Determine the effectiveness factor for the spherical

Q: (aa)The mean velocity, um (ab)The Reynolds number Re, hence verifying that the flow is laminar. (ac)...

A: In the case of Newtonian fluids, depending upon the Reynolds number, the flow can be classified as  ...

Q: What are the assumptions of the rigorous-batch distillation model of Distefano?

A: The assumptions involved in the rigorous-batch distillation model of Distefano are to be mentioned.

Q: What is the mass in grams of precipitate formed when 45.5 mL of 0.300 M Na₃PO₄ reacts with 52.0 mL o...

A:

Q: A stream of warm water is produced by mixing 1 kg/s of cool water at 20°C with1 kg/s of hot water at...

A: given that, the mass flow rate of cool water mc = 1 kg/s the temperature of cool water Tc = 20oC = 2...

Q: Water is in steady fully developed laminar flow between two horizontal, very wide (W) and long (L) p...

A:

Q: For the making of 6000 ft^3 of acetylene (CHCH) gas at 70 degrees F and 750 mm Hg, solid calcium car...

A: Given reaction: CaC2 +2H2O --> CHCH + Ca(OH)2 As suggested in the question, taking a basis as 600...

Q: The following data were reported [from C. N. Hinshelwood and P. J. Ackey,Proc. R. Soc. (Lond).,A115,...

A: Constant Volume Batch reactor- It does not mean the volume of the reactor but it refers to the volum...

Q: Water at 60°F is flowing through a reducing pipe fitting in the horizontal plane as shown below at a...

A: given that, volumetric flow rate Q = 4.5 ft3/s inlet diameter = 12 in outlet diameter = 2.5 in inlet...

Q: I need 13 th question

A: Given:  NO concentration in stack (C)= 38 g/m3 Stack gas velocity (v) = 20 m/sec Stack diameter (d) ...

Q: Chemical Engineering Question

A:

Q: Calculate (∂U/∂P)T, (∂H/∂P)T and m of a substance at 298 K and 1 bar, if the following data are give...

A:

Q: A chemical engineer is studying the following reaction: 2 NO(g)+2H,(9) → N2(9)+2H,O(g) At the temper...

A:

Q: If the air is trap was not used in the fermentation setup, would ethanol be the end product? If not,...

A:

Q: Using Table , select liquid–liquid extraction solvents for removing the solute from the carrier in t...

A: Solvents that lower the activity coefficients are to be choosed. From the table, the minus sign grou...

Q: 1.

A:

Q: Explain how a stirred tank reaction works.

A: The working of a stirred tank reaction is to be explained.

Q: A fireman is using high pressure stream of water from hose to combat raging forest fire. At one end ...

A:

Q: 3. Inside a distillation column, a downward-flowing liquid and an upward-flowing vapor maintain cont...

A: Given that, Mole% of ethanol in vapor = 89% Mole% of water in vapor = 100 - 89 = 11% Mole flow rate ...

Q: Salt can be made from seawater by solar evaporation. In the first stage of the process, all of the C...

A: According to the question, the process can be shown by the following flow sheet if we see both stag...

Q: Compare TLC with column chromatography.

A: Chromatography is a method used to separate a chemical mixture into its components to be further ana...

Q: What is a distillation boundary?

A: The definition of the distillation boundary is to be mentioned.

Q: Question 1 A small sphere of reference-grade iron with a specific heat of 447 J/kg.K and a mass of 0...

A: since you have posted multiple questions and have not specified which question is to be answered, we...

Q: Dry pyrites fines containing 82% FeS2 and 18% gangue are burned in a Herreshoffburner. The cinder pr...

A:

Q: In the laboratory a student finds that it takes 86.8 Joules to increase the temperature of 13.0 gram...

A: Given that, heat Q = 86.8 J mass of Iodine m = 13 g Temperature T1 = 21.5 oC Temperature T2 = 38.1 o...

Q: The first-order, irreversible, exothermic liquid-phase reaction A→Bis to be carried out in a jackete...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: The irreversible reaction following concentration- time data were obtained as follows: A B was carri...

A:

Q: What is the diffusion flux of acetone across a 15-mm layer of air flowing in the opposite direction ...

A:

Q: Define Ion Selective electrodes and Molecular Selective electrodes? Write their types and applicatio...

A: Ion selective electrodes (ISE) are defined as the specific type of electrode which converts activity...

Q: See attachment for the question!

A: Given is a graph, based on data from an experiment, in which 50 ml of the binary mixture was fractio...

Q: Will the boiling point of a pure substance vary if taken on different days? Why? In what ways is the...

A:

Q: “A liquid is heated at constant pressure in a smooth container to a temperature above its boiling po...

A:

Q: Calculate AHrxn for the reaction: C5H12(0) – 5 C(s) + 6 H2(9) Use the following reactions and given ...

A:

Q: In the McCabe–Thiele method, between which two lines is the staircase constructed?

A: The two lines between which the staircase is constructed in the McCabe-Thiele method is to be mentio...

Q: 100 kg of a waste stream containing 10 wt% suspended solids is separated in a vacuum filter to produ...

A:

Q: Solid gypsum, CaSO42H2O, is formed in a crystallizer and leaves the unit as particles suspended in a...

A: Basis: 2-liter Slurry Solid gypsum = 0.35 kg CaSO42H2OL slurry The density of gypsum = 2.32 gmL The ...

Q: connected to two pipes as shown in Figure. The pipe A is containing carbon tetrachloride sp.gr. = 1....

A: Given-pressure drop = PB-PA = 0.8 kg/cm2                                                     = 0.8 x...

Q: 75% pure raw sulfur is burned in excess air supplied at the rate of 4.75m3/kg of raw sulfur at 28⁰C,...

A: Given data: Purity of sulfur = 75 % Excess Air supplied = 4.75 m3/kg of raw sulfur Temperature of ai...

Q: On Planet X, the atmosphere does not contain CO2, but does not contain NH3. If water in equilibrium ...

A:  

Q: What is the entropy change of the gas, heated in a steady flow process at approximately atmospheric ...

A: Initial temperature of ethylene=473.15 K Amount of heat supplied to 10 moles ethylene=800 KJ From li...

Q: 1500 kg solution containing 20% Na 2 SO 4 and 80% H 2 O by weight is subjected to evaporative coolin...

A: given that, weight of feed solution containing 20% Na2SO4 and 80% H2O = 1500 Kg 20% of the original ...

Q: d and e please

A:

Q: What effects does liquid hold up have on batch rectification?

A: The effects of the liquid hold-up on the batch rectification are to be mentioned.

Q: A pipeline laid cross country carries oil at the rate of Q = 795 m³/d. The pressure of the oil is P1...

A:

Q: power a Below is a list of approximate conversion factors, useful for "back estimates. None of them ...

A: Conversion of unit from SI system units to other system of units is done to perform the calculation ...

Q: 1 kg of water is initially at 0 °C and is heated to 100 °C by contact with a heat reservoir at 100 °...

A: Hi and thanks for the question. You have posted multiple subparts, so we will answer the first 3 sub...

Q: Methylene chloride is a common ingredient of paint removers. Besides being an irritant, it also may ...

A: Given that, The thickness of glove L = 0.04 cm Diffusivity DAB = 110×10-8 cm2s Concentration C1 = 1....

Q: How does diafiltration differ from continuous feed-and-bleed ultrafiltration?

A: The difference between the diafiltration and the continuous feed and bleed ultrafiltration is to be ...

Q: A Cuwire with a diameter of 2 mmand a length of 1 mis initially at room temperature (300 K). A const...

A: Given data: Diameter of copper wire = 2 mm Length of wire = 1 m Initial temperature = 300 K Voltage ...