1. Calculate the lc in figure below with beta = 80 Vcc= 12 V ३1. 550k Select one: O a. 0.174mA O b. 1.75mA O c.0.164mA O d. 1.64mA € 1.5k

Q: Sketch v, for the network Vi 20 V -20 V [ Vo 91Ω V₂ = 8 V 0.22 ΚΩ

A: We need to find out the output voltage for given circuit

Q: 1. Determine the following for the network shown below: *Use Mathematical Approach a. ID b. VGS c.…

A:

Q: A dc series motor drives a load a 30revs and takes a current of 10A when the supply voltage is 400V.…

A:

Q: A current of 10 A flows in a coil having 125 turns. If the coil inductance is 50 mH, the flux…

A:

Q: Determine the amplitude of the line current in a three-phase system with a line voltage of 300 V…

A: In a three-phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: blanks: be consumed by the Ho The two windings of a transformer is linked Three phase synchronous…

A:

Q: Figure 9.5 28H) L2 10. Given the delta-delta system of Figure 9.5, if the generator phase voltage is…

A: As the given system is balanced three phase system, we can do the calculations on per phase system.…

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Transfer function is also known as a network function . In a transfer function theoretical model…

Q: The flux linking to 200 turns coil changes from 2 mWb to 5 mWb in 1ms to 3 ms. Determine the induced…

A:

Q: A circuit is constructed with four resistors, one capacitor, one battery and a switch as shown. The…

A: We know that , Current flows only in closed circuit and doesn't flow in open circuit.

Q: Determine V, for the network Si 4.7 ΚΩ +12 V o V₂₁ GaAs 3.3 ΚΩ - 10 V

A:

Q: 1. An electric field of 8.50 x 105 V/m is desired between two parallel plates, each of area 35.0 cm2…

A:

Q: The _________(i)____________ is a diactor and the saturable reactor or magnetic amplifier provide…

A: Integrating fluxmeter is a diactor and the saturable reactor or magnetic amplifier provide automatic…

Q: Use the voltage-division principle to find the voltages labeled in Figure 2.14. R-5Q www +91 R₂-100…

A:

Q: 5. Find the input impedance at 20 krad/s for the circuit shown in Figure 4. 3mH 200 £2 m 0000 3v |…

A:

Q: What is the voltage induced in the secondary coil of transformer with 400 turns when the varying…

A: We need to find out voltage for transformer and current for given force

Q: A substation rated 1250 kVA is operating at full-load at 0.8 pf lagging and to carry an addition…

A: A substation is a place included in the electrical power generation system where electrical voltage…

Q: How many coulombs are represented by these amounts of electrons? (a) 6.482 x 10¹7 (b) 1.24 x 10¹8…

A: We need to find out the charges for given ammount of electrons

Q: The electro-dynamometer type wattmeter is shown below and assuming the diode to be ideal, the…

A: Given circuit, Primary side supply voltage, Vs=200 V (rms) Secondary side peak voltage, Vm=1002 V

Q: Circuit Diagram R1 50 Q 220 Vrms 60 Hz 0⁰ L1 100mH Computed Values Compute the expected power factor…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: SIGNAL Mention the function or work of each component in the circuit? Rc Cc HH Cin R₁ www. HH www R₂…

A: This is the RC coupled multistage amplifier in which two common emitter amplifiers are cascaded.…

Q: Q15: A given voltage signal f(t) = 4cos²20rt+2cos30nt across 102. (a) Determine PSD of f(t). (b)…

A: We need to find out the power and power spectral density of given signal

Q: VII. Design a counter using a 74HC163 binary counter. diagram. ( (1) The MOD is 5+2=7 (2) If the MOD…

A: The 74HC163 is a binary counter with an in-built look-head bring this is the synchronously preset…

Q: (b) Find V across the load in the AC circuit given in Figure 4.1 (assume that both AC sources have…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: 5) What is IC,max(open), the current that flows through the capacitor whose magnitude is maximum…

A:

Q: The two-wattmeter method produces wattmeter readings P2 = 800 W Wand P1= 560 W when connected to a…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is the current in the 12- 2 resistor when a potential difference of 100 V is applied to the…

A: We need to find out the voltage across 12 ohms resistor for given circuit

Q: What is the importance of a full-wave bridge type power supply and its advantages and disadvantages?

A: Full bridge rectifiers are a type of bridge rectifier that may be used to power a wide range of…

Q: Q2/A Shunt motor having a field resistance of 50 and an armature resistance of 0.5 is connected to a…

A:

Q: The N-type and P-type doping levels of an abrupt P-N junction are ND 1017 cm-3, and NA= = 1015 cm-3.…

A:

Q: A wired baseband digital communications system uses a 100 metres long cable to connect the…

A: Distributed resistance = 1ohm/m Distributed capacitance =100pF/m Frequency response equivalent…

Q: Problem#1 Determine vo in the op-amp circuit shown in Fig. 1 6 V 20 ΚΩ 2 V b 40 ΚΩ 2010

A: Given data,

Q: 6. The power input to the d-e field of a 15-kva (input) synchronous motor is 6 per cent of the rated…

A:

Q: 30. The waveforms in Figure 6-81 are observed on the inputs of a 74HC151 8-input multiplexer. Sketch…

A: When enable(bar) input is low then the multiplexer works. If enable(bar) input is high then the…

Q: Determine Vce in the given circuit if VBB = 10V, VCC = 15V, RB = 10kΩ and RC = 110 Ω. Assume β = 100

A:

Q: Sketch vo for the network and determine the dc voltage available. 100 V Si Ge 4.7 ΚΩ • 2.2 ΚΩ 2.2 ΚΩ…

A: Brief description: For the given question we need to calculate dc voltage and output voltage…

Q: Explain how poles and zeros are important in a feedback control system and t differences between…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. a. Find 11, 12, and Vs b. Find Va, Vb and Vc a 11 12v C + 1 ww 2002 ww 1502 Vs b 12 + 1 2 A www…

A:

Q: S-2 The transfer function of a system G(s) = find the zero-input response, " s²-s-2 assume all…

A: Brief description: In the above given question we need to calculate the value of zero input response…

Q: For the inverter shown in the picture, determine the (a) rms output voltage at the fundamental…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: A doubly-fed actuator has two windings with current i, at the stator and current i at the rotor as…

A: Given  A doubly excited rotating actuator is given.we need to find the correct statement. Please…

Q: 2) A system has transfer function: Y(s) 50 R(s) S+50 Find the time constant, T, the settling time,…

A: In this question we will find time constant , settling time , rise time....

Q: 100/120° V 5Ω www | 100/0° V 5Ω wwwww b 5Ω 100 Z-120° V -j6Ω 8 Ω Β A 10 Ω 4Ω j3 Ω C

A:

Q: Design a sequential circuit with two JK flip-flops, A and B, and two inputs, E and x. If E = 0, the…

A: A sequential circuit is a circuit with a set of inputs and outputs. The prior output is used to…

Q: Explain about time graded and current graded system?

A:

Q: Figure 2.1 shows the circuit diagram of a simple npn BJT common emitter amplifier. Explain the role…

A: Brief description: In the above given question we need to define importance of resistive element RE.…

Q: Determine the current flowing through an element if the charge flow is given by (a) q(t) = (3t+ 8)…

A: In this question we will find current I with related to given charge..... Note :- as per our…

Q: Specify the LM-series linear regulator required to regulate a fixed voltage of -9 V. Please write…

A: To specify the LM series linear regulator required to regulate a fixed voltage of -9 V

Q: write the way to find CMRR with all details and needed comprent Notes G₂ you have to draw the…

A: The Common - Mode Rejection Ratio is abbreviated as CMRR.  The CMRR of an op-amp is used to identify…

Q: The input voltage of a Boost converter is 10V, the duty cycle of the boost converter is 0.25. What…

A: