1.) The 300 g rocket is fired horizontally with a velocity of 1570 mph and picks up four stationary washers, the mass of each washer is shown in figure below. Find the energy loss during the interaction. 1st 2nd 3rd 4th 1570mph 300 g 100g 150 g 200 g 250 g

1.) The 300 g rocket is fired horizontally with a velocity of 1570 mph and picks up four stationary washers, the mass of each washer is shown in figure below. Find the energy loss during the interaction. 1st 2nd 3rd 4th 1570mph 300 g 100g 150 g 200 g 250 g

Name: 1.) The 300 g rocket is fired horizontally with a velocity of 1570 mp
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 1.) The 300 g rocket is fired horizontally with a velocity of 1570 mph and picks up four stationary washers, the mass ofeach washer is shown in figure below. Find the energy loss during the interaction.3rd4th1st2nd1570mph300 g150 g200 g250 g100g

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q3/ A hockey puck of mass 0.16 kg traveling on a smooth ice surface collides with the court’s edge. If its initial and final velocities are vi = =2 im/s and vf = 1 i m/s and if the hockey puck is in contact with the wall for 2 ms, find the impulse delivered to the puck and the average force exerted on it by the wall?
A 2-kg car initially moving at 6 m/s at a height of 4 m encounters a hill of height 5 m, as shown in Figure. At a later point there is a horizontal spring (with a spring constant k=150 N/m) at a height of 2 m. (a) Does the car reach the spring? (Hint: Compare the initial total mechanical energy of the car with its potential energy at hill of height 5 m) (b) If so, what is the maximum compression in the spring? Ignore frictional losses and the rotational energy of the wheels.g=9.8 m/s2
Consider a ski jumper moving down a track to acquire sufficient speed to accomplish the ski jumping task. The length of the track is I = 30 m and the track makes an angle 0 = 40° with the horizontal. If the skier starts at the top of the track with zero initial speed, determine the takeoff speed, v2. of the skier at the bottom of the track using the conservation of energy principle. Assume that the effects of friction and air resistance are negligible.
A 0.525-oz model rocket is launched vertically from rest at time t = 0 with a constant thrust of 0.9 lb for 0.3 s and no thrust for t > 0.3 s. Neglect air resistance and the decrease in mass of the rocket. Find the time required to reach the maximum height
A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an orifice of diameter of 0.4 m at the bottom. Find the time taken by water to fall from 4 m to 2m. Take Cd= 0.60include your free body diagrama.84.7 seconds b.47.8 seconds c.24.8 seconds d.43.8 seconds
A reducing elbow is used to deflect water flow at a rate of 95 kg/s in a horizontal pipe upward 45° while accelerating it (Figure below). The elbow discharges water into the atmosphere (ρ= 1000 kg/m3). The crosssectional area of the elbow is 113 cm2 at the inlet and 7 cm2 at the outlet. The elevation difference between the centers of the outlet and the inlet is 30 cm. The weight of the elbow and the water in it is considered to be negligible. Determine(a) the gage pressure at the center of the inlet of the elbow and (b) the anchoring force FRZ needed to hold the elbow in place.
In the photo, two beads are sliding freely on a horizontal rod. Use the following conditions. mA = 3 kg, mB = 1 kg, e = 0.9vA = 1 m/s, vB = -3 m/sa. Determine the final velocity of both beads.b. Determine the average interaction force, F between the beads if the duration of the impact is 0.005 seconds
A wind turbine has a rotor blade diameter of 10 m. If the turbine receives a maximum wind speed of 3.4 m/s, determine the maximum power available at the turbine. Assume ρ = 1.293 kg/m^3.
he fan shown in Figure 6 blows air at the rate of 5700ft3/min. The fan weighs 35 lb and has its center ofgravity at G. The specific weight of air is γ = 0.076lb/ft3. Assume that the upstream velocity of air is zero. Determine:(a) The force exerted by the fan on the air.(b) The pressure rise across the fan blades in psi.(c) The power required by the fan. (1 horsepower = 550 lb-ft/s)(d) The smallest diameter d of the base so that the fan won’t tip over.
The jet has a speed of 1260 km/hkm/h when it is flying horizontally. Air enters the intake scoop S� at the rate of 52 m3/sm3/s. The engine burns fuel at the rate of 1.85 kg/skg/s, and the gas (air and fuel) is exhausted relative to the plane with a speed of 2330 km/hkm/h. The plane has a mass of 8 MgMg. Assume that the air has a constant density of ρa�� = 1.112 kg/m3kg/m3. (Figure 1) Determine the drag exerted on the plane by air resistance. Express your answer to three significant figures and include the appropriate units.
A jet of water whose diameter is 5cm strikes a fixed cup with a velocity of 9.45m/s and is deflected by 165 degree. The jet leaves with a velocity of 30m/s . if the cup offers a reactive force of 26.5N to the jet when the flow rate was 980 N/min. Determine the ratio of a) Actual to theoretical forces of the jet. b) Velocities at outlet and inlet. Assume any missing data.
Commercially available large wind turbines have blade span diameters as large as 100 m and generate over 3 MW of electric power at peak design conditions. Consider a wind turbine with a 90 m blade span subjected to 25 km/h steady winds. If the combined turbine generator efficiency of the wind turbine is 32 percent, determine(a) The power generated by the turbine.(b) The horizontal force exerted by the wind on the supporting mast of the turbine.Take the density of air to be 1.2 kg/m3and disregard frictional effects.