12- For the electric circuit shown in the figure (E12), determine the value of (R) if the current trough the branch AB is zero and the total current is 1A. Note that all the values of resistors are in ohm. 1.5 10V Figure (E12) dby

12- For the electric circuit shown in the figure (E12), determine the value of (R) if the current trough the branch AB is zero and the total current is 1A. Note that all the values of resistors are in ohm. 1.5 10V Figure (E12) dby

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.21P: Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0...

See similar textbooks

Related questions

Q: 5. In the circuit below, Ry is a variable resistor. If the R1 resistance of Ry is increased, what…

A: 1. According to the given question, here resistor is connected to the given circuit across different…

Q: 4. Given the following circuit, find the power delivered to the 150 Q resistor.

Q: 13- chapter28-question17 Four 20-0 resistors are connected in series and the combination is…

Q: 11. Which of the following characteristics are true about a series circuit? 1. The current that goes…

Q: 9:49 I A Current Volta... Saved in Drive Notice three things!! 1: The voltage did NOT divide up…

A: It is given that bulbs are in series in the circuit. Since the bulbs are in series, hence, the…

Q: 57.The current flowing through a 12-Ω resistor is 2A. Determine the potential difference across…

A: Current through resistor, I=2A Resistance of the resistor, R=12Ω Let potential difference be V.

Q: . When switch S in the figure is open, the voltmeter V of the battery reads 3.13 V . When the switch…

Q: 15-It has been found that aluminum and copper wires of the same length have the same resistance. Of…

A: we know the resistance is proportional to length and and inversely proportional to cross section of…

Q: Electromotive Force: Terminal Voltage• Compare and contrast the voltage and the electromagnetic…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 4. In the given circuit, the capacitor is initially discharged. How long after the switch is closed…

Q: 3. In a circuit, a variable resistor is to be connected across a potential difference of 60 V to…

Q: 13 - chapter28-question14 Calculate the power (in Watt) delivered to resistor 20 in the circuit…

Q: 5- chapter27-question28 The current in a resistor decreases by 3.00 A when the voltage applied…

A: Given Data : The initial voltage across the resistor is given as V1 = 12V The final voltage across…

Q: Question 34.) A short circuit in a 120 V appliance cord has a 0.35 Ω resistance. 1.) Calculate the…

Q: : Determine the total resistancecRe) and the voltagel Vi) from the circuit of Fig-C4) lost + VI 12n…

A: For series connection, the resistances simply add linearly. Rs=R1+R2+...........Rn For parallel…

Q: Can the terminal voltage of a battery ever exceed its emf?Explain.

A: emf of a cell is the potential difference across its terminal in open circuit. Terminal voltage of a…

Q: 8. The negative terminal will be connected to METER PLUKE 79 SEEE OFF Hz PLESS 4on RANGE on 10A COM…

A: To answer the given question regarding multimeter.

Q: (5)Calculate the current flowing through R1 (6) Find the total current flowing through the circuit (…

A: Given: V = 120 V P1 = 150 W I2 =0.50 A

Q: A typical television dissipates 275 W when it is plugged into a 120 V outlet. a). Find the…

A: Power of television (P) = 275 W Voltage of the outlet = 120 V

Q: 14- Referring to the circuit below, should we connect the float switch as normally open or normally…

Q: 7.) Consider the circuit shown below. A 13 R3 12 Loop 3 Loop 1 R2 Loop 2 :V2 R5 RA 12 в a. ) Write a…

A: a) "According to Kirchhoff's loop rule, the algebraic sum of the potential differences in any loop…

Q: 14. The average power supplied to the circuit shown passes through a maximum when which one of the…

A: In this problem, It is asking about the average power.

Q: 18- chapter28-question19 Calculate the power (in W) dellvered to 4 0 resistor in the circuit shown…

Q: wound onto a cylindrical A certain resistor is made with a 51.6 m length of fine copper wire, 4.54 x…

A: We have to use the formula Resistance(R) = resistivity ×lengthArea of cross section

Q: 1- Transformers a- Explain why does the secondary voltage increase when you increase the primary…

A: Explain why does the secondary voltage when you increases the primary voltage.

Q: R1 Loop 1 А R2 Loop 2 R3 Is this statement true or false about the circuit shown above: Applying…

A: Given , the equation of kirchoff voltage law in the biggest loop , - I3*R3 + I1*R1 =0 And the…

Q: 03/ For the circuit shown in figure (2), by using mesh anal ysis, 1- Find the current through the…

Q: 7. In a portable speaker, only 16A of current pass through a copper wire. If the speaker is operated…

A: Write the given values with the suitable variables. I=16 AV=9 V Here, I and V are the current and…

Q: mine the value that R3 must have so that the light bulbs in the circuit have a potential difference…

A: We know that we have given a figure is as By this figure, we get that Resistance R1 and R2 are…

Q: 4 - In the circuit with the resistors R1, R2, and a DC power source, 20 V is observed from the…

A: We need to calculate the current through the ampermeter.

Q: You obtain a 100-W light bulb and a 50-W light bulb. Instead of connecting them in the normal way,…

Q: 22- For the following circuit, find Vt +. V1 1. V2

Q: 9- A student observed that a lamp connected to RC circuit was on for 2.5 seconds if the capacitance…

A: Given: T = 2.5 seconds; C = 500 uF = 500 x 10-6 F; R = 100 ohms.

Q: 77. If electric power is transmitted over long distances, the resistance of the wires becomes…

A: We will only answer the first question since the exact question to be answered was not specified.…

Q: 16- What is the value of the ampermeter in the given circuit? NOTE: The internal resistances of the…

Q: Ohm’s Law: Resistance and Simple Circuits• Explain the origin of Ohm’s law.• Calculate voltages,…

A: The physicist Georg Simon Ohm (1787-1854) demonstrated an experiment in the year 1827. In the…

Q: 17. When making an ECG measurement, it is important to measure voltage variations over small time…

A: The discharging of the capacitor is governed by V=V0e-tRC *Here V0 is the voltage across the…

Q: 20 - What is the potential difference between points L and M in the circuit in the figure? Note: The…

Q: Digital meters are able to detect smaller currents than analog meters employing galvanometers. How…

A: Digital meters are able to detect smaller currents than analog meters.

Q: 7. When the switch shown in Fig. 19–45 is closed, what will happen to the voltage across resistor…

A: When the switch is open, the current does not flow through the resistor R2. The current flows only…

Q: 56. What is the maximum voltage that can be applied to a 10-k 2 resistor rated at W

A: Solution: Given that R = 10000 ohm P = 0.25 W By the Power formula we know that: Power (P) = V2 /…

Q: 5-Two resistors of resistances R and 2R are connected in parallel to an ideal battery. If the Power…

A: Power dissipated in a resistor in terms of voltage is given by the relation P…

Q: 36. To protect an expensive circuit component from being delivered too much power, you decide to…

A: Given:To protect an expensive circuit component from being delivered too much power,Now,The minimum…

Q: 3. What happens when you only touch one probe to the resistor / resistive component?

A: ****NOTE : Provide the theoretical data or information or instruction provided along with the…

Q: 7. Most household circuits in North America use 120 V, wh in Europe 240 V is most commonly used.…

A: When Edison invented bulb, he used 3 lines +110 v, 0v, -110v. He used dc voltage than ac voltage as…

Q: 24. The polarity of a resistor's voltage drop is determined by a) the direction of the current…

A: Let a current flowing through a resistor = I Let the voltage drop across the resistor = V Let the…

Q: 8) In the circuit shown in the figure, all the lightbulbs are identical, and attached to a voltage…

Q: The severity of a shock depends on the magnitude of the current through your body. Would you prefer…

A: It would be preferable to be in series with the resistance.

Question

Figure (E11)
For the electric circuit shown in the figure (E12), determine the value
of (R) if the current trough the branch AB is zero and the total current is 1A.
12-
unar
Note that all the values of resistors are in ohm.
1.5
R
10V
d by
Figure (E12)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Consider the circuit shown in the preceding problem. Write equations for the power supplied by the voltage sources and the power dissipated by the resistors in terms
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell (nicads), although it has a 1.25-V emf, whereas an alkaline cell has a 1.58-V emf. The radio has a 3.20 resistance.(a) Draw a circuit diagram of the radio and its battery. Now, calculate the power delivered to the radio (b) when using a nicad cells, each having an internal resistance of 0.0400 , and (c) when using an alkaline cell, having an internal resistance of 0.200 . (d) Does this differenceseem significant, considering that the radio's effective resistance is lowered when its volume is aimed up?
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
In the circuit shown in Figure OQ21.15, each battery is delivering energy to the circuit by electrical transmission. All the resistors have equal resistance. (i) Rank the electric potentials at points a, b, c, d, and e from highest to lowest, noting any cases of equality in the ranking. (ii) Rank the magnitudes of the currents at the same points from greatest to least, noting any cases of equality.
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
Integrated Concepts Use the ECG in Figure 20.34 to determine the heart rate in beats per minute assuming a constant time between beats. Figure 20.34 A lead II ECG with corresponding arterial blood pressure. The QRS complex is created by the depolarization and contraction of the ventricles and is followed shortly by the maximum or systolic blood pressure. See text for further description.
(a) Explain how the mnemonic ELI the ICE man can be used to recall whether current leads voltage or voltage leads current in RLC circuits. Note that E represents emf . (b) Explain how CIVIL works as another mnemonic device, where V represents voltage.
Apply the junction rule to junction b in Figure 21.47. Is any new information gained by applying the junction rule at e? (In the figure, each emt is represented by script E.)
Integrated Concepts If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600F capacitor, what is the resistance in the flash tube?