1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 700 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=2.25m. water oil Y Mercury

1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 700 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=2.25m. water oil Y Mercury

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: 4. The barometer reads 29.0 inches of mercury. What is the absolute pressure if a vacuum gage reads…

A: Given Data: Q-4) Pb=29 in of mercury, Pg= -9.5 psi Q-5) W=5 N, V=200 cm3

Q: B3. A circular plate of diameter 2 m is vertically placed in water in such a way that the centre of…

Q: 1. Figure below fluid A is water, fluid B is oil (s = 0.85). Determine the pressure difference…

Q: A gate of length l and width b is submerged in water, which has density Pw, as depicted in the…

Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…

Q: If the pressure at A was 78 kPa, what is the pressure at B?- Note all dimensions are in cm. Water…

A: Given data: The pressure at point A is PA=78 kPa The density of the mercury is ρm=13.6×103 kg/m3…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given Data: The absolute pressure at the bottom is, P=625 kPa=625 kPa×1000 PakPa=625000 Pa. The…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: The pressure increases as we move deep down in the fluid. For static fluid this pressure is termed…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: 1. Water has a density of 1000- and seawater has SG of 1.024 and m gravitational acceleration at Om…

A: Given Data: Specific gravity of seawater, SG=1.024

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

A: Given data: SGLo=0.938SGCo=0.96 Need to determine the hydrostatic force due to each fluid.

Q: 6. Determine the pressure at Point B if the Pressure at Point A is 40 kPa (Fig. 6). SGmercury=13.6,…

Q: Three liquids of different densities fill connected tubes as shown in the figure below (not drawn to…

Q: Consider a water droplet resting on a 3D spherical surface with a radius of curvature R. Assume the…

Q: B3. A circular plate of diameter 2.25 m is vertically placed in water in such a way that the centre…

Q: A circular plate of diameter 3.25 m is vertically placed in water in such a way that the centre of…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given A container contain three fluid placed over one another of different thickness and density…

Q: A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined in an…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: B3. A circular plate of diameter 2.5 m is vertically placed in water in such a way that the centre…

Q: Q5. Find the center of gravity of a solid bounded by x = y´ and the planes x = z, z = 0, and x = 1.…

A: The region is V ={ (x,y,z) : 1≤ y ≤ I ; y2 ≤ x ≤ 1 ; 0≤ z ≤ 1} The mass of the solid is

Q: In the figure shown, what is the static pressure in kPa in the air chamber? Write the value of your…

A: Given Specific gravity of oil = 0.866 Liquid = 0.93 Density of air =…

Q: For the vertical wall shown on the left, the oil thickness is assumed to be 0.2 m and its SG is 0.8.…

Q: Find the angle the surface tension film leaves the glass for a vertical tube immersed in vater if…

A: Given datad=0.25inh=0.08inσ=0.005lb/ftρ=1.94slugs/f3g=32.2ftwe know thatSurface tension force=weight…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given Absolute pressure = 550 kPa

Q: 23

Q: The figure on the right shows two liquids, one on the top of another. The first liquid has a…

A: Pressure varies with height according to hydrostatic law. The absolute pressure at any point y…

Q: The deepest point in any ocean is in the Mariana Trench, which is about 11 km deep, in the Pacific.…

Q: 3.5 m 1 m Oil (S- 0.83) 2 m 500B

A: Center of pressure is the point at which resultant hydro-static force by the fluid acts on the body.…

Q: 2) The tank in the figure shown has a 4-cm diamter plug which will pop out if the hydrostatic force…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given that the absolute pressure at the bottom is 700 kPa = 700 x 103 Pa Atmospheric pressure is…

Q: Find the hydrostatic pressure on one side of the plate submerged in water (p = 1.00 8/mL) shown in…

A: give data;density of water (ρ)=1g/ml =1000kg/m3 AB=8mAD=6m

Q: What is the absolute pressure inside a water drop having radius 1mm and surface tension as 0.1 N/m?…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

Q: Q2/ Isosceles traingular gate with base equal to height as shown in Fig. Find h water 0.345bar 60cm…

Q: Q2: A cubical tank has sides of 3.75m which contains three immiscible liquids at same depths. A…

A: Given data Side length of the cube L = 3.75m Height of water Hw = 1.25m from base Height of liquid…

Q: SS 3.17 The figure shows a sectional view through a submarine. Calculate the depth of submergence,…

A: According to the information we have, seawater has a special weight of 10.0 kN/m3. The figure…

Q: containing Oxygen (initially at sea level) has a diameter of 8in. If the uniform density of air is…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given data Pressure at bottom = 650 Kpa Atmospheric pressure = 1.0132 bar X= 4 m Y = 4 m Z = 1.5 m

Q: A tall glass cylinder is filled with a layer of water 18.0 cm deep, and floating on top of the…

Q: Consider the pressure and force acting on the pool retaining a reservoir of water. Suppose the pool…

Q: How sensitive is Laplace's law to temperature? Assuming the temperature is 60 degrees Fahrenheit,…

A: To find: The percentage change in pressure and percentage change in pressure as compared to the…

Q: ô FLUID 100cm Figure Q1b 200cm Fluid with weight of 25 kN is filled into a container of width 100 cm…

A: Given data, Fluid weight = 25 KN, width = 100 cm, We have to find density and specific weight of…

Q: *6. A drop of oil (y = 0.0320 N/m) has a radius of 0.0100 mm. The drop is located a distance of 2.55…

Question

1. Find the density of an oil filled in the liquid
column as shown in figure. Given that absolute
pressure at the bottom is 700 kPa, atmosphere
pressure is 1.0132 bar. where X=4m; Y = 4m,
%3D
Z=2.25m.
water
X
oil
Y
Mercury
The density of the oil = (unit in kg/m³) =

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
The surface tension of water in air is approximately 0.0072lbf/ft. If the atmospheric pressure is 14.7 psia, what is the pressure inside a droplet 0.5 mm in diameter?
1. Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively, find the density of the air. 2. A rigid container is closed at one end and measures 7 inches diameter by 14 inches long. The container is held vertically and is slowly moved downward until the pressure in the container is 16.5 psia. What will be the depth of the water surface measure from the free water surface?
If a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at atmospheric pressure, while the external pressure increases due to the increased water depth. At sufficient depths, the difference between the external and internal pressures can rupture an eardrum. Eardrums can rupture when the pressure difference is as little as 35 kPa. What is the depth at which this pressure difference could occur? The density of seawater is 1025 kg/m3. 1)sketch (include everything in the system) 2)solution(step by step)
Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 500 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=1.5m. The density of the oil = (unit in kg/m3) =
3. A barrel contains a 15 cm layer of oil of density 5.88 kN/m3 floating on water that is 30 cm deep. What is the gauge pressure in mmHg at the oil-water interface?
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetrachloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG=1.31). The air chamber in the tank is pressurized at 1296 psf. d. Apply the PANEL EQUATIONS to determine the magnitude, direction and location of the total hydrostatic force acting at the bottom of the tank.
Find surface tension in a soap bubble of 45 mm diameter when the inside pressure is 2.812 N/m2 above atmosphere. (ENTER ONLY THE VALUES IN THE BOXES BY REFERRING THE UNIT GIVEN IN BRACKETS) The surface tension of the soap bubble (unit is N/m) = _____________ Short Answer
Please answer neatly For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m.a.The hydrostatic force due to linseed oil F1. b.The hydrostatic force due to castor oil F2. c.The hydrostatic force due to water. d.The net hydrostatic force acting on the gate Fnet
Mercury is often used in thermometers. The mercury sits in a bulb on the bottom of the thermometer and rises up a thin capillary as the temperature rises. Suppose a mercury thermometer contains 3.380 g of mercury and has a capillary that is 0.200 mm in diameter. How far does the mercury rise in the capillary when the temperature changes from 0.0C to 25.0C? The density of mercury at these temperatures is 13.596 g/cm^3 and 13.534 g/cm^3, respectively.
Give me right solution. Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute pressure of 23 kPa, abs. and the atmospheric pressure at sea level is 101.325 kPa, absolute and temperature of 15 ⁰C. The gas constant of air is 286.9 joule per kilogram per degree kelvin. Assume the condition isisothermal.
A closed tank contains 1.5 m of SAE 30 oil, 1m of water, 20 cm of mercury, and an air pocket in its upper part, all of them at 20 ° C. The absolute pressure at the bottom of the tank is 60 kPa. What is the pressure in the air bag?