1. While performing the Dumas experiment, if the outside of the flask were not completely dry (Part I), how would this affect the calculated molar mass of the unknown volatile liquid? Would it be higher or lower? Explain.

1. While performing the Dumas experiment, if the outside of the flask were not completely dry (Part I), how would this affect the calculated molar mass of the unknown volatile liquid? Would it be higher or lower? Explain.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter85: Vacuum Distillation, Manometers

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The normal molar solubility of cobalt (11) hydroxide, Co(OH), is approximately 710 M and the pH of a...

A: Solubility is the amount of solute that dissolves in a solvent

Q: how many grams of potassium sulfate must be added to make 200ml of a .200 m potassium sulfate soluti...

Q: H3NH2 mixed with 0.50 moles of CH3NH3Cl in water. If 0.10 moles of HCl are added to this solution, w...

Q: Professor Rowan is preparing for his experiment in Sinnoh Lab. The structures of the substances that...

A: London-dispersion forces are present in all the molecules. Dipole-dipole forces are present in molec...

Q: The activation energy for the gas phase decomposition of isobutyl bromide is 211 k). (CH3)2CHCH2Br- ...

Q: What is the value of hfe if beta is 200?

A: The hfe is the ratio between the change in IC, and change in IB. Similarly, the β is also the ratio ...

Q: oles If I have 7.7 moles of gas at a pressure of 0.09 atm and at a temperature of 56 °C, what is the...

Q: 4. A 15.0 g sample of ethanol in an alcohol burner, is used as fuel to heat up 2.0 L of coffee from ...

A: The heat generated during the combustion of 15.0 g is used to increase the temperature of the 2.0 L ...

Q: 12. A certain first-order reaction has a rate constant equal to 0.0184 sec1 at 305 K. At 310 K, the ...

Q: 7. Consider the following chemical equilibrium: 2 CO (g) + 02 (g) = 2 CO2 (g) At equilibrium, the fo...

A: Given, 2CO (g) + O2 (g) ⇌ 2CO2 (g) Equilibrium constant (Kp) = ? At equilibrium, partial pressure of...

Q: Which of the following represents the correct ranking of terms from largest to small O Macromolecule...

A: The correct option is C. Macromolecule are largest. Polymer is the subdivision of macromolecules

Q: 17. A fuel mixture used in the early days of rocketry consisted of two liquids, hydrazine (N2H4) and...

Q: 25.0 mL solution of HNO₃ is neutralized with 23.8 mL of 0.250 M Ba(OH)₂. What is the concentration o...

A: Using stoichiometric ratio we can determine how many moles of HCL reacts during the reaction. From t...

Q: Predict the organic and inorganic products of the given reaction, and select the class to which the ...

A: We have find out correct reaction mechanism.

Q: What is the behavior of the resolution of the analytes as a function of the carrier gas in gas chrom...

A: The function of the carrier gas source is to provide the gas that will be used as the mobile phase f...

Q: of the following is an exact value? A. 1 peso coin B. 12 cars C. 798

A: An exact number has zero uncertainty in it .It has an infinite number of significant figures. ->o...

Q: Consider a solution initially containing 0.30 M of CH3NH2 mixed with 0.50 M of CH3NH3Cl in water. Wh...

Q: Part A What mass of Cu(s) is electroplated by running 22.0 A of current through a Cu²+(aq) solution ...

A: We have to predict the mass of Cu deposited and time taken for Au to get plated.

Q: What would you expect to be the effect of an increase of pressure on the following reaction? CH4(g...

A: We are given equilibrium reaction : CH4(g) + 2S2(g) ↔ CS2(g) + 2H2S(g)

Q: unknown sample contains radioactive element U-235. If the original amount present is 3500 atoms, how...

A: Given- Number of initial atom =3500 atoms Number of final atom =125 atoms Half life =700 million ye...

Q: Anna Divi, a young and ambitious researcher, is planning to put up her very own research laboratory....

A: Given: Break temperature = melting point = 54 oC Halt temperature = freezing point = 51 oC

Q: A weak acid (HA) solution has a 5.6 x 10-5 M of H3O*. If the Ka for the weak acid is 3.1 x 10-8

A: We have to calculate the initial concentration of weak acid.

Q: Consider the following equilibrium: CO2(g) + C(graphite) 2CO(g); H = 172.5 kJ The equilibrium const...

Q: Select one or more answers and submit. For keyboard navigation... SHOW MORE V a A C=O bond is longer...

A: Given, Predict the correct statements

Q: Hello I am having a hard time understanding this question, can you please explain this to me. Rank ...

A: This question is the application of colligative properties of solutions.

Q: Rank the following compounds in order of increasing boiling point. Be sure to answer all parts. A) (...

A: Alcohols has highest boiling point than ether because alcohol can form hydrogen bonds. ->as the b...

Q: O Naphthalene (128.164 g/mol) H. H. H. O Acetic acid (59.04 g/mol) H-C-C HICI

Q: Which of the following solutions can act as a buffer? Group of answer choices 100 ml of 0.2 M HCl + ...

A: Given, Which of the following solutions can act as a buffer? Group of answer choices a). 100 ml of...

Q: Sodium chlorate crystals are easy to grow in the shape of cubes by allowing a solution of water and ...

A: Answer: This question is based on the basic understanding of one of the solid shapes cube, its volum...

Q: 12. Find the limiting reactant if 5.00g of SrH2 react with 5.00g of H2O according to the following r...

Q: y of Conservation of trolysis of Definite Proport of Conservation of

A: Matter can be separated into fine forms it is proves by electrolysis

Q: Chlorine gas used for disinfection combines with water to form hypochlorous acid (HOCI). The HOCI io...

A: Given, Reversible reaction : HOCl ⇌ H+ + OCl- K=2.7×10-8

Q: Draw the structures of 5 structural nd positional isomers of alkynes with formula C6H10

Q: The standard cell potential, E°, of a reaction is found to be 0.11 V. For this reaction, the value o...

A: Given- E°cell=-0.11volt

Q: 4. How many atoms of sulfur are in 10.18 mol of tetrathionate (S4O,2-) ion? O 2.451 x1025 atom O 6.1...

A: 1 mol of any substance contains avogadro number of atoms or ions. Avogadro's constant= 6.023× 10^ 23

Q: Example: A solution buffered at pH 3.90 is needed for a reaction. Would formic acid and its salt, so...

A: Given: A solution buffered at pH 3.90 is required for a reaction. ka of formic acid is 1.8 x 10-4

Q: Part C Pb02 (s) + 4 H (ag) + Sn (s) → Pb²+(ag) +2 H20 (1) + Sn² femplates Symbols uado redo reset ke...

Q: Using the data in the table below, calculate AH° in kilojoules for the following reactions. Standard...

Q: For the decomposition of nitrous oxide at 565 °C 2 N20(g) → 2 N2(g) + 02(g) the average rate of disa...

A: Rate of disappearance of N2O is 2.82×10-4 M/s ∆N2O∆t= 2.82×10- M/s

Q: Write Half Redox reaction Sn = Sn02

A: In a balanced redox reaction two conditions are satisfied i.e atom balance and charge balance.

Q: Compare diffusion and osmosis

A: The movement of molecules from higher concentration to lower concentration is known as diffusion. Di...

Q: A student was studying the pH differences in Erie Lake streams. The student measure a pH of 6 in str...

Q: Compute for the volume of a 2.5 M sodium chloride solution which contains 71.3 g NaCl

Q: g it into a Au³+ solution. at which the Au3+ ions are d is used as the anode and thus completing the...

A: Given, Current (i) = 8.60 A Time (t) = 14.0 min = 14×60= 840 s Number of electrons transferred (n) ...

Q: Crude Oil must be processed before it can be used? True or False

A: Given statement is : Crude Oil must be processed before it can be used? Whether this statement is T...

Q: 6. -čOCH,CH, 7. CH;CH:CH:CH;CH2NH2 S. CH:(CH:);CHO 9. HC CHẠCH,CH;-CH-CH, 10.

A: IUPAC Rules : Identify the longest carbon chain as parent chain Start the numbering from the end ne...

Q: Write Half Redox reaction of (Cr2O7)^2- = Cr(OH)3 . Please Write step by step

A: The hald redox reaction is

Q: The ideal gas law would work for which if the following? a. A fluid with Z = 0.7 b. Hydrogen...

A: An ideal gas follow the ideal gas law, which is given by PV=nRT, where P, V, and n are the pressure,...

Q: 4. What is the amount of 2 M HCl(ag) that is used to neutralize 40 ml of 4 M NaOHag)? (Show set-up a...

Q: Galvanized nails are iron nails that have been plated with zinc to prevent rusting. The relevant rea...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What are the assumptions necessary to be made in order to determine the molecular weight of a volatile substance using the Dumas method?
How will the calculated molarity of the solution be affected if solid particles splatter out of the flask during the drying process? Explain. How will the calculated molarity be affected if the solute residue is not dried thoroughly? Explain.
Why is important to allow the saturated solution to cool down slowly during the recrystallization?
For the reaction determine A) Why the reaction is performed with a distillation setup instead of a reflux. B) What conditions could affect the reaction to cause less than a 100% yeild. C) If magnesium sulfate is used as a reagent, what would the melting point indicates about the product if not enough of the magnesium sulfate is used?
show your work for the determination of the Ksp of sodium chloride for your sample
Isopropanol and water are miscible, meaning they can be combined in any ratio. So why were they immiscible in this experiment? In other words, why does the presence of sodium chloride reduce the solubility?
During heating, some solution of NaCl splattered out of the evaporating dish. How would this affect the calculated percentage of mixture recovered upon separation?
Why is it not necessary to dry the Erlenmeyer flask between each trial?
What is the effect of weighing a recrystallized organic solid which is not completely dried to the percentage yield? Elaborate.
In order to obtain accurate data it is important to add hear slowly and steadily when the temperature gets close to the melting point of a sample. Why is necessary?
If you did not completely dry the Erlenmeyer flask before weighing the result, how would that affect the final results? Be specific in your answer.
Imagine your original mixture had contained a component capable of sublimation, such as naphthalene. When would be best time to remove this volatile component so the other procedural steps would still work: before step (1), after (1), after (2), or after (3)? Why? How could the volatile component then be collected as a solid?