1. A copper pipe of length 15.4 m and inside diameter of 1.34 cm runs from your hot water heater to your kitchen sink. In preparation for cooking some pasta, you turn on the hot water tap and note that the water starts to become warm after 6.90 s. After the water is hot, you begin to fill a pot with hot water. How long does it take for 3.54 L of hot water to pour into the pot?

1. A copper pipe of length 15.4 m and inside diameter of 1.34 cm runs from your hot water heater to your kitchen sink. In preparation for cooking some pasta, you turn on the hot water tap and note that the water starts to become warm after 6.90 s. After the water is hot, you begin to fill a pot with hot water. How long does it take for 3.54 L of hot water to pour into the pot?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 13PE: (a) How much heat transfer is required to raise the temperature of a 0.750kg aluminum pot containing...

See similar textbooks

Similar questions

A high-end gas stove usually has at least one burner rated at 14 000 Btu/h. (a) If you place a 0.25-kg aluminum pot containing 2.0 liters of water at 20.C on this burner, how long will it take to bring the water to a boil, assuming all the heat from the burner goes into the pot? (b) Once boiling begins how much time is required to boil all the water out of the pot?
In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
(a) How much heat transfer is required to raise the temperature of a 0.750kg aluminum pot containing 2.50 kg of water from 30.0C to the boiling point and then boil away 0.750 kg of water? (b) How long does this take if the rate of heat transfer is 500 W 1watt=ljoule/second(lW=lJ/s) ?
In an air conditioner, 12.65 MJ of heat transfer occurs from a cold environment in 1.00 h. (a) What mass of ice melting would involve the same heat transfer? (b) How many hours of operation would be equivalent to mailing 900 kg of ice? (c) If ice costs 20 cents per kg, do you think the air conditioner could be operated more cheaply than by simply using ice? Describe in detail how you evaluate the relative costs.
A microwave oven is used to heat 250 g of water. On its maximum setting, the oven can raise the temperature of the liquid water from 20°C to 100°C in 1min 45 s(=105s) (a) At what rate does the oven put energy into the liquid water?(b) If the power input from the oven to the water remainsconstant, determine how many grams of water will boil awayif the oven is operated for 2 min (rather than just 1 min 45 s).
1. How long (in seconds) will it take to heat 40 kg of water from 40°C to 80°C with a 20-kW immersion heater? Assume no energy is lost to the environment and specific heat of water is 4.186 kJ/kgoC. 2. The heat of vaporization of water is 2260 kJ/kg and the heat of fusion of water is 335 kJ/kg. Use the specific heat of water is 4.186 kJ/kg·oC 2a) How much energy (in kJ) will it take to raise the temperature of water (15 kg) from 0°C to 100oC? 2b) How much energy (in kJ) would it take to then completely convert the water to steam? 3. You want to raise the temperature of 22kg of water from 60°C to 95°C. If electricity costs $0.08/kWh, how much would it cost you to use an electric heater for this process? Use the specific heat of water is 4.186 kJ/kgoC and 1 kJ = 0.00028 kWh.
The heat required to melt a block of ice is 1165500 J. Estimate the total heat required to vaporize the same mass of water that is at 50 °C. ( Cwater = 4186 J/kg.°C, Lf = 3.33 × 105 J/kg, and Lv = 2.26 × 106 J/kg.)
1. If 60 kJ of heat energy are added to 2 kg of water at 30°C, what will be the final temperature of the water? The specific heat of water is 4186 J/kg·°C. 2. How long (in seconds) will it take to heat 40 kg of water from 40°C to 80°C with a 20-kW immersion heater? Assume no energy is lost to the environment and specific heat of water is 4.186 kJ/kgoC. 3. The heat of vaporization of water is 2260 kJ/kg and the heat of fusion of water is 335 kJ/kg. Use the specific heat of water is 4.186 kJ/kg·oC 3a) How much energy (in kJ) will it take to raise the temperature of water (15 kg) from 0°C to 100oC? 3b) How much energy (in kJ) would it take to then completely convert the water to steam? 4. You want to raise the temperature of 22kg of water from 60°C to 95°C. If electricity costs $0.08/kWh, how much would it cost you to use an electric heater for this process? Use the specific heat of water is 4.186 kJ/kgoC and 1 kJ = 0.00028 kWh.
A 8.2 kg block of copper is dropped at 80 ° C into a container with 0.62 L of water at 10 ° C. How much energy in the form of heat is absorbed by the water when the copper and water reach thermal equilibrium?
How many grams of coffee must evaporate from 500 g of coffee in a 140g glass cup to cool the coffee from 95.0°C to 41.0°C? You may assume the coffee has the same thermal properties as water and that the average heat of vaporization is 2340 kJ/kg (560 cal/g). (You may neglect the change in mass of the coffee as it cools, which will give you an answer that is slightly larger than correct.)
A giant, hot (323oC) sphere of copper is placed into the middle of Space where it radiates heat as a black body radiator. The sphere has a radius of 0.50 meters and a mass of 4660 kg. Assuming copper has emissity of 0.8, how long will it take for the giant ball of carbon to drop 2oC (Csp=0.385 J/g*C =385 kJ/Kg*C)