1. Consider the following reaction, Q + R the rate law for the above reaction: Rate = k [R]? S+T The above reaction was carried out three times and each time initial concentration of R is 2.0 M. The initial concentration of Q in each run is given below: run 1, [Q]= 0.0 M run 2, [Q] =1.0 M run 3, [Q] =2.0 M. Rank the rate of the three runs using each of above concentrations and explain your answer.

1. Consider the following reaction, Q + R the rate law for the above reaction: Rate = k [R]? S+T The above reaction was carried out three times and each time initial concentration of R is 2.0 M. The initial concentration of Q in each run is given below: run 1, [Q]= 0.0 M run 2, [Q] =1.0 M run 3, [Q] =2.0 M. Rank the rate of the three runs using each of above concentrations and explain your answer.

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter11: Chemical Kinetics

Section: Chapter Questions

Problem 5ALQ: Consider the following statements: In general, the rate of a chemical reaction increases a bit at...

See similar textbooks

Similar questions

11.35 For the reaction 2 NO(g) + 2 H?(g) — N,(g) + 2 H,O(g) at 1100°C, the following data have been obtained: [NOJ [HJ Rate = A(N2]/At (mol L~1) (mol L_1) (mol L-1 s_1) 5.0 X 10’1 0.32 0.012 1.0 X 10~’ 0.32 0.048 1.0 X 10"2 0.64 0.096 Derive a rate law for the reaction and determine the value of the rate constant.
The reaction H2SeO3(aq) + 6I-(aq) + 4H+(aq) Se(s) + 2I-3(aq) + 3H2O(l) was studied at 0C, and the following data were obtained: [H2SeO3]0 (mol/L) [H+]0 (mol/L) [I]0(mol/L) Initial Rate (mol/L s) 1.0 104 2.0 102 2.0 102 1.66 107 2.0 104 2.0 102 2.0 10-2 3.33 107 3.0 104 2.0 102 2.0 102 4.99 107 1.0 104 4.0 102 2.0 102 6.66 107 1.0 104 1.0 102 2.0 102 0.42 107 1.0 104 2.0 102 4.0 102 13.2 107 1.0 104 1.0 102 4.0 102 3.36 107 These relationships hold only if there is a very small amount of I3 present. What is the rate law and the value of the rate constant? (Assumethatrate=[H2SeO3]t)
Hydrogen iodide, HI, decomposes in the gas phase to produce hydrogen, H2, and iodine, I2. The value of the rate constant, k, fur the reaction was measured at several different temperatures and the data are shown here: Temperature (K) k (M -1 5-1) 555 6.23107 575 2.42106 645 1.44104 700 2.01103 What is the value of the activation energy (in kJ/mol) for this reaction?
The reaction 2 NO(g) + 2 H2(g) N2(g) + 2 H2O(g) was studied at 904 C, and the data in the table were collected. (a) Determine the order of the reaction for each reactant. (b) Write the rate equation for the reaction. (c) Calculate the rate constant for the reaction. (d) Find the rate of appearance of N2 at the instant when [NO] = 0.350 mol/L and [H] = 0.205 mol/L.
The following statements relate to the reaction for the formation of HI: H2(g) + I2(g) -* 2 HI(g) Rate = it[HJ [I2J Determine which of the following statements are true. If a statement is false, indicate why it is incorrect. The reaction must occur in a single step. This is a second-order reaction overall. Raising the temperature will cause the value of k to decrease. Raising the temperature lowers the activation energy' for this reaction. If the concentrations of both reactants are doubled, the rate will double. Adding a catalyst in the reaction will cause the initial rate to increase.
Nitrogen monoxide reacts with chlorine according to the equation: 2NOCI(g)2NOCI(g) The following initial rates of reaction have been observed for certain reactant concentrations: [NO] (moI/L1) [CI2] (mol/L) Rate (moI/L/h) 0.50 0.50 1.14 1.00 0.50 4.56 1.00 1.00 9.12 What is the rate equation that describes the rate’s dependence on the concentrations of NO and CI2? What is the rate constant? What are the orders with respect to each reactant?
Consider the following statements: In general, the rate of a chemical reaction increases a bit at first because it takes a while for the reaction to get warmed up. After that, however, the rate of the reaction decreases because its rate is dependent on the concentrations of the reactants, and these are decreasing. Indicate everything that is correct in these statements, and indicate everything that is incorrect. Correct the incorrect statements and explain.
A study of the rate of dimerization of C4H6 gave the data shown in the table: 2C4H6C8H12 (a) Determine the average rate of dimerization between 0 s and 1600 s, and between 1600 s and 3200 s. (b) Estimate the instantaneous rate of dimerization at 3200 s from a graph of time versus [C4H6]. What are the units of this rate? (c) Determine the average rate of formation of C8H12 at 1600 s and the instantaneous rate of formation at 3200 s from the rates found in parts (a) and (b).
Consider the following statements: In general, the rate of a chemical reaction increases a bit at first because it takes a while for the reaction to get warmed up. After that, however, the rate of the reaction decreases because its rate is dependent on the concentrations of the reactants, and these are decreasing. Indicate everything that is correct in these statements, and indicate everything that is incorrect. Correct the incorrect statements and explain.
At 40C, H2O2 (aq) will decompose according to the following reaction: 2H2O2(aq)2H2O(l)+O2(g) The following data were collected for the concentration of H2O2 at various times. Times(s) [H2O2](mol/L) 0 1.000 2.16 104 0.500 4.32 104 0.250 a. Calculate the average rate of decomposition of H2O2 between 0 and 2.16 104 s. Use this rate to calculate the average rate of production of O2(g) over the same time period. b. What are these rates for the time period 2.16 104 s to 4.32 104 s?
You are running the reaction 2A+BC+3D. Your lab partner has conducted the first two experiments to determine the rate law for the reaction by the method of initial rates. Experiment Number Concentration of A (M) Concentration of B(M) 1 0.0250 0.0330 2 0.0500 0.0330 3 Presuming that you can measure the initial rate of each experiment, which of the following concentrations for Experiment 3 would help you determine the rate law easily? a [A] = 0.0330 M, [B] = 0.0330 M b [A] = 0.0125 M, [B] = 0.0500 M c [A] = 0.0250 M, [B] = 0.0400 M d [A] = 0.0250 M, [B] = 0.0330 M e [A] = 0.0500 M, [B] = 0.0330 M
Nitrogen monoxide reacts with hydrogen as follows: 2NO(g)+H2(g)N2O(g)+H2O(g) The rate law is [H2]/t = k[NO]2[H2], where k is 1.10 107 L2/(mol2 s) at 826C. A vessel contains NO and H2 at 826C. The partial pressures of NO and H2 are 144 mmHg and 315 mmHg, respectively. What is the rate of decrease of partial pressure of NO? See Problem 13.151.