Answered: I. 5,64 kPa II. 11,8 kPa III. 10 kPa…

Name: the figure below shows a water pipe where a pressure tap is being carr
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: the figure below shows a water pipe where a pressure tap is being carried out. At the site, the specific gravity of water Ywater=10,000 N/m^3 and the specific gravity of mercury is UHg=136,000 N/m^3. Find the gauge pressure in pipe A. Where h1=50mm;

Engineering

Mechanical Engineering

I. 5,64 kPa II. 11,8 kPa III. 10 kPa IV. 21,6 kPa V. 45,89 kPa Water h1 A h2 Hg h3 Hg- h4 Water

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter34: Emission Control Diagnosis And Service

Section: Chapter Questions

Problem 2RQ: What will result from too little EGR flow? And what can cause a reduction in the flow?

See similar textbooks

Similar questions

Solution to HW problem.
Inlet: Air, 72 kPa, 291.15K, 230 meters/second Outlet: Air, 98 kPa, 0 meters/second What is the temperature at the outlet? Cp=3.5(8.3145). No heat exchange.
29 - A pump increases the pressure of water at a flow rate of 160 L/minute from 100 kPa to 900 kPa. If the shaft power supplied to the pump is 3 kW, what is the pump power? a) 2,128 kJ B) 1,710 kJ NS) 1,660 kJ D) 1,532 kJ TO) 2,082 kJ
HVAC UPVOTE WILL BE GIVEN. ANSWERS ARE GIVEN ALREADY. PLEASE WRITE THE COMPLETE SOLUTIONS. Air with dry bulb temperature of 25°C (Psat=3.169 kPa) and a wet bulb temperature of 15°C (Psat = 1.7051 kPa) flows in round duct of diameter 800 m/s with a velocity of 7 m/s. Defermine a) RH (Ans. 33%) b) Moisture content (Ans. 00065) c) Sp. Enthalpy (Ans. 42) d) Mass Flow rate (Ans. 249 kg/min) e) Mass Flow rate of dry air (Ans. 247 kg/min) f) DPT (Ans. 8°C) 9) Sp. volume (Ans. 0.85)
The date for a certain installation are as follows Net Head = 454 m, BP = 57,200 bkw, n = 750 rpm, ηT = 90%. What type of turbine was used? A. Impulse turbine B. Kaplan turbine C. Propeller turbine D. Francis turbine
Rotameter having a glass float (sp. gr = 4.0) is calibrated to handle a maximum flow of 80gpm of water. Whatis the maximum flow rate of biodiesel (sp. gr = 0.9) can it handle in gpm?
identifuy the limitations that exist within different types of water turbine
What will result from too little EGR flow? And what can cause a reduction in the flow?
SN=50
Real operating diffuser throat area in a wind tunnel should be less than A_y^*.
Fixed wings with classification of 120ㅇ as illustratedis being sprayed at a flow rate of 15 m/s toThe sprayed water is 0.45 kg/s. Seek the power to action on the wings
Explain the following terms by searching different sources: 1. Effect of design on volumetric efficiency, 2. Estimating air capacity