1. A circuit is composed of a 12V battery source and a network of resistors. The network is connected in such a way that a 1 ohm and 2 ohms resistance in parallel is connected in series with a 6 ohm resistance and another parallel connection of 3 ohms, 4 ohms and 5 ohms. Find the total current drawn by the circuit.

1. A circuit is composed of a 12V battery source and a network of resistors. The network is connected in such a way that a 1 ohm and 2 ohms resistance in parallel is connected in series with a 6 ohm resistance and another parallel connection of 3 ohms, 4 ohms and 5 ohms. Find the total current drawn by the circuit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter33: Single-phase Motors

Section: Chapter Questions

Problem 1PA

See similar textbooks

Similar questions

In an R-L parallel circuit, ET=480 volts, R=16, and XL=24. Find PF.
Find the current flowing in the 4-ohm resistor using Thevenin's Theorem. Show complete solution.
Find the current at the 10 ohm resistor using thevenin theorem. Show complete solution.
Given the circuit below. Determine the total resistance. Show complete solution
The resistance of each brake light bulb on an automobile is 4.9 . Use the fact that cars have 12-V electrical systems to compute the current that flows in each bulb if they are connected in series. ( for simplicity, assume that the circuit is only composed of one brake light bulb and the car battery) A
3. Given the network below, find the current through a 12-ohm resistor, power at a 4-ohm resistor, the voltage at a 5-ohm resistor, and current through of 5- ohm resistor.
How many nodes are present in the circuit given below? Mark all the nodes, and identify theessential nodes and the non-essential nodes. Using only Ohm’s Law, KVL, and/or KCL (you cannot use theconcept of equivalent resistance) find the current through all elements in the circuit, find the voltage drops acrossall elements in the circuit, assign polarities to voltage drops across all circuit elements. Find all node voltages.Show that KVL holds true for the loop.
Recreate the series-parallel network in Tinkercad, then calculate and measure the total resistances.
Determine the Norton's Equivalent circuit for the network external to the resistor R in the given circuit then find the current through the resistor R if its value is 20 ohms, 50 ohms, and 100 ohms. Without have the Norton's equivalent circuit, what would you have to do to find the current through the resistor R for all the values above?
Solve the direct current circuit given below by writing the node voltages and ambient currents methods and the circuit equations separately. Calculate the node voltages V1, V2 and V3 and the currents and powers of the resistors for both methods. Give all the results in a table
Determine the current in the 5Ω resistance of the network shown in the image using DC circuit theories. Hence find the currents flowing in the other two branches.
If we measure the voltage at the terminals of a two-terminal network with two known (anddifferent) resistive loads attached, we can determine the Thévenin and Norton equivalentcircuits. When a 2.2-kΩ load is attached to a two-terminal circuit, the load voltage is 4.4 V. When the load is increased to 10 kΩ, the load voltage becomes 5 V. Find the Thévenin voltage and resistance for this circuit.