 7.3 kJ/kg•K; (b) 220°C, 244°C.
[ENGLISH UNIT]Three pounds of a perfect gas with R=38 ft.b / (lb.R) and K=1.667 have 300 BTU of heat added during a reversible non flow constant pressure change of state. The initial temperature is 100 ℉. Determine the a) Final Temperatureb) Change of enthalphyc) Workd) Change of Internal Energye) Change of Entropy
COMPLETE SOLUTION. FINAL ANSWER ARE IN ENGLISG SYSTEMS. DRAW A DIAGRAM IF NECESSARY. A gaseous Ammonia actuates a Carnot power cycle in which the respective volumes at the four corners of the cycle, starting at the beginning of the isothermal expansion, are V1 = 12, V2 = 15, V3 = 330.25 and V4 = 264.20. Determine (a) the overall expansion ratio and (b) the thermal efficiency.
Wet steam at 200°C and 20% moisture is compressed in an irreversible adiabatic process to a pressure of 2.30 MPa and a temperature of 225°C. Determine (a) the work of compression, (b) the compression efficiency, (c) the irreversibility of the process, and (d) the compression internal reheat. Ans. (а) 413.49 kJ/kg; (b) 33.3%; (с) 0.71018 kJ/kg•K; (d) 275.73 kJ/kg
23. A 5.2m3 tank contains nitrogen, which is evacuated from 100kPag to a pressure of 98kPagvacuum. Determine the mass of pumped out nitrogen if initially the temperature is 510K and thefinal temperature is 100K.a. 6.3274kg b. 5.8802kg c. 6.4656kg d. 6.2169kg
Steam at 1.2 MPa and 500 C undergoes isentropic ( S=C ) expansion process. For mass flow of 2.5 kg/s and final state after expansion is saturation, determine the following: a) Plot the T-S diagram completely & properly labeled b) Approximae final pressure of steam c) Approximate final temperature of steam d) Work (W) , is it input or output? e) Heat (Q), is it added or rejected? Note: There is NO need to interpolate ( get the approximate reading of properties)
Air enters the compressor of a gas-turbine engine at 300 K and 100 kPa, where it is compressed to 700 kPa and 580 K. Heat is transferred to air in the amount of 950 kJ/kg before it enters the turbine. For a turbine efficiency of 86 percent, determine: (a) the fraction of turbine work output used to drive the compressor, (b) the thermal efficiency.Assume: constant specific heats at 300 K.Ans: 50.1%, 29.6%