1. Draw an 8"x8" square cake by slicing it to produce 12 servings 2. Draw an 18X25" rectangular cake and try to produce 48 slices. 3. Draw a 1 pound loaf cake that produces 8 servings 4. Draw a 1 pound loaf cake that produces 10 servings 5. Draw a circle of an 8" layer cake that yields 12 servings 12

1. Draw an 8"x8" square cake by slicing it to produce 12 servings 2. Draw an 18X25" rectangular cake and try to produce 48 slices. 3. Draw a 1 pound loaf cake that produces 8 servings 4. Draw a 1 pound loaf cake that produces 10 servings 5. Draw a circle of an 8" layer cake that yields 12 servings 12

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter1: Introduction To Common Fractions And Mixed Numbers

Section: Chapter Questions

Problem 3A: The circle in Figure 1-5 is divided into equal parts. Write the fractional part represented by each...

See similar textbooks

Similar questions

A welded support base is cut into four pieces as shown in Figure 14. What fractional part of the total length does each of the four pieces represent? All dimensions are in inches. Piece 1: . Piece 2: . Piece 3: . Piece 4: . The circle in Figure I -S is divided into equal parts. Write the fractional part represented by each of the following in Exercises 3 and 4:
Measure the length of the line segment in Figure 40-2 to the nearest fiftieth of an inch (002").
Describe, if possible, how you would inscribe a circle within kite ABCD.
The circle in Figure 1-5 is divided into equal parts. Write the fractional part represented by each of the following in Exercises 3 and 4: 3. a. 1 part. b. 3 parts . c. 7 parts . d. 5 parts . e. 16 parts .
The proportion AB=CDcompares the sides of two triangles like those in Figure 209. Determine the missing values in the table.
Suppose that a circle is divided into three congruent arcs by points A,B, and C. What is the measure of each arc? What type of figure results when A,B, and C are joined by line segments?
Four studs of the following lengths in inches are to be machined from bar stock: 134,178,2516 and 11132 . Allow 18inch waste for each cut and 132inch on each end of each stud for facing. What is the shortest length of bar stock required so that only three cuts are needed?
If the area of the 1200 sector is 40 cm2 and the area of MON is 16 cm2, what is the area of the segment bounded by MN- and MN?
If line segment AB and line segment CD in the accompanying drawing are drawn to scale, what does intuition tell you about the length of these segments?