1. What is the total N in soil (%) if the consumed volume of 0.05 N H2SO4 was 0.01 ml? 2. What is the nitrogen content and partition of organic and inorganic nitrogen in soil? And what are the Forms of inorganic nitrogen in soil?.

1. What is the total N in soil (%) if the consumed volume of 0.05 N H2SO4 was 0.01 ml? 2. What is the nitrogen content and partition of organic and inorganic nitrogen in soil? And what are the Forms of inorganic nitrogen in soil?.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter98: Guide To The Chemical Literature

Section: Chapter Questions

Problem 5P

See similar textbooks

Related questions

Q: 1. Step-Growth Polymerization (a) Draw 2 different combinations of monomers that can be used to…

A: The polymerization process involves the combination of the monomers catalyzed by heat, light, and…

Q: The nature of the primary solvent exclusively influences the miscibility of certain compounds. To…

A: In the given question two statements are given and it is asked that whether these statements are…

Q: What is the basic mechanism of an Anionic polymer (acrylic acid based as carbomers) in regards to…

A: Answer - Anionic polymer - Anionic polymerization is a form of chain-growth polymerization that…

Q: A) the possible methods to purify cyclohexene from cyclohexanol and other materials produced in the…

A: Purification of Cyclohexene from cyclohexanol can be done via these following ways - First one is…

Q: How to perform Stoichiometric Analysis on the equation between HMF and water using a 0.1M H2SO4…

A: Carbohydrates are biomolecules that are composed of certain monomer units, called monosaccharides or…

Q: What is main objectives in extraction of beta-carotene from carrot.

A: Extraction is a separation process consisting of the separation of a substance from a mixture.…

Q: the production of vinyl polymers using bulk methods

A: Bulk polymerization or mass polymerization is carried out by adding a soluble radical initiator to…

Q: What is the difference between homolysis vs. heterolysis. Show by giving an example.

A: The difference between homolysis and heterolysis has to be given with an example.

Q: What is cross linking, give how does it effect recycling ability and strength of a polymer,

A: This is a question from polymer chemistry.

Q: Suppose you are to analyse these compounds from WWTPs, discuss what type of samples you would…

A: A drug is any chemical that, when eaten, induces a change in the physiology or psychology of an…

Q: The primary reason for the addition of anhydrous magnesium sulfate to the organic solvent layer…

A: The primary reason for the addition of anhydrous magnesium sulfate to the organic solvent layer…

Q: The polymer shown can be formed by Fischer esterification. What monomer(s) would be used to make…

A: In the polymerization , the key step is the selection of appropriate monomer to get the desired…

Q: heat

A: The above reaction, substrate having electronegative Oxygen atom which can accept proton from acidic…

Q: oxidation

A: Filtration condition for the benzene derivatives for oxidation purpose is that the alkyl side chains…

Q: (b) The synthetic designed by BHC is a classic example of application of green chemistry in…

A: " Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Enters the preferred IUPAC name of the connection in Figure 29.

Q: (b) Now write a short note on the possible structures of polystyrene as formed from styrene…

A: Polystyrene is a synthetic aromatic hydrocarbon polymer that is prepared from the polymerization of…

Q: Compound A is impure and has a melting point of 93°C - 105°C. After purification, A will most likely…

A: Melting point can be defined as the temperature at which a solid melts. When the intermolecular…

Q: ----- --.. Type of layer: Agueaus. Species contcined: Sodium benzoare, and Combined No OH (ay)…

A: The type of layer and species is answered in the next step:

Q: 4. In the condensation polymerization of stoichiometric dicarboxylic acid and diol catalyzed by…

A: In this question, we have given condensation polymerization of stoichiometric dicarboxylic acid and…

Q: Give reason/s for the following? Why CCl4 is used solvent for IR analysis?

Q: Explain the variables in the Carothers equation, and its physical meaning. How can this equation be…

A: Since you have posted a question with multiple questions, we will solve first question for you. To…

Q: Why is purification necessary when doing organic synthesis? What are examples of purification…

A: Purification is an important key in the organic synthesis as we can not get a desired compound…

Q: Why must some organic reactions occur in the absence of water? Describe how you can remove residual…

A: Since water is a polar solvent so it can interfere with the reacting species, which is unwanted and…

Q: Can Organic reactions using microwave irradiation made in Home microwave ?

A: Microwave radiations are the kind of electromagnetic radiations whose irradiation for a very small…

Q: How do we detect organic compounds and inorganic compounds used in GC analysis?

A: Gas Chromatography is an analytical technique used to separate various components inside the column…

Q: What is the purpose of adding anhydrous sodium sulfate to the organic layer after extraction? * it…

A: The question is based on the concept of organic chemistry. we have to explain the reason of adding…

Q: why is distillation an ideal choice to purify cyclohexene from cyclohexanol instead of other…

A: Distillation is used to separate a mixture when the boiling point difference between the…

Q: Explain two separation techniques how may be feasible for Benzene vs Phenol. One can be an…

A: Benzene is volatile liquid of boiling point 80°C . Phenol is of high boiling point of range 181°c.…

Q: Briefly describe what is thermoplastic, thermoset plastic and elastomer. Give examples to clarify…

Q: Write short note on distereomers properties with a suitable example ?

A: Stereoisomerism is molecules that have the same molecular formula but different orientations in…

Q: After treating the activated carbon with sulfuric acid or any acid, I found out that it is needed to…

A: acid wash of activated carbon

Q: the production of vinyl polymers using bulk methods

Q: When would you use recrystallization technique as opposed to extraction? What is the relative…

A: Recrystallization is often used as a final step after other separation methods such as extraction,…

Q: Introduction of vinyl polymer production using the bulk method.

A: This is a method of polymerization. This method involves radical mechanism. It is a three step…

Q: What is main objectives in extraction of beta- carotene from carrot.

A: Extraction is a separation process consisting of the separation of a substance from a mixture.…

Q: Answer the following question with respect to Fatty Acid Methyl Esters (FAMEs) by Gas Chromatography…

A: Fatty acids of food product is determined by derivatization Of fatty acids in its ester components.

Q: Find the product to be formed by writing the mechanism of the reaction of methylcyclohexene with HBr…

A: The reaction of alkenes with HBr in the presence of light takes place according to the free radical…

Q: Why is it recommended to fight fire only in the INCIPIENT Stage?

A: FIRE SUPRESSION

Q: Indicate general observations of flame produced in the combustion of below organic compounds. State…

Q: Calculate the volume of methane gas, at 15°C and 1.0 atm pressure, that is released annually by the…

A: The net balanced chemical equation for the decomposition of cellulose through the two anaerobic…

Q: Acetic acid was also formed in the synthesis of aspirin and would be present with aspirin in the…

A: Aspirin (Acetylsalicylic acid) is formed when salicylic acid reacts with acetic anhydride. It also…

Q: PLA, a polyester-based synthetic polymer, decomposes in our body fluid and separates into its…

A: PLA was first found in the year 1932. It's a bio-based, compostable polyester. PLA's early…

Q: three dimensional structure for 2-Hydroxypropanoic acid

Q: What is the process of seeding, as it applies to recrystallisation? What purpose does it serve?

A: The process of seeding is defined as the addition of crystal of pure substance into saturated…

Question

1. What is the total N in soil (%) if the consumed volume of 0.05 N
H2SO4 was 0.01 ml?
2. What is the nitrogen content and partition of organic and inorganic
nitrogen in soil? And what are the Forms of inorganic nitrogen in
soil?.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

In the reactions given below, write to which organic molecule Y, Z, T, A ‘belongs, and give information about the reaction types that take place.
What is main objectives in extraction of lycopene from watermelon.
) PLA, a polyester-based synthetic polymer, decomposes in our body fluid and separates into its constituent acids and alcohol. This acid in the body can cause inflammation. What would you recommend to overcome this disadvantage? b) The late decomposition of PLA, which is a biodegradable and hydrophobic polymer, in body fluid may create a disadvantage in applications where faster degradation is desired. What would you suggest to do to resolve this situation? Please explain.
Is 1-octadecene and/or heptane soluble in benzene? Why?
Chemistry 1. Answer the following question with respect to Fatty Acid Methyl Esters (FAMEs) by Gas Chromatography for Determination of Fatty Acid Profiles in Foods. a) With the BF3 method for FAME preparation, glycerides and phospholipids are saponified by ________, and and fatty acids are esterified by _________. b) What are the functions of hexane and saturated NaCl? c) Summarize the safety concerns of BF3 and what we can do to minimize the hazard to yourself during the experimentexperiment.
An organic chemistry laboratory Extraction; the extraction of crude naphtalene- benzoic acid mixture. Naphthalene is a suspect carcinogen and is toxic to aquatic life. Find an alternative pair of molecules that adhere better to the principles of green chemistry and can be separated by extraction using green' solvents. (kindly answer fully)
Write short note on distereomers properties with a suitable example ?
Compound A is impure and has a melting point of 93°C - 105°C. After purification, A will most likely have a melting point of
Describe how functional groups (toluene to be specific) are characterized for the Nitration test and Basic Oxidation Reaction test. Provide general chemical reactions that explain the appearance of the indicators for each test result.
Fill in the missing starting material, reagant, or product where neccessary.
What is the strongest IMF in pure 2-octanone? I know it is a ketone and has some polarity due to this, but the carbon chain so long, I wonder if london dispersion forces are stronger?
The phospholipid structure shown above provides for ___? The hydrophobic by-layer of cell membranes The hydrophilic inner and outer surfaces of cell membranes a and b