1) The walls of a house are 11 cm thick and have an average thermal conductivity two times that of cork. The walls' surface area is 850000 cm2 and their inside surface is at 18 °C, while their outside surface is at 4°C. (Thermal conductivity of cork is 0.036 W/m°C). Calculate, (i) The rate of heat conduction through house walls in Watts: (ii) Amount of heat conducted in Joules, in 5 min:

1) The walls of a house are 11 cm thick and have an average thermal conductivity two times that of cork. The walls' surface area is 850000 cm2 and their inside surface is at 18 °C, while their outside surface is at 4°C. (Thermal conductivity of cork is 0.036 W/m°C). Calculate, (i) The rate of heat conduction through house walls in Watts: (ii) Amount of heat conducted in Joules, in 5 min:

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 97P: Compare the rate of heat conduction through a 13.0-cm-thick wall that has an area of 10.0 m2 and a...

See similar textbooks

Similar questions

Suppose you stand with one foot on ceramic flooring and one foot on a wool carpet, making contact over an area of 80.0 cm2 with each foot. Both the ceramic and the carpet are 2.00 cm thick and ale 10.0 on their bottom sides. At what rate must heat transfer occur from each foot to keep the top of the ceramic and carpet at 33.0 ?
One easy way to reduce heating (and cooling) costs is to add extra insulation in the attic of a house. Suppose a single-story cubical house already had 15 cm of fiberglass insulation in the attic and in all the exterior surfaces. If you added an extra 8.0 cm of fiberglass to the attic, by what percentage would the heating cost of the house drop? Take the house to have dimensions 10 m by 15 m by 3.0 m. Ignore air infiltration and heat loss through windows and doors, and assume that the interior is uniformly at one temperature and the exterior is uniformly at another.
A firewalker runs across a bed of hot coals without sustaining burns. Calculate the heat transferred by conduction into the sole of one foot of a firewalker given that the bottom of the foot is a 3.00-mm-thick callus with a conductivity at the low end of the range for wood and its density is 300 kg/m3. The area of contact is 25.0 cm2 the temperature of the coals is 700 , and the time in contact is 1.00 s. Ignore the evaporative cooling of sweat.
Consider the latent heat of fusion and the latent heat of vaporization for H2O, 3.33 105 J/kg and 2.256 106 J/kg, respectively. How much heat is needed to a. melt 2.00 kg of ice and b. vaporize 2.00 kg of water? Assume the temperatures of the ice and steam are at the melting point and vaporization point, respectively. (a). UsingEq21.9, Q = mLF = (2.00 kg) (3.33l05 J/kg) = 6.66105 J (b).UsingEq21.10. Q = mLV = (2.00kg) (2.256106 J/kg) = 14.51106 J
To help prevent frost damage, 4.00 kg of water at 0 is sprayed onto a fruit tree. (a) How much heat transfer occurs as the water freezes? (b) How much would the temperature of the 200-kg tree decrease if this amount of heat transferred from the tree? Take the specific heat to be 3.35k J/kg. , and assume that no phase change occurs in the tree.
An underground gasoline tank can hold 1.00 103 gallons of gasoline at 52.0F. If the tank is being filled on a day when the outdoor temperature (and the gasoline in a tanker truck) is 95.0F, how many gallons from the truck can be poured into the tank? Assume the temperature of the gasoline quickly cools from 95.0F to 52.0F upon entering the tank.
The height of the Washington Monument is measured to be 170.00 m on a day when the temperature is 35.0 . What will its height be on a day when the temperature falls to -10.0 ? Although the monument is made of limestone, assume that its coefficient of thermal expansion is the same as that of marble. Give your answer to five significant figures.
Two concrete spans that form a bridge of length L are placed end to end so that no room is allowed for expansion (Fig. P16.63a). If a temperature increase of T occurs, what is the height y to which the spans rise when they buckle (Fig. P16.63b)?
At 25.0 m below the surface of the sea, where the temperature is 5.00C, a diver exhales an air bubble having a volume of 1.00 cm3. If the surface temperature of the sea is 20.0C, what is the volume of the bubble just before it breaks the surface?
A high-end gas stove usually has at least one burner rated at 14 000 Btu/h. (a) If you place a 0.25-kg aluminum pot containing 2.0 liters of water at 20.C on this burner, how long will it take to bring the water to a boil, assuming all the heat from the burner goes into the pot? (b) Once boiling begins how much time is required to boil all the water out of the pot?
Compare the rate of heat conduction through a 13.0-cm-thick wall that has an area of 10.0 m2 and a thermal conductivity that of glass wool with the rate of heat conduction through a 0.750-cm-thick window that has an area of 2.00 m2, assuming the same temperature difference across each.
Most automobiles have a coolant reservoir to catch radiator fluid than may overflow when 1he engine is hot. A radiator is made of copper and is filled to its 16.0L capacity when at 10.0C. What volume of radiator fluid will overflow when the radiator and fluid reach their 95.0C operating temperature, given that the fluid’s volume coefficient of expansion is =400106/C ? Note that this coefficient is approximate, because most car radiators have operating temperatures of greater than 95.0C.