Q.51 Digital communication system consists of:Information source emitting symbols S₁, S5 with rate fs= 800 [symb/s].Symbol probabilities are:St$1 S2 $3 SAp(s) 0.29 0.24 0.21 0.14 0.07$55/102. Binary encoder performing Huffman coding.3. Channel can be considered as a binary symmetric channel. Total error probability is0.18.i) Draw the system block-scheme.ii) Find the entropy and the source information rate.iii) Find the average code word lengh at the encoder output, code efficiency and thecompression ratio in the obtained code.iv) Find the probability of ones and zeros at the encoder output.v) Find the channel capacity if the source emites the symbols with maximum possible(allowed) rate.

Since you have posted a question with multiple subparts, we will solve the first three parts for…

1 Digital communication system consists of: 0.51 Information source emitting symbols $₁,...,Sg with rate fs 800 [symb/s]. Symbol probabilities are: St $1 $2 S3 SA $5 p(s) 0.29 0.24 0.21 0.14 0.07 3/10 2. Binary encoder performing Huffman coding. 3. Channel can be considered as a binary symmetric channel. Total error probability is

1 Digital communication system consists of: 0.51 Information source emitting symbols $₁,...,Sg with rate fs 800 [symb/s]. Symbol probabilities are: St $1 $2 S3 SA $5 p(s) 0.29 0.24 0.21 0.14 0.07 3/10 2. Binary encoder performing Huffman coding. 3. Channel can be considered as a binary symmetric channel. Total error probability is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

By using BPSK modulation from a communication channel, voice transmission is made at a data rate of 240 kbps. However, due to the low speed, it is desired to increase this rate to 3*240 kbps, but to keep the bandwidth constant while this process is being done. In order to do this, which and how many levels of modulation should be preferred. ( Binary data rate of 3 * 240 kbps transmitted per second, symbol rate should be obtained to provide the same bandwidth as modulation.)
1) What is the bit rate that is transmitted by this coder in bits/second? A PCM coder performs an analog‐to‐digital conversion, then transmits the encoded signal over a digital network to a receiver running an equivalent PCM decoder. The PCM encoder runs under the following specifications:- It samples incoming analog signals at 200,000 samples/sec.- It performs uniform quantization on the PAM samples using a –3.2 volt to +3.2 volt scale and 5‐bit quantization
1. a. Create the gray code representation of the following binary numbers.i) 01011 ii) 10110 iii) 01101 iv) 11001 b. If a computer’s system clock is 2.7 GHz, calculate the period of the system clock. c. What is the minimum sampling rate needed in order to successfully capture frequencies up to 60MHz in an analog signal? d. Represent the number 1.00011011101 x 2-23in IEEE Standard 754 single precision floating point binary.
The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What will be the minimum bandwidth required for ISI free transmission?
Computer Science In a binary system, bits "1 and 0" are transmitted as signals S,(t)- A volt within 0 st ST. Given that p(s₂) = p(5₂) = 1/2. N/2=10-9 W/Hz, A= 10mv and the transmission rate (bit rate) is 104 bits/sec. the probability of error is??
Please provide a complete solution and explain how did you get the answer thank you. For 16-PSK and a transmission system with a 10 kHz bandwitdth, determine the maximum bit rate.
Q31)The bit rate for American PCM-24 system is a. 2.048 Mb/s b. 1.544 Mb/s c. 8 kb/s d. 64 kb/s This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
Design 2-bit synchronous counter that counts 0, 1, 2, 3 in succession. Thank you.
If the sequence 111111 is transmitted using Differential Manchester encoding. what is the ratio of the baud rate (D) to the bit rate (R)?
Design a circuit to realize the function ? = ∏?(0,1,5,7) using a decoder with inverted outputs
For the source coding What is/are the benefit(s) of calculating entropy?
In a baseband digital communication system, communication is made with pole coding at -1 V and +5 V levels. There is a noise sign of ? ~ ? (0.1) in the channel. It is also given the information that (? = 0) = 0.4. In this case, find the decision threshold that will give the buyer the lowest probability of error. Calculate the total error probability of the system for this decision threshold.