Answered: 10- A certain logic gate has a VoLmax)…

10- A certain logic gate has a VoLmax) = 0.45 V, and it is driving a gate with a VIL(max) = 0.75 V. Are these gates compatible for LOW-state operation? Why?

Modern Physics

3rd Edition

ISBN:9781111794378

Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Publisher:Raymond A. Serway, Clement J. Moses, Curt A. Moyer

Chapter12: The Solid State

Section: Chapter Questions

Problem 2Q

See similar textbooks

Related questions

Q: Driven by ac power, the same electrons pass back andforth through your reading lamp over and over…

A: To determine: Why light stays lit instead of going out after the same electrons are passed back and…

Q: 3- TTL SSI comes mostly in 14 - pin packages. Two pins are reserved for power supply and the other…

A: Solution: to find the number of gates in different packages

Q: A 100 W lightbulb is brighter than a 60 W lightbulb when both operate at the same voltage of 120 V.…

Q: Halogen bulbs have some differences from standard incandescent lightbulbs. They are generally…

Q: Give the important properties of series connections of resistors

A: In a series connection of resistors, the various resistors are connected end to end. The equivalent…

Q: 7. What does a diode do in a circuit?

A: 7. Diode do in a circuit

Q: Halogen bulbs have some differences from standard incandescent lightbulbs. They are generally…

A: The rating of bulb 12 V, 50 W. The lamp is plugged into 120 V, 60 Hz.

Q: Halogen bulbs have some differences from standard incandescent lightbulbs. They are generally…

A: Given: The rating of bulb is 12 V, 50 W. The input voltage is 120 V, 60 Hz.

Q: - If we use 5000 uF, we can get a very low ripple voltage. But this is so bad and this a…

A: Ripple voltage means the amount of AC voltage that appears on a DC voltage. The main reason for the…

Q: 3. Use Kirchoff's Laws for solving this Series-Parallel Circuit 20 20 20 10 V 20 20 20 2 0 20…

Q: 3. In Fig. 3, the resistances are R1 = 20.0 W and R2 = 40.0 W, and the ideal batteries have emfs…

Q: The total power in a certain circuit is 1 W. Each of the five equal-value series resistors making up…

A: Given that Five equal value resistor are connected in series by a battery of emf V (let say) as…

Q: 2. Consider an electric circuit shown in Figure 2. 30 4Ω 62 ww- 82 Figure 2 a. If the current…

Q: 12. What is the power output of a flashlight if 5.90×102 C pass through it in 0.550 h and its…

A: The expression for the Power output (P) of a flashlight is given as, P = V×I, where V is the voltage…

Q: A number of light bulbs are to be connected to a battery. Which will provide more overall…

Q: _1. Both AC and Dc described the flow of current in a circuit. 2. Electric charges in both AC and DC…

A: Electric current flows in two ways as an alternating current (AC) or direct current (DC). In…

Q: 1. Use the Conventional way of solving Parallel-Series Circuit 4.092 1502. 9.002. 18.02. 30 2.…

Q: 12- For the electric circuit shown in the figure (E12), determine the value of (R) if the current…

Q: An rms voltage of 120 V produces a maximum current of 4.1 A ina certain resistor. Find the…

A: The expression for find resistance of resistor is R=VI

Q: The output of a 2-input AND gate is fed to a NOT gate. Give the name of the combination and its…

Q: A 1.6-μF capacitor is connected in series with a 15.0-kΩ resistor. It is charged by a 5.0 V battery.…

A: Given value--- capacitance = 16 micro F resistance = 15 k ohm. We have to find--- time constant?

Q: - Series Circuits 6. In the circuit shown below, voltmeter V, reads 80. volts. 80. V (V, (V2) 40. 2…

Q: Which logic gate does the following truth table represent? A Out put 1 1 1 1 1 A AND B NAND с ХOR D…

A: The output column is the complement of OR gate operation. Therefore it must be NOR gate.

Q: 44. In FET, .......control the resistance of the channel. O a. Base. O b. Gate. O c. Source. d.…

A: FET is a device in which the output current is controlled by the applied electric field. It has high…

Q: What happens to an electron when voltage is zero and why??

Q: 9. You are about to take a picture of a bullet traveling at 250 m/s, then a very brief flash of…

A: A quick shutter speed is used to limit the exposure and limit blurring but when you are taking about…

Q: س5 تسقط قذيفة كتلتها m = 15g من وضع السكون من على ارتفاع h = I8 m من مستوي الأرض، 1- ما مقدار الطاقة…

A: الطاقة الحركية = الطاقة الكامنة الأولية = 0.015 × 9.8 × 18 = 2.646 جولالسرعة النهائية = (2 × 9.8 ×…

Q: A transformer for a transistor radio reduces 120 V ac to 9.0 V ac. The secondary contains 30 turns…

A: Given value--- Primary voltage = 120 V. secondary voltage = 9 V. No. of turns in secondary coil =…

Q: 5- The rms value of the current in an alternating current circuit is given as 10/2 A. Accordingly,…

A: Given that, RMS value of the current =

Q: 2. Suppose the voltage V (in volts) is a function of time t (in seconds) given by V = 30e-t/5…

A: Note: As per Bartleby guidelines only 3 subparts have to be solved at the time. So upload other…

Q: Q4. Determine the value of collector current and collector-to- emitter voltage for the voltage…

A: Using voltage divider rule, we need to find current flowing through emitter.

Q: 10. Observe the given Junction and then find the value of i. 8A 4A 8A 4F

A: As per guidelines only first question is solved here. Here first question is question no. 10 to find…

Q: 3- Why does the resistivity of superconductors become zero?

A: given statement - " why the resistivity of superconductors become zero" ?

Q: - Normally every conductor has a resistance. ................... are conductors where the resistance…

A: Resistance is the measure of opposition to current flow in a circuit.

Q: 2 * 4.8029 * 10-10esu 2.9979 * 1010c m/s ec q = 3.2043 * 10-20emu

A: The electrostatic system of units is a system of units used to measure quantities of charge, current…

Q: A single slide wire is used for the measurement of current in a circuit. The voltage drop across a…

Q: 12. Give two examples of electrical devices that are based on transistors.

Q: . You run your 1500 W microwave in your dorm room for 5.0 minutes to heat your TV dinner. What…

Q: Given the circuit diagram below and assuming that the emf (ε=12V) Find: (a) the total resistance…

A: Given data :- emf E = VT = 12 V R1 = 4 ohm R2 = 3 ohm R3 = 6 ohm

Q: 23. In operational amplifier (op-amp) circuit, no current flows into the input pins of the ideal…

A: We are asked to give the reason of why there is no input current in an ideal op amp

Q: A 67-0 loudspeaker, a 6.5-Q loudspeaker, anda 2.9-Q loudspeaker are connected in parallel across the…

A: Given data: Three loudspeakers are connected in parallel R1 = 67 Ω, R2 = 6.5 Ω R3 = 2.9 Ω…

Q: A three input NOR gate gives a logic high output only when A. One input is high B. One input…

A: Let the three inputs of a NOR gate are : A , B and C The output of NOR gate = high = 1 (in binary…

Q: can this be rewritten in a legible way so i can understand how you got 335m

A: Index of refraction,n=1.79 Velocity of light,c=3×10⁸ m/s Time travelled by light,t=2×10^-⁶ s

Q: The PLA device is the programmable array of AND gates feeding a fixed array of OR gates. Select one:…

A: PLA ( programmable logic array ) has programmable connection for both AND and OR gates . so this…

Concept explainers

Microscopic view of current

In physics, the term current is expressed as the rate of flow of electric charges across the area per unit time (I=q/t). It propagates along in the direction of the motion of positive charges. When the current is caused by the motion of electrons, the direction of the current is opposite to the flow.

Question

nese gates Compatible 1Or
state operatioOn? why
10- A certain logic gate has a VOLmax) = 0.45 V, and it is driving a gate with a VIL(max) = 0.75 V.
Are these gates compatible for LOW-state operation? Why?
11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What semiconductor is frequently used for its high reliability at high speed? Explain why.
Let's say you have a 20 cm long silicon wire, with a diameter of 4 cm. What current flows through this wire if a 1000 V potential difference is applied to the two ends? Please enter your answer in the unit of mA. You can use 2300 Ohm.m for the resistivity of silicon.
A silicon crystal having a cross-sectional area of 0.001cm? and a length of 10°cm is connected at it s ends with 10v battery at temperature 300°K, when the current is 100mA. Find the resistivity and the conductivity?
The Type K thermocouple has a sensitivity of about 41 micro-Volts/℃, i.e. for each degree difference in the junction temperature, the output changes by 41 micro-Volts. If you have a 32-bit ADC, what is the smallest temperature change you can detect if the ADC range is 10 V? Try leaving the answer as a decimal with significant digits: e.g., 0.00004100.
How does the resistance of: i) a semiconductor ii) an alloy vary with temperature?
A zener diode is specified as having a brealdown voltage 9.1V, with a maximum power of 364mW. What is the maximum current the diode can handle?
Using the mathematical expression for the conductivity of a material, explain how it varies with temperature for (i) semiconductors, (ii) good conductors.
The relaxation time τ is nearly independent of applied E field whereas it changes significantly with temperature T. First fact is responsible for Ohm’s law whereas the second fact leads to a variation of ρ with temperature. Elaborate why?
A particular electronic-code lock provides over 500 billion combinations. Moreover, it can sustain an electric shock of 168286 V. Suppose this potential difference is applied across a series connection of the following resistors: 14.2 kΩ, 33.9 kΩ, and 239.3 kΩ. What current would pass through the resistors?
For the silicon transistor in the following figure the Q point is (2v ,1mA) Beta= 100 VBE= 1.3 v Find RB
A new material is found to be superconducting below 77 K. How much resistance will a 75 mm long sample of this material have if it is at a temperature of 69.3 K while connected to a 6.4 V AC-power supply? R = How much thermal energy will it generate?Thermal energy generated =
When two identical resistors(say 4 ohm each)Are connected in parallel to a 12 V car battery,Calculate for both resistors: a.Voltage across each ,b.power dissipated in each,c.current through each? Do any of your answers change if the restistors are different from each other?