1. The system as shown in Fig.1. The gauge pressure at the bottom of the tank is 242 kPa. what is the specific gravity of fluid X? Water 2 m Fluid X 3 m Mercury 0.5 m Fig.1 to
Q: A gage on the suction side of a pump shows a vacuum of 93 mm of mercury. Compute the absolute…
A:
Q: Water was used in a manometer to measure pressure from a vessel. The difference in height between…
A: GIVEN DATA - DIFFERENCE IN HEIGHT h=2ft WE HAVE TO CALCULATE PRESSURE IN mm OF Hg
Q: a) Pressure meters A and B reads 500 kPa absolute and 300 kPa absolute respectively, as shown in…
A: Note: As per policy, we can solve the first question from multiple questions. Please resubmit the…
Q: If the gage pressure in pipe is 2 bars, what is the absolute pressure?RITake atmospheric pressure as…
A: Given Gage pressure = 2 bar Atmospheric pressure = 1 bar
Q: A manometer measures a pressure difference as 40 inches of water. What is this pressure difference…
A: Given data: The pressure difference of water is Δp = 40 inch of H2 The height of column is h =40…
Q: Q/Specific gravity of manometer fluid is 3. Ah = 5 cm Az = 1 m %3D Ay = 2 cm Ah What is the pressure…
A:
Q: Determine the gauge and absolute pressure at a point which is 2.0 m below the free surface of…
A: Atmospheric Pressure:- The pressure exerted by atmospheric air normally upon all surfaces measured…
Q: A closed tank contains 0.5 m of mercury, 1.5 m of water, 2.5 m of oil of sp.gr. 0.8 and air space…
A:
Q: A closed tank contains 0.5 m of mercury, 1.5 m of water 2.5 m of oil of specific gravity 0.8 and air…
A:
Q: If you measured h=16.9 mm Hg using simple manometer, then the pressure (in kpa) will be (Given:…
A: h=16.9mm of Hg Sg=13.55 To Find Pressure in Kpa
Q: If mercury (SGHg = 13.6) is used in a barometer measuring atmospheric pressure of 97 kPa. What is…
A: Given P = 97 kPa P = 97 x 103Pa P = 97 x 103Nm2ln SGHg=13.6∴ Density…
Q: For the inclined-tube manometer of Fig. 2.4 the pressure in pipe A is 0.6 psi. The fluid in both…
A:
Q: A vessel containing oil of s = 0.762 moves vertically upward with an acceleration of +2.5 m sec2 ⁄…
A:
Q: Question 2: the height difference is 760 mm, and the gauge pressure is 5,218.92 Pa. Find the density…
A:
Q: A closed tank contains 0.610 m of mercury ( specific gravity = 13.6 ), 524 m of water, 2.438 m of…
A: Given That
Q: 1. A clean circular glass tube is to be selected in the design of a manometer to measure the…
A:
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A:
Q: A square block has 320 mm bottom sides dimensions, weighing W is 1.4 kN on an edge slides down an…
A: Given data: The bottom side, a = 320 mm. The weight of the block, W = 1.4 kN. The incline angle,…
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A:
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A: ρ1= 1.5(1000)= 1500 kg/m3PA= 110 kN/m2= 110000 N/m2ρ2= 0.5(1000)= 500 kg/m3PB= 216 kN/m2= 216000…
Q: The pressure of steam inside a boiler is shown by a pressure gauge 120 N/cm2. Take barometer reads…
A: Given data: Atmospheric pressure = 770 mm of Hg Gauge pressure = 120 N/cm2 Need to determine the…
Q: 1. If 5.30 m³ of certain oil weighs 43,360 N, calculate its: a) specific weight b) specific gravity…
A:
Q: 5. A manometer tube which contains mercury shown in figure below is used to measure the pressure Pa…
A:
Q: what is the pressure (psia) in the tank at the level where the manometer is attached
A: This answer is given below
Q: Density in inclined U tube manometer formula represents ___________. A. Outside air density B. Gas…
A: An inclined U tube manometer is a device used to measure the pressure in low-velocity systems or…
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A: Given Data The specific gravity at A is: SGA=1.6 The pressure at A is: PA=110 kN/m2 The specific…
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A: This is the basic numerical of fluid mechanics. Used concept is variation of pressure with height in…
Q: The difference in level between the points of supports and the lowest point on the conductor in…
A:
Q: A closed tank contains 0.5 m of mercury, 1.5 m of water, 2.5 m of oil of specific gravity 0.8 and…
A:
Q: 3. A pressure gauge indicates 25 psi when the barometer is at a pressure equivalent to 14.5 psia.…
A: Atmospheric pressure = Patm = 14.5 Psi Gauge Pressure = Pg = 25 Psi Absolute pressure is pressure…
Q: A closed tank contains 0.5 m of mercury, 1.5 m of water, 2.5 m of oil of specific gravity 0.8 and…
A: A closed tank includes 0.5 m of mercury, 1.5 m of water, 2.5 m of oil with a specific gravity of…
Q: ometer with diameters L and d is used to measure the pressure difference P, - P. Both ends…
A:
Q: 3.) Figure 41 shows one pressurized tank inside another. If the sum of the readings of Bourdan gages…
A: It is required to determine absolute pressure in A
Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…
A:
Q: Q1. The tank in Fig. 1 contains oil of specific gravity 0.75. Determine the reading gauge A in KPa.…
A:
Q: A U-tube manometer containing a light oil (specific gravity 0.7) is used to measure the static…
A: Given data: Specific gravity of oil = S = 0.7 Thus, density of oil = ρoil=1000×0.7=700 kg/m3 Density…
Q: Problem: The reading of an automobile fuel gage is proportional to the gage pressure at the bottom…
A:
Q: For the inclined-tube manometer in the figure shown, the pressure in pipe A is 0.6 psi. The fluid in…
A: P=Pa= rho*g*h formula is used to arrive the solution.
Q: Q11: Find the SPECIFIC GRAVITY of the OIL GOn in the Tank shown in Figure 10, if the pressure at…
A: Given Data: The pressure at point D is PD= 21 kN/m2. The value of a=1 m, b =0.4 m, c =0.4 m and d…
Q: Pa has a gauge pressure of 319892.923 Pa What is the density of the unknown fluid in kg/m?
A: The density of the water is
Q: ne surface tension of water- 73 N/m, the gauge pressure in
A: Given Data⇒ Surface tension of water-air interface is :σ=0.073 Nm Diameter (d)=1 mm =0.001 m
Q: Q2: A dead-weight gauge with a piston circumstance of 0.07 m is used for the accurate measurement of…
A: Given data circumference of piston = 0.07 m 2πr = 0.07 r =0.011146 m Mass of piston and pan = 5.020…
Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…
A: Specific gravity of liquid in pipe A, SA=1.6The pressure at pipe A, PA=102 kN/m2=102000 N/m2Specific…
Q: A cylindrical tank, 2 feet deep and 3 feet in diameter is filled with a fluid that weighs 50 lb/ft^3…
A: Given:- γ=50 lb/ft3h=2 ftd=3 ftTo find:_Pressure at the base, P
Q: A tube contains an oil of specific gravity 0.9 to a depth of 120 cm. Find the gauge pressure at this…
A:
Q: PROBLEM 4 To monitor the pressure in three pipes, a manometer setup was installed in one section of…
A: Given: gauge pressure in pipe B→PB=7200 lbft2 because inside the pipe B, water is flowing and…
Q: A Bourdon gage A inside a pressure tank reads 20 kPa. Another Bourden gage B outside the pressure…
A:
Q: If the gauge pre ssure in a 50-gal tank half-filled with liquid is 100 lbf/in .2, what would be the…
A:
Q: QI) A-tube manometer measures the pressure difference between two points A and B in a liquid of…
A:
Step by step
Solved in 2 steps with 2 images
- As illustrated, a mercury manometer is attached to the side of a nearly full water tank. The reading of the mercury column is 15.5 in. Hg gage. Although air on the water maintains the pressure, the other 10-in. leg of the manometer is full of water, for H2O , ρ = 62.3lb/ft3 ; for Hg, ρ = 846lb/ft3 If the location is at standard gravity and the temperature of both the water and mercury is 60°F, what is the pressure (psia) in the tank at the level where the manometer is attached? If the tank extends 10ft below this level, what is the pressure at this depth?A soccer referee inflates a soccer ball to the standard required measured pressure for a game of 90kPa, before the game. The balloon has an internal volume of 2650 cm3 and the air is at a temperature of 25°C when the balloon is first inflated. The ball is brought onto the field of play, and by the time the game starts, the air temperature has dropped to 0°C. Assuming that the volume of the balloon does not change significantly. Determine the following: a. Make a schematic of the system, showing the limits and conditionsb. The mass (in Kilograms) of air in the ball.c. The air pressure in the ball when the game starts. (Measured pressure)Q1 Determine the minimum size of glass tubing that can be used to measure water level, if the capillary rise in the tube is not to exceed 0.3 mm. Take surface tension of water in contact with air as 0.0735 N/m. A U-tube is made up of two capillaries of bores 1.2 m and 2.4 mm respectively. Q2) The tube is held vertical and partially filled liquid of surface tension 0.06 N/m and zero contact angle. If the estimated difference in the level of two menisci is 15 mm, determine the density the liquid. Q10) In measuring the unit energy of a mineral oil (specific gravity = 0.85) by the bubble method, a tube having an internal diameter of 1.5 mm is immersed to depth of 12.5 mm in oil. Air is forced through the tube forming a bubble at the lower end. What magnitude of the unit surface energy will be indicated by a maximum bubble pressure intensity of 150 N/m.
- The pressure inside a soap bubble of 10 mm diameter above the atmosphere is_____(σ = 0.04 N/m)An engineer sets the pressure in a supply tank usinga very accurate manometer as a guide and then reads theoutput of a 20-psig pressure gauge attached to the tank as10.2 psig. Sometime later she repeats the procedure andobtains values of 10.4 and 10.3 psig. Discuss the following gauge properties:(a)Precision(b)Accuracy(c)Resolution(d)RepeatabilityExpress these answers on a percentage of full-scale basis.The expansion tank of a household hot-water heating system is open to the atmosphere and is 10 meters above a pressure gauge attached to the furnace. What is the gauge pressure at the furnace, in pascals? In atmospheres? Include given, fbd and solution.
- A kelvin and rankine thermometer are both immersed in a fluid and indicate identical numerical readings. What is the temperature expressed as °C and °F?Question 6 Figure 6 shows a U-tube manometer.Fluid A is oil ( s= 0,9) and fluid B is mercury (s= 13,6).Determine the prrssure difference between P and Q.Ignore thr density of air.A 120-litre pressure vessel in a laboratory contains 1.587 kg of air. If the room temperature is 22 C and the atmospheric pressure is 101 kPa. What would be the reading on a pressure gauge? Note any assumptions you have made.
- the figure below shows a water pipe where a pressure tap is being carried out. At the site, the specific gravity of water Ywater=10,000 N/m^3 and the specific gravity of mercury is UHg=136,000 N/m^3. Find the gauge pressure in pipe A. Where h1=50mm; h2=20mm; h3=30mm; h4=20mmAs shown in Fig. 1.12, a horizontal interface 0-0 exists between two immiscible liquids. The dynamic viscosity of these two liquids are 0.14 Pa sand 0.24 Pa s respectively. The thickness is d1 0.8 mm and d2 1.2 mm respectively. Assuming that the velocity gradient is linear. Find theforce F required to push a bottom area A 1000 cm2 wood board to movewith velocity v0 0.4 m/s along the surface?A pressure gauge submerged in sea displays 1.6 MPa of absolute pressure. The density of seawater is 1025 kg/m3. At what depth is the pressure gauge situated? Atmospheric pressure is 101,325 kPa